The vulnerability of the French Riviera to hydro meteorological hazards has been dramatically illustrated by the flash floods of October 3, 2015: 20 people were killed and the cost of the direct damages were higher than 600 million euros. Due to their fast dynamics, flash floods are difficult to predict and leave little time for forecasting. In this context, it is needed to improve real-time simulations to enable a short-range anticipation of the consequences of these phenomena. The main goal of this work was to test a hydrologic-hydraulic coupling in order to assess whether this coupling can be used for real-time forecasting purposes. The coupling is composed for the hydrological part of the event-based spatially distributed rainfall-runoff model Cinecar and for the hydraulic part of the Basilisk software, which is based on 2D hydraulic modelling (finite volume methods for shallow water equations) with adaptive grid refinement. The main interest of this coupling method is the compromise obtained between calculation time and precision. The rainfall-runoff model is run on the upstream part of the domain and feeds the hydraulic model applied in the downstream part. The rainfall-runoff model makes it possible to estimate very quickly the streamflow temporal evolution, while the hydraulic model, although much slower when applied at high spatial resolution (up to 4m), makes it possible to have water level and velocity at any point of the downstream area. The application of this coupling approach is presented for three basins severely affected by the October 2015 flash floods: the Brague (68 km²), the Frayère (22 km²) and the Riou de l’Argentière (48 km²) catchments. The results obtained for the three basins are compared with information gathered from post-event surveys, particularly the high water level marks. A particular attention is also put on computation times in order to evaluate the possibilities of real-time simulation. The results show promising performances both in terms of calculation time but also in terms of accuracy of the simulated flood areas and water levels.
L’objectif de ce travail est le développement d’un modèle et d’une méthode numérique adaptés à la simulation du ruissellement d’eau de pluie sur des surfaces agricoles. Pour cela, nous utilisons un système d’équations aux dérivées partielles pour les eaux peu profondes : le système de Saint Venant. La pluie et l’infiltration y sont pris en compte par l’ajout de termes source et le couplage avec un modèle d’infiltration. Le système étant hyperbolique et conservatif nous choisissons d’utiliser un schéma aux volumes finis avec reconstruction hydrostatique. Avec cette reconstruction nous obtenons un schéma permettant de traiter les équilibres stationnaires et les interfaces sec/mouillé dues aux événements pluvieux. Tout d’abord, nous effectuons une comparaison systématique de différents flux numériques, de différentes reconstructions d’ordre deux (MUSCL et ENO modifiées) et de différentes méthodes de traitement des frottements sur des solutions analytiques unidimensionnelles. Ces comparaisons nous permettent de choisir une méthode numérique adaptée à la simulation du ruissellement qui en outre capture les phénomènes de typeroll-waves. Ensuite nous nous intéressons au traitement de la pluie et de l’infiltration à l’aide du modèle de Green-Ampt. Cette méthode généralisée en dimension deux est validée sur des résultats expérimentaux obtenus à l’INRA d’Orléans et à l’IRD. La méthode numérique choisie et validée a été implémentée dans FullSWOF_2D un logiciel libre écrit en C++ pour la simulation de ruissellement d’eau de pluie sur des surfaces agricoles.