23 October 2024 in IEEE Transactions on Instrumentation and Measurement
Precise geomagnetic azimuth measurement is essential for automation and intelligent operations in deep-earth and deep-sea resource exploration. However, during drilling, the main sources of azimuth error include the inherent distortion of triaxial accelerometer and triaxial magnetometer, which require prior calibration. To address this issue, we focus on static azimuth measurements by analyzing the error propagation relationship, developing a comprehensive error correction model, and proposing a correction method that combines piecewise polynomial fitting and improved interpolation. Finally, the proposed algorithm was experimentally validated using a high-precision inclinometer calibration platform. The experiment compared the error correction effects of the three-step combination method and the proposed method. At a confidence level of p =0.95 and an axial tilt of I =0.594, dA decreased from (3.1° ± 0.9°) to (1.8° ± 0.5°) and (7*10 -4 ° ± 3.7*10 -2 °) for the traditional and proposed method, respectively. The proposed method demonstrates good performance in azimuth reconstruction and meets the practical engineering demands of azimuth calibration in measurement-while-drilling system.
15 July 2021 in IEEE Access
Detecting and localizing the inner damage of the downhole casing is crucial for oil and gas production. The current methods for damage detection suffer from polarization effect, capacitance effect, and difficulty in measuring weak direct current signals. As an alternative, we propose a new instrument design based on a six-electrode array in this study. The basic detection principle is introduced, and the key factors that affect the detection performance are studied through modeling and simulation. Besides, the entire system of the instrument design consisting of several modules is presented. In addition, an experiment is conducted to demonstrate the detection capability of the proposed design. It is found that the detection dynamic of the instrument is 93 dB and a signal-to-noise ratio is 73 dB. It can detect damage when salinity is lower than 120 g/l and can identify the location of damage with high resolution in the longitudinal and radial directions.