The distributions of major and minor elements in Earth’s core and mantle were primarily established by high pressure, high temperature metal–silicate partitioning during core segregation. The partitioning behaviors of moderately siderophile elements can be used to constrain the pressure–temperature conditions of core formation and the core’s composition. We performed experiments to study the partitioning of Ni, Co, V, Cr, Si, and O between silicate melt and Fe-rich metallic melt in a multianvil press and diamond anvil cell, up to 100GPa and 5700K. Combining our new results with data from 18 previous studies, we parameterized the effects of pressure, temperature, and metallic melt composition on partitioning. Ni and Co partitioning are insensitive to composition. At low pressures, these elements become less siderophile with increasing temperature, with this trend reversing above ∼45GPa. V and Cr partitioning are much more sensitive to metallic melt composition and less sensitive to pressure. Partitioning of Si and O are insensitive to pressure, but with strong and moderate temperature dependences, respectively. Our new parameterizations of Ni and Co partitioning suggest that the Earth’s distributions of these elements can be matched by single-stage core–mantle equilibration at 54±5GPa and 3300–3400K. These conditions would result in 8.5±1.4wt% Si and 1.6±0.3wt% O in the core, compatible with the core’s measured density. However, this single-stage model matches the Earth’s V and Cr distributions less well. We also incorporated our parameterizations into models of multi-stage core formation over evolving pressure–temperature-oxygen fugacity conditions, reproducing the Earth’s Ni and Co distributions while simultaneously producing a core whose light element composition is consistent with its density
The volume change of solid phases associated with dissolution and precipitation reactions during mineral replacement is a critical factor for the advancement of the reaction boundary. Contributing parameters to the overall volume change of a replacement reaction are the molar volume of parent and product and their solubility ratio within a given solution. Based on simple model salt systems, the contribution of solubility to volume change is quantitatively determined. For NaCl-KCl as an example of a binary salt system without solid solution, the relative volume changes can be calculated for various reaction paths using the slope of the solubility from a simple solubility diagram. For KBr-KCl as an example of a binary salt system with complete solid solution, the determination of the solubility curve is based on a modified Lippmann phase diagram called a solubility phase diagram. It allows a quantitative calculation of the relative volume change based on the solid solution-aqueous solution (SS-AS) relationships for variable solution compositions and reaction paths in the salt-water system. Reaction kinetics, textures and the compositional evolution of replacements in both salt systems can be conclusively explained by the relative volume change on the basis of experimentally constrained reaction paths. The analogy from simple model system to replacement reactions at the Earth's surface and crustal conditions (for example in apatites or feldspars) may offer insights to successfully describe volume changes and porosity generation in mineral reactions on the basis of solubility data towards a more quantitative modeling of interface-coupled dissolution-precipitation reactions.