Sb-doped ZnO films were fabricated on c-plane sapphire using the pulsed laser deposition method and characterized by Hall effect measurement, X-ray photoelectron spectroscopy, X-ray diffraction, photoluminescence, and positron annihilation spectroscopy. Systematic studies on the growth conditions with different Sb composition, oxygen pressure, and post-growth annealing were conducted. If the Sb doping concentration is lower than the threshold ∼8 × 1020 cm−3, the as-grown films grown with an appropriate oxygen pressure could be n∼4 × 1020 cm−3. The shallow donor was attributed to the SbZn related defect. Annealing these samples led to the formation of the SbZn-2VZn shallow acceptor which subsequently compensated for the free carrier. For samples with Sb concentration exceeding the threshold, the yielded as-grown samples were highly resistive. X-ray diffraction results showed that the Sb dopant occupied the O site rather than the Zn site as the Sb doping exceeded the threshold, whereas the SbO related deep acceptor was responsible for the high resistivity of the samples.
Systematic magnetic, electronic, and electrical studies on the Cu0.04Zn0.96O/Ga0.01Zn0.99O cell structure grown on (001) sapphire by the pulsed laser deposition technique show that the Cu multivalent (CuM+) ions modulate magnetic and resistive states of the cells. The magnetic moment is found to be reduced by ∼30% during the high resistance state (HRS) to low resistance state (LRS) switching. X-ray photoelectron spectroscopy results reveals an increase of the Cu+/Cu2+ oxidation state ratio (which has been determined by the relative positions of the Fermi level and the Cu acceptor level) during the HRS to LRS transition. This decreases the effective spin-polarized Cu2+–Vö–Cu+ channels and thus the magnetic moment. A conduction mechanism involving the formation of conductive filaments from the coupling of the CuM+ ions and Vö has been suggested.
Junction barrier Schottky diode fabrication involves multi-folded Al ion implantation for realizing p-type doping. With a new fabrication recipe, we demonstrate that the trade-off between sufficiently high Al acceptor activation and sufficiently low residual concentration of carbon vacancies - acting as free carrier traps - may be resolved applying relatively low temperature anneals (1700°C), followed by the thermal oxidation which leads to in-diffusion of the carbon interstitials from the C-rich sacrifice-oxide/SiC interface. Specifically, we detected two major interconnected factors: suppression of the carbon vacancies and dramatic reduction of the reverse leakage current (by 32 times at -1200 V). The reduction of the reverse biased current is correlated with the removal of the carbon vacancies, interconnected with the Poole-Frenkel emission contribution to the leakage current.
21 March 2019 in Journal of Materials Science: Materials in Electronics