Herein, the systematic change in the self-polarization behavior against the post-heat treatment after film deposition was investigated to understand the origin of self-polarization in hydrothermally prepared (K x Na
1−
x )NbO 3 films with x = 0.88 at 240 °C below the Curie temperature. The transverse piezoelectric constant, e
31
,f , was evaluated by the cantilever method. The as-prepared films and heat-treated films at 300 °C had an almost perfectly self-polarized state and showed e
31
,f of ∼−5.0 C m −2 without applying an electric field as a poling treatment. Also, the piezoelectric response shows good linearity with the asymmetric piezoelectric butterfly curves, showing imprint characteristics. The self-polarized states were maintained until the heat treatment above the Curie temperature. Moreover, the self-polarized film was successfully deposited on the post-heat-treated film without the self-polarized state. This result suggests that the self-polarized state is generated regardless of the polarized state of the underlying layer by the hydrothermal synthesis in which deposition temperature is below the Curie temperature.
We prepared a stacked structure consisting of a quasi-free-standing functional oxide thin film and a ceramic piezoelectric disk and observed the effect of the piezoelectric disk deformation on the resistance of the thin film. Epitaxial V2O3 films were grown by a pulsed laser deposition method on muscovite mica substrates, peeled off using Scotch tapes, and transferred onto piezoelectric elements. In this V2O3/insulator/top electrode/piezoelectronic disk/bottom electrode structure, the resistance of the V2O3 film displayed a variation of 60% by sweeping the piezoelectronic disk bias. With support from x-ray diffraction measurements under an electric field, a huge gauge factor of 3 × 103 in the V2O3 film was inferred. The sizeable resistance change in the V2O3 layer is ascribed to the piezo-actuated evolution of c/a ratios, which drives the material towards an insulating phase. A memory effect on the resistance, related to the hysteretic displacement of the piezoelectric material, is also presented.
A hydrothermal method was used to epitaxially grow 70-nm-thick tetragonal (Bi,K)TiO3 films with stoichiometric compositions at 240 °C on (001)cSrRuO3//(001)SrTiO3 substrates. Crystal structure analysis revealed that the obtained (Bi,K)TiO3 films had a polar-axis orientation attributable to the matching of the in-plane lattice with the SrRuO3 underlayer. Large coherent displacement of A-site ions along the polar direction observed by transmission electron microscopy may have induced the large tetragonal distortion of c/a = 1.046. The dielectric constant was about 100 and was almost frequency independent in the range of 103–105 Hz, while the dielectric loss, tan δ, was below 5%. Well-saturated ferroelectric polarization−electric field (P−E) hysteresis loops were observed, and the remanent polarization (Pr) was 84 μC/cm2. In addition, the effective piezoelectric constant, d33,eff., was estimated to be 85 pm/V by time-resolved x-ray diffraction measured under an applied electric field. The Pr and d33,eff. values were larger than those reported for polar-axis-oriented epitaxial tetragonal Pb(Zr0.35Ti0.65)O3 films, indicating that the polar-axis-oriented tetragonal (Bi,K)TiO3 film has high potential as a lead-free material for various applications. Specifically, the small εr and large d33,eff. led to an improvement in the figures of merit [d33,eff./εr and (d33,eff.)2/εr], the most important index in sensor and energy-harvester applications.
13 August 2020 in Japanese Journal of Applied Physics
(K x Na
1−
x )NbO 3 films that were approximately 3 μ m in thickness and with various x values were systematically deposited at 240 °C on (100) c SrRuO 3 //(100)SrTiO 3 substrates using a hydrothermal method. Direct and inverse transverse piezoelectric coefficients, e31,f , near 0 kV cm −1 were approximately −5.0 C m −2 for the as-deposited films with a wide range of x values without any poling treatment. A large difference in e31,f value was not observed before or after poling treatment upon applying a positive electric field, suggesting that the as-deposited (K x Na
1−
x )NbO 3 films with x = 0.36–0.88 were almost fully in a self-polarized state. (K x Na
1−
x )NbO 3 films with x = 0.36–0.88 without any poling treatment showed a figure of merit for an energy harvester (FOM = e31,f2 / εr ) above 0.13, as calculated directly from e31,f . These FOM values are relatively high compared with the reported ones for other lead-free films that have a perovskite structure.
14 January 2022 in Physica Status Solidi (RRL) – Rapid Research Letters