This paper presents an experimental study of the variation in the performance of silicon solar cells with temperature. The cells studied were fabricated from standard electronic grade and upgraded metallurgical grade silicon. Both monocrystalline and multicrystalline silicon wafers are included. The main object is to evaluate critical cell parameters for cell performance against temperature. The critical parameters selected are the wafer type, wafer resistivity, fabrication process routing, and solar cell electrical parameters. Their impact on cell performance is evaluated by systematic study expressed in terms of temperature coefficients. The resulting quantitative study finds different cell performance sensitivities to specific parameters: the crystal growth, the use of electronic grade or upgraded metallurgical grade silicon wafers, and the fabrication process employed. It is shown that the temperature coefficient of the short circuit current is an important factor in the tendency of the temperature coefficient of the maximum power. This phenomenon is responsible for the superior temperature coefficient observed in solar cells fabricated from upgraded metallurgical grade silicon wafers. Furthermore, the study quantitatively demonstrates the sensitivity of cell temperature coefficient to fabrication process. The optimum process for a superior temperature coefficient is identified, and also corresponds to an improved overall efficiency
A polarization insensitive technique for highly efficient coupling between SOI waveguides and high mode field diameter single-mode fibers is reported. The proposed coupling structure is based on an inverted taper structure coupled to a fiber-adapted waveguide. The fiber-adapted waveguide is made by using the SiO2 layer under the Si waveguiding layer of the SOI wafer thus avoiding the use of extra materials such as polymers. The proposed coupling structure is aimed for being integrated with V-groove auto-alignment techniques. Coupling losses of 3.5dB and 3.7dB to 8μm mode field diameter single-mode fibers have been estimated by means of 3D-BPM simulations for TE and TM polarizations respectively and a 1550nm input signal wavelength.
1 January 2015 in Solar Energy Materials and Solar Cells
A planar photonic crystal that allows inherently gap-guided single-mode waveguides is proposed and discussed. This novel structure consists of a two-dimensional lattice of silicon rods embedded on a thin silica slab sandwiched between two silica claddings whose refractive indices are slightly lower than the index of the silica core. The physical parameters of the structure, i.e., rod radius and core thickness, are optimized to maximize the bandgap width for odd modes. Lossless guided modes inside the bandgap and below the claddings’ light cone are obtained by reducing the radius of a row of rods. The waveguide bandwidth can be increased by inserting a thin silicon dielectric waveguide instead of the row of rods. The proposed approach may overcome many of the common drawbacks in conventional holes-on-dielectric planar photonic crystal waveguides.
Black silicon is relevant for the photovoltaic industry when searching for low-reflectance, low-defect front surface, which is the goal of this work. We have fabricated samples using reactive ion etching (RIE) plus chemical etching for the smoothing, characterized them, and built modeling tools capable of reproducing the resulting geometric features, based on the process parameters. Reflectance is simulated using a proprietary rigorous coupled wave analysis (RCWA)-based tool, and compared with the experimental results. A good matching was achieved using a simple unit cell, and a better agreement when using a 0.5 square microns sample. Finally, an optimum trade-off between low reflectance and low thickness has been achieved.