23 October 2017 in Applied Physics Letters
We have fabricated GaN-based light-emitting diodes (LEDs) with different quantum well (QW) thicknesses to investigate the influence of the quantum confined Stark effect (QCSE) and carrier localization effect on the carrier recombination processes under both direct current (DC) and alternating current (AC) biases. At low current density, QCSE dominates the carrier recombination and decreases the radiative recombination rate. With increasing the current density, QCSE will be screened by injected carriers, and both optical power and modulation bandwidth can be increased. When the polarization field is completely compensated, the carrier localization effect starts to dominate. By reducing the influence of the QCSE and carrier localization effect, a high modulation bandwidth of ∼700 MHz was achieved at a low current density of 425 A/cm2 for the LED with 5 nm QW. Our findings will pave an alternative solution for co-optimization of the modulation bandwidth and efficiency for LEDs at a relatively low current density for visible light communications.
1 February 2018 in ACS Applied Materials & Interfaces
17 September 2021 in Optics Letters
A four-channel coarse wavelength division multiplexing (CWDM) (de)multiplexer on a thin film lithium niobate–silicon rich nitride hybrid platform has been designed, fabricated, and experimentally measured. Enabled by cascaded multimode waveguide Bragg gratings, the (de)multiplexer has a box-like spectral response, wide 1-dB bandwidth (10 nm), low excess loss ( ), and low channel cross talk ( ). The central wavelengths of the (de-)multiplexer are 1531/1551/1571/1591 nm, which align to the wavelength grids stipulated by the standard ITU-T G.694.2.
18 January 2016 in Scientific Reports
In this work, a new strategy for achieving efficient p-type doping in high bandgap nitride semiconductors to overcome the fundamental issue of high activation energy has been proposed and investigated theoretically and demonstrated experimentally. Specifically, in an AlxGa1−xN/GaN superlattice structure, by modulation doping of Mg in the AlxGa1−xN barriers, high concentration of holes are generated throughout the material. A hole concentration as high as 1.1 × 1018 cm−3 has been achieved, which is about one order of magnitude higher than that typically achievable by direct doping GaN. Results from first-principle calculations indicate that the coupling and hybridization between Mg 2p impurity and the host N 2p orbitals are main reasons for the generation of resonant states in the GaN wells, which further results in the high hole concentration. We expect this approach to be equally applicable for other high bandgap materials where efficient p-type doing is difficult. Furthermore, a two-carrier-species Hall-effect model is proposed to delineate and discriminate the characteristics of the bulk and 2D hole, which usually coexist in superlattice-like doping systems. The model reported here can also be used to explain the abnormal freeze-in effect observed in many previous reports.
1 December 2018 in Applied Surface Science
15 March 2021 in IEEE Photonics Journal
In this paper, we present a novel transmission line architecture in thin-film lithium niobate (TFLN) platforms to improve the velocity match between the microwave and the optical wave. Compared to conventional coplanar waveguide (CPW), the microwave index ( $n_m$ ) of the proposed slotted electrodes can be optimized from 2.1 to 3 while maintaining the high modulation efficiency and 50- $\Omega$ impedance match. Equivalent-circuit model analysis and finite-element simulation are performed. The simulated half-wave voltage (V $_\pi$ ) of 1.2 V and E-O modulation bandwidth greater than 80 GHz is obtained for a 2-cm-long modulator. By utilizing the slotted slow-wave electrode, TFLN Mach-Zehnder modulators with CMOS-compatible operating voltage and 3-dB modulation bandwidth greater than 100 GHz are potentialized.