The delafossite structured CuCrO2 system is well known as p-type transparent conducting oxide. We have synthesized a Cu deficient form at low process temperature maintaining its good conductive properties.
Epitaxial -type transparent conducting oxide (TCO) was grown by electron-beam evaporation in a molecular beam epitaxy system on -plane sapphire. The influence of Mg dopants and the oxygen partial pressure were investigated by thermoelectric and electrical measurements. The conduction mechanism is analyzed using the small-polaron hopping model, and hopping activation energies have been determined, which vary with doping concentration in the range of 210–300 ± 5 meV. Films with better conductivity were obtained by postannealing. The effect of postannealing is discussed in terms of a crystallographic reordering of the Mg dopant. The highest Seebeck mobilities obtained from thermoelectric measurements are of the order of . We investigate the fundamental properties of a Mg dopant in a high crystalline quality epitaxial film of a binary oxide, helping us understand the role of short range crystallographic order in a -type TCO in detail.
In this letter, we demonstrate a low temperature (≈345 °C) growth method for Cu deficient CuCrO2 performed by spray pyrolysis using metal-organic precursors and a simple air blast nozzle. Smooth films were grown on glass substrates with a highest conductivity of 12 S/cm. The most conductive samples retain transparencies above 55% resulting in a figure of merit as high as 350 μS, which is the best performing p-type transparent conducting material grown by solution methods to date. Remarkably, despite the nano-crystallinity of the films, properties comparable with crystalline CuCrO2 are observed. No postannealing of the films is required in contrast to previous reports on crystalline material. The low processing temperature of this method means that the material can be deposited on flexible substrates. As this is a solution based technique, it is more attractive to industry as physical vapour deposition methods are slow and costly in comparison.
The current best performing p-type transparent conducting oxides are typically highly crystalline materials, deposited at high temperatures, and hence incompatible with the drive to low cost flexible electronics. We investigated a nanocrystalline, copper deficient CuxCrO2, deposited at low temperatures upon a flexible polyimide substrate. The as-deposited film without post annealing has an electrical conductivity of 6Scm−1. We demonstrate that this p-type transparent oxide retains its excellent electrical conductivity under tensile strain, withstanding more than one thousand bending cycles without visible cracks or degradation in electrical properties. In contrast, compressive strain is shown to lead to an immediate reduction in conductivity which we attribute to a de-lamination of the thin film from the substrate.