6 May 2013 in Proceedings of the National Academy of Sciences
Tailoring the hydrodynamic boundary condition is essential for both applied and fundamental aspects of drag reduction. Hydrodynamic friction on superhydrophobic substrates providing gas–liquid interfaces can potentially be optimized by controlling the interface geometry. Therefore, establishing stable and optimal interfaces is crucial but rather challenging. Here we present unique superhydrophobic microfluidic devices that allow the presence of stable and controllable microbubbles at the boundary of microchannels. We experimentally and numerically examine the effect of microbubble geometry on the slippage at high resolution. The effective slip length is obtained for a wide range of protrusion angles, θ , of the microbubbles into the flow, using a microparticle image velocimetry technique. Our numerical results reveal a maximum effective slip length, corresponding to a 23% drag reduction at an optimal θ ≈ 10°. In agreement with the simulation results, our measurements correspond to up to 21% drag reduction when θ is in the range of −2° to 12°. The experimental and numerical results reveal a decrease in slip length with increasing protrusion angles when θ ≳ 10°. Such microfluidic devices with tunable slippage are essential for the amplified interfacial transport of fluids and particles.
1 May 2015 in Journal of Colloid and Interface Science
1 November 2010 in Journal of Membrane Science
25 July 2013 in Soft Matter
In this study we investigate numerically how a partially slippery bubble mattress can be employed to enhance momentum and mass transport. The bubble mattress, which is a superhydrophobic surface, consists of an array of slippery gas bubbles with no-slip walls in between. We consider a pressure-driven laminar flow over the bubble mattress, with a solute being supplied from the gas bubbles. The results show that, because of effective wall slip, solute transport can be enhanced significantly with respect to a fully saturated no-slip wall. The enhancement depends on the interface geometry of the bubble mattress, i.e. on the bubble size, protrusion angle, and surface porosity. In addition, we demonstrate that the mass transfer enhancement disappears below a critical bubble size. The effective slip vanishes for very small bubbles, wherefore interfacial transport becomes diffusion dominated. For large bubbles, solute transport near the interface is convection enhanced.
1 October 2013 in Soft Matter
We investigate the absorption of a pure gas into a liquid in laminar flow past a superhydrophobic surface consisting of alternating solid walls and micro-bubbles. We experimentally measure and numerically estimate the dynamic mass transfer of gas absorption at stable gas–liquid interfaces for short contacting times. We study the net rate of gas absorption experimentally by in situ measurements of dissolved oxygen concentration profiles in aqueous solutions flowing over oxygen bubbles by fluorescence lifetime imaging microscopy. We numerically analyze the dynamics of interfacial mass transfer of dissolved oxygen by considering (i) kinetic equilibrium conditions at bubble surfaces that are conventionally described by Henry's Law and (ii) non-equilibrium conditions at bubble surfaces using Statistical Rate Theory (SRT). Our experimental results show that kinetic equilibrium is not established for short contact times. Mass transfer of gas into liquid flow past micro-bubbles can be well described by our simulations performed with the non-equilibrium theory for a short exposure time (∼180 μs) of liquid with a microbubble, deviating from the commonly accepted Henry's Law.