1 September 2019 in Control Engineering Practice
25 October 2019 in IEEE Access
LSLuiz Carlos Gadelha De Souza
Luiz Carlos Gadelha De Souza
12 August 2019 in IEEE Access
RRReurison Silva Rodrigues
The increasing need for testing and prototyping designs under more realistic conditions is responsible for the advancement of new types of simulation. In this scenario, one type of simulation which has gained high notoriety and applicability is the one known as Hardware-in-the-Loop (HIL). This technique allows real and virtual components of a system to be tested together, making it possible to perform tests under realistic (and even extreme) conditions without harming the real system or a prototype built only for testing. The objective of this work was to develop a low-cost HIL simulation platform to be used for many different applications, unlike most commercial ones, that are developed for one exclusive field of application, such as automotive, aerospace, power electronics, among others. Thus, the main contribution of this work is the project of a HIL platform capable of simulating different types of systems, making it possible to validate embedded control strategies designed for them. Two different applications are tested in order to validate the HIL platform: an active suspension and a satellite attitude control air bearing table, both controlled using a discrete Linear Quadratic Regulator (LQR) designed for each of them.
31 January 2022 in IEEE Access
This paper presents an upper-level vehicular stability controller based on parameterized Model Predictive Control (MPC). The proposed system computes the additional moment applied on the vehicle’s yaw axis to improve the lateral stability. In the MPC formulation, the optimization problem is defined as a quadratic programming derived from a linear time-invariant model of vehicle dynamics. The control system is implemented based on a model that considers the rolling movement and on a simpler model that does not consider it, in order to evaluate the effects of using a more representative linear model for more accurate prediction or a simplified model for faster calculation. Constraints are imposed on the optimization problem to deal with the limits in the corrective yaw moment. A parameterized MPC approach is designed to reduce the number of optimization variables, and hence, reducing the computation time required for real-time implementation. Model-in-the-loop simulations are proposed to evaluate the effectiveness of the MPC strategy to avoid steering instability. Simulations are performed for profiling the calculation time, tuning the parameters, and testing algorithm running in an ARM-Cortex A8 on real-time control. Simulation results show that the proposed control strategy is effective in preventing destabilization and demonstrates that even with a longer computation time, the resulting MPC scheme meets the control requirements successfully, even under the presence of model disturbances.
13 May 2019 in Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering
In this article, a parameterized nonlinear model predictive control strategy is developed for trajectory tracking and stabilization of a quadrotor unmanned aerial vehicle. The control strategy handles structurally with constraints on commands and input derivatives and deals with model uncertainties and white noise on whole state vector. Moreover, the resulting parametrization decreases the number of decision variables related to the nonlinear optimization problem substantially, which highly facilitates the attainment of the optimal control sequence. The proposed nonlinear model predictive control framework also enables the use of different nonlinear formulations of the unmanned aerial vehicle whatever the complexity of the model being used. Simulation results for different flight conditions are presented in order to show the efficiency of the tracking performance and highlight the advantages of the proposed control scheme.