The Precipice Sandstone is a major Great Artesian Basin aquifer in the Surat Basin, Queensland, Australia, which is used for water supply and production of oil and gas. This report describes use of observed groundwater pressure responses to managed aquifer recharge (MAR) at a regional scale to test recent geological descriptions of Precipice Sandstone extent, and to inform its hydrogeological conceptualisation. Since 2015, two MAR schemes have injected over 20 GL of treated water from coal seam gas production into the Precipice Sandstone, with pressure responses rapidly propagating over 100 km, indicating high aquifer diffusivity. Groundwater modelling of injection and inversion of pressure signals using PEST software shows the spatial variability of aquifer properties, and indicates that basin in-situ stresses and faulting exert control on permeability. Extremely high permeability, up to 200 m/day, occurs in heavily fractured regions with a dual-porosity flow regime. The broader-scale estimates of permeability approach an order of magnitude higher than previous studies, which has implications for the management of water resources in the Precipice Sandstone. Results also show the Precipice Sandstone to have broadly isotropic permeability. The results also support a recent geological interpretation of the Precipice Sandstone as having more limited lateral extent than initially considered. The study shows the effective use of MAR injection data to improve geological and hydrogeological understanding through groundwater model inversion. It also demonstrates the utility of combining hydrogeological and reservoir-engineer datasets in areas explored and developed for both groundwater resources and oil and gas resources.
Injected CO 2 streams may have geochemical reactivity to different rock types in a CO 2 storage complex depending on solubility and formation water chemistry. The Precipice Sandstone and Evergreen Formation are a low-salinity reservoir–seal pair in the Surat Basin, Australia, targeted for potential CO 2 storage. The kinetic geochemical CO 2 reactivity of different rock facies from three regions were predicted over 30 and 1000 year time periods. No material CO 2 mineral trapping in the quartz-rich Precipice Sandstone reservoir was predicted, owing to the low rock reactivity. Predicted CO 2 mineral trapping in the Evergreen Formation was more variable due to different amounts of more reactive feldspars, clays, calcite and siderite. Predicted mineral trapping as siderite and ankerite was between 0.03 and 8.4 kg m −3 CO 2 , and mainly depends on chlorite and plagioclase content. Predicted pH was between 5 and 7.5 after 1000 years. Pyrite precipitation was also predicted with SO 2 present in the injectate. QEMSCAN and SEM-EDS (scanning electron microscopy and energy-dispersive spectroscopy) spot imaging of samples from the seal containing natural fractures filled by siderite, pyrite, clays, ankerite, calcite, barite and apatite represent a natural analogue for natural mineral trapping. These are in good agreement with our model predictions. This study suggests that, from a geochemical perspective, the Precipice Sandstone is a suitable storage reservoir, whereas mineral trapping would occur in the overlying Evergreen Formation. Supplementary material: Additional model inputs, characterization and model images, and an excel file of QEMSCAN mineral and porosity components, are available at https://doi.org/10.6084/m9.figshare.c.5395393 Thematic collection: This article is part of the Geoscience for CO 2 storage collection available at: https://www.lyellcollection.org/cc/geoscience-for-co2-storage
The Lower Jurassic Precipice Sandstone and Evergreen Formation are an important prospective reservoir–seal pair for CO 2 storage in the Surat Basin, Australia. However, there is little seismic and well data to constrain reservoir modelling in the best notional injection area. To test the likely storage performance, three contrasting sector-scale static reservoir models were built to capture the range of geological uncertainty in facies distribution and reservoir properties. These considered sectors of the Surat Basin with different palaeogeographical arrangements. The models were focused on capturing detail at the interface between the top of the Precipice Sandstone (Blocky Sandstone Reservoir: BSR) and the overlying basal portions of the Evergreen Formation (Transition Zone: TZ), a critical area for understanding CO 2 injection. Object modelling was used for the BSR and lower TZ. Stochastic modelling was implemented for the upper TZ and the Ultimate Seal because these zones were less sensitive to facies distributions. Porosity was modelled stochastically, and permeability calculated using porosity–permeability transformation functions. Dynamic simulation showed the TZ has the capacity to arrest CO 2 flow out of the BSR given appropriate CO 2 injection conditions. This study shows a method of capturing uncertainty in geological heterogeneity when data are sparse or absent. The promising initial modelling results of CO 2 injection into the Surat Basin suggests that it presents a real option for carbon storage at a climate mitigation scale. Further investigation should focus on assessing other major risks associated with carbon storage such as fault seals, reactive fluid transport and the impact of legacy wells. This article is part of the Energy Geoscience Series available at https://www.lyellcollection.org/cc/energy-geoscience-series
Rapid reduction in global methane emissions has been identified as the fastest approach to reduce future global warming and emission reduction requires accurate identification of sources, and reliable emission quantification. This study addresses an unaccounted source of methane by providing the first longer-term quantification of substantial fugitive methane emissions from an abandoned coal exploration borehole in Queensland, Australia, revealing a mean emission rate of 235 t/a. Depending on the Global Warming Potential applied, this mean rate is equivalent to 6580 or 19,768 t CO2e. The surveyed borehole, classified as a "super-emitter" (>25 kg/h), exhibited substantial temporal variability in methane flux with the 5th and 95th percentile of 22.8 t/a and 438 t/a, respectively. The survey used a trailer mounted Quantum Gas LiDAR system to enable continuous monitoring over seven days and six nights in variable weather conditions. Exploratory data analysis identified a negative correlation with atmospheric pressure as a likely meteorological driver of emission rate variability, although other factors such as subsurface (groundwater) pressure changes may also influence emission rates. The study highlights that legacy coal exploration infrastructure, if improperly sealed, can act as anthropogenic pathways for uncontrolled methane release. These findings indicate the need for surveys of a larger sample of coal exploration holes across Queensland's coal basins to understand the frequency and rates of emissions, to investigate emissions from other holes, such as water bores, and further investigation of emission dynamics considering geological characteristics and nearby activities. This research indicates the possible significance of legacy coal exploration bores as an under-reported and unaccounted source of methane emissions, with potential implications for coal basins globally.
14 March 2024 in Australian Journal of Earth Sciences