1 January 2009 in IAWA Journal
Three lesser known wood species from Mozambique were studied to generate information for identification purposes and facilitate the introduction of these species into the wood working industry by assigning or widening the potential uses of these species. Selected anatomical features were used to predict some important wood properties, subsequently confirmed by measurements of both density and impregnability. Comparative wood anatomy showed that all three wood species have anatomical features typical for their genus after comparisons with their closest relatives. Both ntholo (Pseudolachnostylis maprounaefolia Pax) and muanga (Pericopsis angolensis Meeuwen) are diffuse-porous (with 14–24 and 16–20 vessels/mm2 respectively), have extractives in the heartwood vessels and thick-walled fibres, features consistent with good natural durability and strength respectively. Metil (Sterculia appendiculata K. Schum.) is also diffuse-porous with very wide vessels at much lower frequency (<5/mm2), it lacks extractives in the heartwood vessels, and thin-walled axial and ray parenchyma constitutes the bulk of the ground tissue. This set of characteristics makes the wood light and satisfactory for construction purposes but highly vulnerable to biodegradation.
1 February 2018 in BioResources
The wood anatomy and chemistry of a relatively lesser used wood species, known in Mozambique as nsangala (Millettia mossambicensis J. B. Gillett), was compared to overexploited species jambire (Milletia stuhlmannii Taub.) to provide diagnostic features for safe discrimination. The anatomical results showed that both species shared several similarities such as intervessel pitting size range (8 µm to 11 µm), rays composed of only procumbent cells, fiber dimensions (average length up to 1359 µm and wall thickness up to 10 µm), and banded axial parenchyma. The extractives and lignin content were higher in jambire, while the carbohydrates and acetyl contents were higher in nsangala. The main anatomical feature separating the two species was the porosity pattern with semi-ring porous wood of nsangala compared to the diffuse-porous structure of jambire. Jambire had wider vessel lumina (200 µm) and up to 3 vessels/mm2 compared to nsangala vessel lumina of 86 µm and a frequency of 37 vessels/mm2.
1 January 2019 in Floresta e Ambiente
This study intended to assess the effect of weather on the air-drying process of messassa wood (Brachystegia spiciformis Benth) in two areas of Mozambique (Machipanda and Beira city). First, the logs were sawn into 27 mm thick boards. Every five days the moisture content of the wood was determined by the control samples. For each region, the drying rate and wood quality post sawing and drying were estimated. The drying time differed between the regions under investigation, with Machipanda revealing the higher value. Messassa wood, which revealed a low drying rate (0.33% U/day), was categorized as slow drying wood. Both regions showed average final moisture content of 15.3% in the boards, with only slight variations in moisture inside the stacks. After outdoor drying, only a few defects were noted and as it was free from tensions, hence it was classified as good quality wood.