6 January 2017 in Science Advances
Ultrahigh-energy density (UHED) matter, characterized by energy densities >1 × 108 J cm−3 and pressures greater than a gigabar, is encountered in the center of stars and inertial confinement fusion capsules driven by the world’s largest lasers. Similar conditions can be obtained with compact, ultrahigh contrast, femtosecond lasers focused to relativistic intensities onto targets composed of aligned nanowire arrays. We report the measurement of the key physical process in determining the energy density deposited in high-aspect-ratio nanowire array plasmas: the energy penetration. By monitoring the x-ray emission from buried Co tracer segments in Ni nanowire arrays irradiated at an intensity of 4 × 1019 W cm−2, we demonstrate energy penetration depths of several micrometers, leading to UHED plasmas of that size. Relativistic three-dimensional particle-in-cell simulations, validated by these measurements, predict that irradiation of nanostructures at intensities of >1 × 1022 W cm−2 will lead to a virtually unexplored extreme UHED plasma regime characterized by energy densities in excess of 8 × 1010 J cm−3, equivalent to a pressure of 0.35 Tbar.
27 October 2017 in Optica
VSVyacheslav N. Shlyaptsev
+8
The efficient conversion of optical laser light into bright ultrafast x-ray pulses in laser created plasmas is of high interest for dense plasma physics studies, material science, and other fields. However, the rapid hydrodynamic expansion that cools hot plasmas has limited the x-ray conversion efficiency (CE) to 1% or less. Here we demonstrate more than one order of magnitude increase in picosecond x-ray CE by tailoring near solid density plasmas to achieve a large radiative to hydrodynamic energy loss rate ratio, leading into a radiation loss dominated plasma regime. A record 20% CE into photons was measured in arrays of large aspect ratio Au nanowires heated to keV temperatures with ultrahigh contrast femtosecond laser pulses of relativistic intensity. The potential of these bright ultrafast x-ray point sources for table-top imaging is illustrated with single shot flash radiographs obtained using low laser pulse energy. These results will enable the deployment of brighter laser driven x-ray sources at both compact and large laser facilities.
3 August 2020 in Physical Review E
Structures on the front surface of thin foil targets for laser-driven ion acceleration have been proposed to increase the ion source maximum energy and conversion efficiency. While structures have been shown to significantly boost the proton acceleration from pulses of moderate-energy fluence, their performance on tightly focused and high-energy lasers remains unclear. Here, we report the results of laser-driven three-dimensional (3D)-printed microtube targets, focusing on their efficacy for ion acceleration. Using the high-contrast () PHELIX laser (, ), we studied the acceleration of ions from -thick foils covered with micropillars or microtubes, which we compared with flat foils. The front-surface structures significantly increased the conversion efficiency from laser to light ions, with up to a factor of 5 higher proton number with respect to a flat target, albeit without an increase of the cutoff energy. An optimum diameter was found for the microtube targets. Our findings are supported by a systematic particle-in-cell modeling investigation of ion acceleration using 2D simulations with various structure dimensions. Simulations reproduce the experimental data with good agreement, including the observation of the optimum tube diameter, and reveal that the laser is shuttered by the plasma filling the tubes, explaining why the ion cutoff energy was not increased in this regime.
20 July 2020 in Nature Photonics
1 January 2007 in Optics Express
Arrays of nanodots were directly patterned by interferometric lithography using a bright table-top 46.9 nm laser. Multiple exposures with a Lloyd’s mirror interferometer allowed to print arrays of 60 nm FWHM features. This laser-based extreme ultraviolet interferometric technique makes possible to print different nanoscale patterns using a compact table-top set up.
3 June 2019 in Physical Review B
The domain wall response under constant external magnetic fields reveals a complex behavior where sample disorder plays a key role. Furthermore, the response to alternating magnetic fields has only been explored in limited cases and analyzed in terms of the constant field solution. Here we unveil phenomena in the evolution of magnetic domain walls under the application of alternating magnetic fields within the creep regime, well beyond a small fluctuation limit of the domain wall position. Magnetic field pulses were applied in ultrathin ferromagnetic films with perpendicular anisotropy, and the resulting domain wall evolution was characterized by polar magneto-optical Kerr effect microscopy. Whereas the dc characterization is well predicted by the elastic interface model, striking unexpected features are observed under the application of alternating square pulses: Magneto-optical images show that after a characteristic number of cycles, domain walls evolve toward strongly distorted shapes concomitantly with a modification of domain area. The morphology of domain walls is characterized with a roughness exponent when possible and contrasted with alternative observables which are more suitable for the characterization of this transient evolution. The final stationary convergence as well as the underlying physics is discussed.