In this letter, a low scattering microstrip antenna array has been designed and fabricated using a coding artificial magnetic conductor (AMC) ground. Two different AMC unit cells are designed first, and then they are combined to replace the conventional metallic ground of an antenna array. It is found that the radar cross section (RCS) of the novel antenna array is reduced in a wideband from 6 to 13.4 GHz for the broadband diffusion property of an AMC ground. The maximum RCS reduction of 17 and 16.65 dB can be obtained at 10 GHz for both polarizations. Moreover, the antenna radiation properties are hardly influenced owing to the antenna array and an AMC ground work at different frequencies. The measured results are in good agreement with the simulations, verifying the validity of the proposed design method.
16 April 2018 in IEEE Antennas and Wireless Propagation Letters
In this letter, a novel dual-circular polarization diffusion metasurface is proposed for the radar cross section reduction. Considering the polarization, the diffusion metasurface is designed based on two circular polarizations, and it has different phase distributions for two circular polarizations separately. Through increasing the degree of freedom, a more uniform scattering pattern can be obtained for a linear-polarized incidence. Following this idea, the four types of unit cells are designed, which can independently control phases of left-hand and right-hand circular polarizations in broadband. To achieve broadband low-scattering performance, these unit cells are arranged in a configuration optimized by a genetic algorithm. Simulated and measured results prove that our method offers an effective strategy to design diffusion metasurfaces for broadband low scattering.
30 May 2018 in IEEE Antennas and Wireless Propagation Letters
A broadband substrate integrated waveguide (SIW) cavity-backed slot antenna for endfire applications is presented in the letter. The antenna employs a semiclosed SIW cavity with one sidewall removed and two radiating slots with different shapes etched on top broad wall to enhance bandwidth and radiation performance. With the special combination of the semiclosed SIW cavity and the slots, multiple resonances are generated in a close frequency range to broaden bandwidth. Furthermore, the proposed antenna is flush-mounted on a large metal plate to analyze the influence of platform on antenna performance. Measured results are in good agreement with simulation and show that the antenna bandwidth covers the frequency range 7.8~12.1 GHz for VSWR <; 2, with the fractional bandwidth of 43.2%. High gain of 7.8~11.8 dBi is obtained over the working band.
12 March 2024 in IEEE Transactions on Microwave Theory and Techniques
The development of metasurfaces from periodic designs to quasi-periodic ones, and eventually into reconfigurable periodic forms has significantly enhanced their capabilities. This article explores reconfigurable quasi-periodic metasurfaces (RQPMSs)—the latest generation of metasurfaces comprised of multiple elements. The phase quasi-periodic design plays a crucial role in suppressing symmetrical beams from 1-bit metasurfaces under normally incident plane waves. Three quasi-periodic forms were discussed to investigate the single-beam scanning capabilities of the RQPMS. Two types of low-loss 1-bit elements with a 90 $^{\circ}$ phase difference were designed using an interdigitated structure. The maximum loss of elements is only 0.81 dB within the range of 9.25–11.00 GHz. A random arrangement RQPMS was constructed to confirm single-beam scanning effects. Experimental results demonstrate that the RQPMS can perform single-beam scanning from $-$ 50 $^{\circ}$ to 50 $^{\circ}$ while experiencing scattering loss (SL) less than 73% of the traditional 1-bit MS and sidelobe levels (SLLs) lower than $-$ 8.43 dB. The RQPMS uses only half the amount of diodes compared with traditional 2-bit metasurfaces, thereby simplifying design complexity and minimizing the implementation costs of the MS antenna. The successful implementation of phase quasi-periodic design validates the advantages of the concept of RQPMS and suggests its potential for extension to other parameters such as amplitude quasi-periodicity.
Metasurfaces, as two dimensional periodic structures, are an important candidate to manipulate the polarization of electromagnetic (EM) waves. However, there are few reports on the simultaneous realization of wideband dual-circular polarization conversion using transmissive metasurfaces with one periodic structure in measurement. In this paper, we propose a dual-band dual-circular transmissive metasurface (DCT-MS) for polarization conversion. A DCT-MS simultaneously converts linearly polarized (LP) EM waves into left-hand circularly polarized (LHCP) EM waves in a lower band and right-hand circularly polarized (RHCP) EM waves in a higher band. The unit cell of a DCT-MS consists of a thin substrate and two metal patches in the shape of symmetrical arrows above and below the substrate. The simulated results show that LP waves can be converted into LHCP waves from 7.31 GHz to 10.58 GHz with the axial ratio less than 3 dB. Moreover, the RHCP waves can be realized from 14.26 GHz to 17.36 GHz with the same standard. A DCT-MS sample is measured, and the experimental results are in good agreement with the simulation results.
High-frequency microwave generation based on PCSS devices requires the fastest possible response speed. In this study, we successfully demonstrated controlled donor level doping in 4H-SiC PCSS devices to reduce the carrier recombination lifetime and enhance high-frequency microwave generation. PCSSs with three different doping of nitrogen concentrations were manufactured and compared. By femtosecond transient absorption spectroscopy (fs-TAS), we observed that the 4H-SiC PCSS devices doped with lower nitrogen concentrations exhibited significantly shorter carrier recombination lifetime and faster response speed, ranging from 137 ps to 118 ps. Furthermore, experiment results demonstrate that if nitrogen doping concentration was below 10 16 cm -3 , the PCSS devices could generate high-frequency microwave up to 10 GHz, with improved response speed and higher photoelectric efficiency. Consequently, by precisely controlling the nitrogen concentration, it is feasible to enhance the response frequency of photoconductive microwaves.