Zahra Dehghani

Zahra Dehghani

Auto-generated profile, based on publicly available information

Zahra Dehghani

Department of Physics, University of Neyshabur, P. O. Box 9319774400, Neyshabur, Iran

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2017 in Optik
Verified
Journal Article
Closed access
MNMarzieh Nadafan
Marzieh Nadafan
MPMarziye Parishani
Marziye Parishani
ZDZahra Dehghani
Zahra Dehghani
JAJavid Z. Anvari
Javid Z. Anvari
RMRasoul Malefkar
Rasoul Malefkar

1 June 2022 in Journal of Applied Physics
Verified
Journal Article
Closed access
ZDZ. Dehghani
Z. Dehghani
FOFatemeh Ostovari
Fatemeh Ostovari
MNM. Nadafan
M. Nadafan
In this research, solvothermal synthesized MoSe2 nanosheets were analyzed to determine their structure and optical properties. Measurements through atomic force microscopy, scanning electron microscopy, and transmission electron microscopy confirmed the formation of MoSe2 nanosheets. The energy-dispersive x-ray results revealed the presence of high-purity MoSe2 and an atomic percentage ratio of Mo:Se ∼ 1:1.93. Additionally, x-ray diffraction and Raman showed the crystal structure of MoSe2 and the existence of a two-dimensional (2D) layer, respectively. The linear optical properties of the MoSe2 nanosheets were analyzed by Fourier transform infrared (FTIR) spectroscopy and the Kramers–Kronig method. The FTIR research indicated the vibrational modes of several chemical groups, thus proving the presence of MoSe2 ions. For the varying concentrations of MoSe2 nanosheets in dimethylformamide, the third-order nonlinear optical properties of MoSe2 nanosheets were determined in detail using the Z-scan approach and a continuous-wave Nd:YAG laser. As the transmittance measurements in an open aperture Z-scan setup indicated, all the synthetized samples had saturable absorption. Similar investigations using a close-aperture Z-scan technique proved that all samples had nonlinear refractive indices in the range of 10−7 cm2/W with a positive sign and self-focusing behavior. Moreover, the third-order susceptibility and the figure of merit were found to be in the order of 10−5 esu and 10−4 esu cm, respectively. The findings of this study provide insight about modified 2D materials and expand the use of MoSe2 nanosheets in photonic devices.

1 June 2015 in AIP Advances
Verified
Journal Article
Open access
PDF file
MNMarzieh Nadafan
Marzieh Nadafan
RMRasoul Malefkar
Rasoul Malefkar
ZDZahra Dehghani
Zahra Dehghani
The cordierite (2Mg.2Al2O3.5SiO2) was synthesized by the Pechini method and added to polyurethane open cell (PUOC) foam in three different percentages. Fourier transform infrared spectroscopy (FTIR) was employed to evaluate the bonding characteristics of PUOC/cordierites. The effect of temperature on the synthesis of cordierite and crystallographic structure of the final product were studied by XRD. By increasing the temperature, the widths of the XRD peaks decreased, approaching the single crystal spectrum. The SEM results show that by increasing of cordierite percentage in PUOC foam, the matrix structure was much damaged. Using Z-scan method, optical nonlinearities of samples were measured by continues wave (CW) laser at the wavelength of 532 nm. The nonlinear refractive (NLR) indices and nonlinear absorption (NLA) coefficients of the synthesized samples are obtained in the order of 10−8 (cm2/W) with negative sign and 10−5 (cm/W), respectively. The origin of optical nonlinearity may be attributed to the presence of strong saturable absorption (SA) effect.

13 November 2020 in Energies
Verified
Journal Article
Open access
PDF file
ZSZohreh Shadrokh
Zohreh Shadrokh
SSShima Sousani
Shima Sousani
SGSomayeh Gholipour
Somayeh Gholipour
ZDZahra Dehghani
Zahra Dehghani
YAYaser Abdi
Yaser Abdi
Bart RooseBart Roose
Bart Roose
In this study, inorganic stannite quaternary Cu2M(M = Ni, Co)SnS4 (CMTS) is explored as a low-cost, earth abundant, environmentally friendly and chemically stable hole transport material (HTM). CMTS nanoparticles were synthesized via a facile and mild solvothermal method and processed into aggregated nanoparticle inks, which were applied in n-i-p perovskite solar cells (PSCs). The results show that Cu2NiSnS4 (CNiTS) is more promising as an HTM than Cu2CoSnS4 (CCoTS), showing efficient charge injection as evidenced by considerable photoluminescence quenching and lower series resistance from Nyquist plots, as well as higher power conversion efficiency (PCE). Moreover, the perovskite layer coated by the CMTS HTM showed superior environmental stability after 200 h light soaking in 50% relative humidity, while organic HTMs suffer from a severe drop in perovskite absorption. Although the obtained PCEs are modest, this study shows that the cost effective and stable inorganic CMTSs are promising HTMs, which can contribute towards PSC commercialization, if the field can further optimize CMTS energy levels through compositional engineering.

1 May 2023 in AIP Advances
Verified
Journal Article
Open access
PDF file
MNM. Nadafan
M. Nadafan
GKGh. H. Khorrami
Gh. H. Khorrami
MAM. Arab
M. Arab
ZDZ. Dehghani
Z. Dehghani
AKA. Kompany
A. Kompany
In this research, Zn(1−x)CrxAl2O4 (x = 0.00, 0.05, 0.10, 0.20) nanoparticles were prepared by a simple and green chemistry synthesis using gelatin as a polymerization agent. X-ray diffraction technique and scanning electron microscopy imaging were used to analyze the structural and morphological properties of the samples. X-ray diffraction results revealed that all samples were polycrystalline and crystallized in a cubical spinel phase. With increasing the x from 0.00 to 0.20, the main Bragg peaks shift to smaller angles, and the crystallite size and energy bandgap of samples decrease as well. The nonlinear absorption coefficient, β, and nonlinear refractive index, n2, of Zn(1−x)CrxAl2O4 were meticulously studied by the Z-scan approach. The orders of n2 and β are 10−7 and 10−4 cm/W, respectively. The saturable absorption and the self-defocusing effect are the main factors in the appearance of β and n2, respectively. The experimental results confirmed that increasing the percentage of Cr caused nonlinear coefficients to increase.

1 March 2023 in AIP Advances
Verified
Journal Article
Open access
PDF file
ZDZ. Dehghani
Z. Dehghani
SNS. Nezamdoost
S. Nezamdoost
ANA. Vejdani Noghreiyan
A. Vejdani Noghreiyan
MNM. Nadafan
M. Nadafan
In this research, γ-Al2O3 nanoparticles (NPs) were synthesized by using the sol–gel process. The photon attenuation properties of these NPs were obtained by measuring the linear and mass attenuation coefficients (μl, μm) at different photon energies. In addition, the theoretical values of μm for γ-Al2O3 micro-particles were calculated using the WinXCom computer program and compared with the experimental values of μm for NPs of γ-Al2O3. Furthermore, in order to evaluate the impact of γ-irradiation on these NPs, the experimental values of μl and μm for γ-Al2O3 NPs, before and after receiving 20 kGy dose of γ-irradiation, were investigated. It was observed that μm of γ-Al2O3 NPs decreases after receiving γ-irradiation because of increasing the photon’s energy, which indicates the changes in the molecular structure of NPs after γ-irradiation. Moreover, the structural properties of NPs were evaluated by UV–Vis spectroscopy, x-ray diffraction patterns, and scanning electron microscopy images. UV–Vis spectroscopy showed an absorption peak at 212.5 nm before γ-irradiation, and the absorption peak of NPs disappeared when γ-irradiation was started. The average crystalline size was determined to be 3.65 nm in the sample before γ-irradiation and 9.29 nm in the sample with the maximum dose of 20 kGy. The results of scanning electron microscopy show an increase in particle size from 6.5 nm in a non-irradiated sample up to 9 nm in a sample with the highest γ-irradiation dose.