The exploitation of ever increasing Interferometric Synthetic Aperture Radar (InSAR) data sets to monitor the Earth's surface deformation is an important goal of today's geodesy. In this study our observations consist of deformations along the Line‐Of‐Sight direction of the satellite. Our observations are the result of the combination of a multitude of sources (either volcano‐tectonic or nontectonic deformation). In most cases, we are facing a Blind source separation (BSS) problem. Natural approaches to tackle BSS problems are multivariate statistical techniques that attempt to decompose the data set into a limited number of statistically independent sources, under the assumption that the different physical mechanisms contributing to the observations have independent footprints in space and/or time. We show the capabilities of a variational Bayesian independent component analysis (vbICA) algorithm in dealing with synthetic InSAR time series and compare it to the commonly used FastICA algorithm. We explore the effectiveness of the spatial and temporal mode decompositions. We apply vbICA on data relative to the San Joaquin Valley and the Central San Andreas fault (CSAF), California, spanning the time range 2015/03/01–2019/07/14. The proposed approach likely isolates the contribution of shallow and deep aquifers to the surface deformation as well as the elastic and inelastic deformation. We present a 1‐dimensional compaction estimation of the elastic and inelastic storage coefficients adopting a formalism that takes into account the last century water level history. Concerning the CSAF, the algorithm helps separating tectonic loading from seasonal behavior concentrated in the Quaternary sediments of the Salinas Valley.
29 May 2018 in Journal of Geophysical Research: Solid Earth
We apply a blind source separation algorithm to the ground displacement time series recorded at continuous Global Positioning System (GPS) stations in the European Eastern Alps and Northern Dinarides. As a result, we characterize the temporal and spatial features of several deformation signals. Seasonal displacements are well described by loading effects caused by Earth surface mass redistributions. More interestingly, we highlight a horizontal, nonseasonal, transient deformation signal, with spatially variable amplitudes and directions. The stations affected by this signal reverse the sense of movement with time, implying a sequence of dilatational and compressional deformation that is oriented normal to rock fractures in karst areas. The temporal evolution of this deformation signal is correlated with the history of cumulated precipitations at monthly time scales. This transient horizontal deformation can be explained by pressure changes associated with variable water levels within vertical fractures in the vadose zones of karst systems. The water level changes required to open or close these fractures are consistent with the fluctuations of precipitation and with the dynamics of karst systems.
15 December 2018 in Journal of Geophysical Research: Solid Earth
Deformation of the Earth's surface associated with redistributions of continental water mass explains, to first order, the seasonal signals observed in geodetic position time series. Discriminating these seasonal signals from other sources of deformation in geodetic measurements is essential to isolate tectonic signals and to monitor spatio‐temporal variations in continental water storage. We propose a new methodology to identify and extract these seasonal signals. The approach uses a variational Bayesian Independent Component Analysis (vbICA) to extract the seasonal signals and a gravity‐based deformation model to identify which of these signals are caused by surface loading. We test the procedure on two study areas, the Arabian Peninsula and the Nepal Himalaya, and find that the technique successfully extracts the seasonal signals with one or two independent components, depending on whether the load is stationary or moving. The approach is robust to spatial heterogeneities inherent to geodetic measurements and can help extract systematic errors in geodetic products (e.g., draconitic errors). We also discuss how to handle the degree‐1 deformation field present in the geodetic data set but not captured by the gravity‐based model.