Obtaining uniform silicon concentration, especially with low concentrations (ranging from 1 × 1016 to 1 × 1018 cm−3) by molecular beam epitaxy, has been challenging due to oxidation of a silicon solid source in the oxide environment. In this work, Si doping of β-Ga2O3 (010) films by diluted disilane as the Si source is investigated using hybrid plasma-assisted molecular beam epitaxy. The impact of growth temperature, disilane source concentration, and disilane flow rate on Si incorporation was studied by secondary ion mass spectrometry. Uniform Si concentrations ranging from 3 × 1016 to 2 × 1019 cm−3 are demonstrated. Si-doped β-Ga2O3 films with different silicon concentrations were grown on Fe-doped β-Ga2O3 (010) substrates. The electron concentration and mobility were determined using van de Pauw Hall measurements. A high mobility of 135 cm2/V s was measured for an electron concentration of 3.4 × 1017 cm−3 at room temperature.
Traditionally, elemental Ga and Si have been used to supply Ga and Si, respectively, in molecular beam epitaxy (MBE) to grow Si-doped β-Ga2O3. In this work, we investigated the feasibility of enhancing the β-Ga2O3 growth rate by using a Ga-suboxide precursor in a plasma-assisted MBE. Additionally, Si doping of β-Ga2O3 using diluted disilane and Ga-suboxide as the Si and Ga precursors, respectively, was studied. The growth rate and film quality under different suboxide fluxes were inspected. We found that Si concentration has an inverse relationship with Ga2O flux due to atom competition. A room-temperature mobility of 115 cm2/V s was measured for an electron concentration of 1.2 × 1017 cm−3 on the sample grown using a Ga2O beam equivalent pressure of 1.1 × 10−7 Torr and a disilane flow rate of 0.006 sccm. Temperature-dependent Hall characterization was performed on this sample, revealing compensating acceptor and neutral impurity densities of 2.70 × 1015 and 8.23 × 1017 cm−3, respectively.
The interface and bulk properties of ∼20 nm hafnium-silicon-oxide (HfSiOx) dielectric deposited by atomic layer deposition (ALD) on (001) β-Ga2O3 were investigated systematically using deep ultraviolet photo-assisted capacitance–voltage (C–V) and current–voltage (I–V) measurements. The ALD HfSiOx dielectric constant, bulk, and HfSiOx/Ga2O3 interface quality and breakdown field were determined, and the impact of post-deposition annealing (PDA) on these parameters was studied. PDA reduced near-interface traps resulting in a smaller hysteresis without changing the dielectric constant. An average trap density of 2.72 × 1012 and 1.06 × 1012 cm−2 eV−1 was measured on samples with PDA at 400 and 900 °C, respectively. In addition, a high dielectric constant of 9.28 and breakdown field as high as 8.7 MV/cm were achieved on these devices.
31 May 2023 in Journal of Vacuum Science & Technology A
In the present study, thermal stability of α-Ga2O3 under vacuum and ambient pressure conditions was investigated in situ by x-ray diffraction and transmission electron microscopy (TEM). It was observed that the thermal stability of α-Ga2O3 increased by 200 °C when pressure was lowered from an atmospheric to a vacuum level. This finding can be explained by oxygen diffusion under different oxygen partial pressures. In addition, in situ TEM imaging revealed that, once past the decomposition temperature, the onset of phase change propagates from the top crystal surface and accumulates strain, eventually resulting in a fractural film. The mechanism of α-Ga2O3 to β-Ga2O3 transition is evaluated through experiments and is discussed in this manuscript.
We report the epitaxial growth of (010) β-(AlxGa1−x)2O3 using tritertiarybutylaluminum (TTBAl) as an aluminum gas precursor in a hybrid molecular beam epitaxy (h-MBE) system. In conventional MBE systems, a thermal effusion cell is typically used to supply Al. However, in an oxide MBE system, using a conventional Al effusion cell can cause difficulties due to the oxidation of the Al source during growth. This often requires breaking the vacuum frequently to reload Al. Our approach utilizes TTBAl, a gaseous Al source, via a h-MBE to circumvent the oxidation issues associated with traditional solid Al sources. We investigated the growth conditions of β-(AlxGa1−x)2O3, varying TTBAl supply and growth temperature. For this purpose, we utilized both elemental Ga and Ga-suboxide as Ga precursors. Controllable and repeatable growth of β-(AlxGa1−x)2O3 with Al compositions ranging from 1% to 25% was achieved. The impurity incorporation and crystal quality of the resulting β-(AlxGa1−x)2O3 films were also studied. Using TTBAl as a gaseous precursor in h-MBE has proven to maintain stable Al supply, enabling the controlled growth of high-quality β-(AlxGa1−x)2O3 films.
1 March 2023 in Journal of Vacuum Science & Technology A
There is increasing interest in α-polytype Ga2O3 for power device applications, but there are few published reports on dielectrics for this material. Finding a dielectric with large band offsets for both valence and conduction bands is especially challenging given its large bandgap of 5.1 eV. One option is HfSiO4 deposited by atomic layer deposition (ALD), which provides conformal, low damage deposition and has a bandgap of 7 eV. The valence band offset of the HfSiO4/Ga2O3 heterointerface was measured using x-ray photoelectron spectroscopy. The single-crystal α-Ga2O3 was grown by halide vapor phase epitaxy on sapphire substrates. The valence band offset was 0.82 ± 0.20 eV (staggered gap, type-II alignment) for ALD HfSiO4 on α-Ga0.2O3. The corresponding conduction band offset was −2.72 ± 0.45 eV, providing no barrier to electrons moving into Ga2O3.