Signals, Systems and Components Laboratory, Faculty of Science and Technology of Fez, University Sidi Mohammed Ben Abdellah USMBA, Route d’Imouzzer, Fez P.O. Box 2202, Morocco
Auto-generated profile, based on publicly available information
Taj-Dine Lamcharfi
Signals, Systems and Components Laboratory, Faculty of Science and Technology of Fez, University Sidi Mohammed Ben Abdellah USMBA, Route d’Imouzzer, Fez P.O. Box 2202, Morocco
In this work, the influence of zinc doping on structural and dielectric properties of CaCu(3-x)ZnxTi4O12 (CCZxTO with x = 0, 2.5, 5, 7.5, 10, 12.5 and 15%) ceramics sintered at 1000 ºC for 8 h was studied. The ceramic samples were prepared by the conventional solid-state and calcined at 1050 ºC for 4 h. The X-ray diffraction (XRD) analysis of pure and Zn-doped CCTO were analyzed by using Rietveld refinement with cubic CCTO phase with no trace impurity phase. The scanning electron microscopy (SEM) investigation showed that for Zn-doped CCTO, the grains distributions were homogenous with average sizes which decreased with increasing of Zn concentration. The dielectric permittivity as function of temperature showed two dielectric anomalies (weakly and strong) and the dielectric constant value largely decreased for x = 2.5%, which is about tree magnitude smaller than the pure ceramic. Then it increased and reached a maximum at x = 10%, which is larger than the value of pure ceramic. And for x > 10%, the dielectric constant decreased for about two magnitude smaller than the ceramic at x = 10%. The cole-cole diagramm for all the samples showed existence of two semi-arcs attributed to the grains and grains boundaries. It was found that the Rg values were much smaller than the Rgb value. This give an evidance on the formation of interior barrier layer capacity (IBLC).
In present work, the structural and dielectric properties of Pb1-xCuxZr0.52Ti0.48O3 (PCxZT) ceramics where x = 0. 0.025, 0.05, 0.075, 0.10, 0.15 and 0.20 were studied. Powder of the compositions (PCxZT) was obtained by sol-gel route, the powders were calcined at 700 ºC for 4 h and sintered at 1100 ºC for 4 h. X-ray diffraction analysis and Raman spectroscopy suggest the formation of mixed-phase of tetragonal and rhombohedral structure which was confirmed by Rietveld refinement. Dielectric measurements of the compounds were studied as a function of temperature (from room temperature to 420 ºC at different frequencies) and as a function of frequency (from 100 Hz to 2 MHz at different temperatures). The temperature variation of the real permittivity gives evidence of the ferroelectric phase transition as well as of the resonance behaviour also observed in the dielectric permittivity frequency-dependent variation.
25 January 2025 in Indonesian Journal of Chemistry
In this paper, we studied the effect of strontium doping on the structural, microstructural, dielectric, and electrical properties of Ba1-xSrxTiO3 (BSxT) ceramics prepared via the sol-gel method, with x = 0.00 to 0.15. The results obtained from the X-ray diffraction spectrum confirmed the creation of the pure perovskite structure, with the diffraction peaks of the BSxT shifting toward the bigger 2θ with increasing Sr content. Scanning electron microscopy images show that the grain size of the BSxT ceramics decreases with increasing Sr content. An increase in Sr content appears to lower the activation energy by the factor of 0.16 meV/mol% and to decrease Curie temperature by the factor of 3.34 °C/mol%. Furthermore, in case of 15 mol% of Sr addition, the dielectric constant value is increased about twice. Moreover, the relationship between grain sizes and dielectric properties was also investigated. Using the frequency measurement method (up to 2 MHz in a step of 1 kHz), we are able to determine the temperature of transition without using the conventional method.
1 March 2025 in Insights into Regional Development