The improvement of the performance of a distributed Bragg reflector laser bar emitting near 905 nm through the use of multiple epitaxially stacked active regions and tunnel junctions is reported. The bar consisting of 48 emitters (each having an aperture of 50 µm) emits an optical power of 2.2 kW in 8 ns long pulses at an injection current of 1.1 kA. This corresponds to an almost threefold increase of the pulse power compared to a bar with lasers having only a single active region. Due to the integrated surface Bragg grating, the bar exhibits a narrow spectral bandwidth of about 0.3 nm and a thermal tuning of only 68 pm/K.
3 September 2024 in IEEE Journal of Selected Topics in Quantum Electronics
For LiDAR applications, compact, robust, and mass-producible light sources generating high-peak power nanosecond-long pulses are essential. This paper presents an investigation of power scaling in semiconductor lasers via the number of epitaxially stacked active regions in a single vertical waveguide supporting a higher order mode, chip length, output aperture width, and lateral waveguide design. All devices are wavelength-stabilized using surface gratings integrated either as a passive section at the rear facet of the diode laser as a distributed-Bragg-reflector (DBR) or along the full length of the chip in a distributed feedback (DFB) design. A 4 mm long broad-area (BA) DBR laser with a stripe width of 200 $\mu$ m and five active regions delivered approximately 171 W at 80 A, a factor of 6.6 more peak pulse power than the standard 6 mm long single active region DBR laser with 50 $\mu$ m stripe width. A corresponding 3 mm long 3-active region DFB-BA laser achieved more than 125 W at 129 A. These BA lasers have a lateral beam propagation ratio M $^{2}\approx$ 30. In contrast, weakly tapered ridge waveguide (TRW) lasers were found to generate more than 20 W with an M $^{2}$ of about 3 and an excellent lateral brightness of 24 W $\cdot$ mm $^{-1}$ mrad $^{-1}$ .
Distributed feedback (DFB) broad area (BA) lasers with multiple epitaxially stacked active regions and tunnel junctions designed for emission around 900 nm are investigated. DFB BA lasers with a cavity length of 1 mm and different stripe widths are compared in terms of their electro-optical performance and beam quality. The laser with a 200 µm stripe width achieved a high optical pulse power of 100 W in 10 ns long pulses at an injection current of 63 A, resulting in a brightness of 81 MW/cm2sr. The optical spectrum of both lasers is centered at around 886 nm, exhibiting a narrow spectral bandwidth of 0.2 nm (64 pm/K).
We report a record-high pulse power of 420 W or a pulse energy of 4.2 μJ at a pulse current of 210 A, emitted by a single distributed Bragg reflector broad-area laser with 5 active regions separated by 4 tunnel junctions. The laser is operated with nanosecond current pulses at a repetition frequency of 10 kHz so that optical pulses with a width of 10 ns are emitted. The emission spectrum exhibits a spectral peak at approximately 905 nm at 25 °C with a spectral width of less than 0.2 nm and a temperature-related shift of 63 pm K−1. We also investigate the dependence of the output power on cavity length and number of active regions. A 4 mm long laser with 3 active regions achieves a pulse power of 272 W at 150 A. At the same current, 2 mm long lasers with 3 and 5 active regions achieve output powers of 167 W and 283 W, respectively. Despite its shorter cavity, the 2 mm long 5 active region laser delivers 10 W more output power at 150 A than the 4 mm long laser with 3 active regions. All lasers under study have a p-contact stripe width of 200 μm.
The improvement of the performance of a distributed Bragg reflector laser bar emitting near 905 nm through the use of multiple epitaxially stacked active regions and tunnel junctions is reported. The bar consisting of 48 emitters (each having an aperture of 50 μm) emits an optical power of 2.2 kW in 8 ns long pulses at an injection current of 1.1 kA. This corresponds to an almost threefold increase of the pulse power compared to a bar with lasers having only a single active region. Due to the integrated surface Bragg grating, the bar exhibits a narrow spectral bandwidth of about 0.3 nm and a thermal tuning of only 68 pm/K.