In this study, in order to solve the problems of low sensitivity and complex sample pretreatment in traditional detection, a method was proposed to detect plant growth regulators using terahertz combined with metamaterial sensors. Two metamaterial sensors with different structures are designed. The differences of two kinds of metamaterial sensors for detecting plant growth regulators were analyzed from three aspects of frequency domain, time domain and absorption characteristics. It is further proved that the difference of metamaterial structure will lead to the change of frequency shift, time domain waveform and absorption characteristics of measured samples, and the influence of sample concentration on the detection characteristics of the metamaterial sensor. The results show that both metamaterial sensors can effectively detect the four plant growth regulator solutions with concentrations as low as 0.05 mg/L. In terms of detection and sensing, the frequency shift, sensitivity, figure of merit value, vibration amplitude and change rate of absorption intensity of metamaterial sensor 2 are higher than each parameter of metamaterial sensor 1, which has better detection performance. However, in terms of identification between samples, metamaterial sensor 1 is more suitable for the identification of daminozide and naphthaleneacetic acid solutions, and metamaterial sensor 2 was more suitable for the detection of glyphosine and gibberellic acid solutions. It provides a new method for multi-target fusion to detect plant growth regulators with high sensitivity and high accuracy.
The rapid and sensitive detection of plant-growth-regulator (PGR) residue is essential for ensuring food safety for consumers. However, there are many disadvantages in current approaches to detecting PGR residue. In this paper, we demonstrate a highly sensitive PGR detection method by using terahertz time-domain spectroscopy combined with metamaterials. We propose a double formant metamaterial resonator based on a split-ring structure with titanium-gold nanostructure. The metamaterial resonator is a split-ring structure composed of a titanium-gold nanostructure based on polyimide film as the substrate. Also, terahertz spectral response and electric field distribution of metamaterials under different analyte thickness and refractive index were investigated. The simulation results showed that the theoretical sensitivity of resonance peak 1 and peak 2 of the refractive index sensor based on our designed metamaterial resonator approaches 780 and 720 gigahertz per refractive index unit (GHz/RIU), respectively. In experiments, a rapid solution analysis platform based on the double formant metamaterial resonator was set up and PGR residues in aqueous solution were directly and rapidly detected through terahertz time-domain spectroscopy. The results showed that metamaterials can successfully detect butylhydrazine and N-N diglycine at a concentration as low as 0.05 mg/L. This study paves a new way for sensitive, rapid, low-cost detection of PGRs. It also means that the double formant metamaterial resonator has significant potential for other applications in terahertz sensing.
Metamaterial absorber has the advantages of high absorption rate and small size, but its absorption band is very narrow or the number of absorption peaks is limited, which greatly limits its practical application. In this study, a flexible metamaterial composed of a rectangular-ring-rectangle planar array is fabricated, which can realize the absorption of double resonance peaks. The results show that the designed metamaterial absorber has two resonance absorption peaks at 1.04 THz and 1.92 THz, and the absorption rates are 94.06% and 97.07%, respectively. The maximum sensitivity of the resonance peak 1 is 36.11 GHz/RIU, and the maximum sensitivity of the resonance peak 2 is 91.67 GHz/RIU. Based on the absorption enhancement mechanism of the double absorption peaks of metamaterials, a highly sensitive detection of forchlorfenuron was achieved with a limit of detection at 0.01 mg/L. More importantly, the designed metamaterial absorber has also been successfully applied to the detection of forchlorfenuron on the surface of tomatoes, which are in line with the regulations on the maximum pesticide residues in food. The experimental results further prove the feasibility of the designed metamaterial for the detection of biological interfaces, and provide a promising sensing platform for the detection of pesticide residues.
Designing a sensitized structure to improve inherent performance of photoactive materials is an effective strategy for improving the sensitivity of “signal-off” photoelectrochemical aptasensing. Here, we present a facile thermal-treatment route for fabricating ZnO/graphene sensitized structure (ZnO/GR nanocomposite) via using zinc sulfate and graphene oxide (GO) as starting materials. The PEC performance of ZnO/GR nanocomposite can be controlled by the annealing temperature. It was found that the annealing temperature greatly affects the phase transition and nanocrystallite size of the prepared nanostructure. X-ray diffraction showed the ZnO began to form at the decomposition temperature of 530 °C, indicating the existence of GO can greatly decrease the decomposition temperature of zinc sulfate from 930 °C to 530 °C. The morphology characterization illustrated an increase in the average ZnO NPs nanocrystallite size from ~30 nm to ~100 nm when the annealing temperature was varied from 530 °C to 700 °C. Further, we investigated the PEC behavior of these different nanostructures obtained under various temperatures, and the significant photocurrent intensity of ZnO/GR nanocomposite was also obtained at the annealing temperature of 700 °C, because the well distributed and increased crystallite size can reduce the recombination rate of electron–hole pairs on the ZnO/GR nanocomposite thin films. Finally, a “signal-off” PEC sensor was designed for Adenosine triphosphate (ATP) detection based on a ZnO/GR-700 °C nanocomposite as photoactive materials and an ATP-binding aptamer as the recognition element. This “signal-off” PEC aptasensor exhibited a wide linear range from 5 to 3000 nM with a low detection limit of 1.66 nM.
Terahertz technology is receiving increasing attention for its use as an efficient non-destructive, non-contact and label-free optical method for qualitative and quantitative detection.
The abuse of high concentrations of forchlorfenuron can lead to malformed fruits and pose risks to human health, highlighting the need for effective detection methods. In this study, a flexible multi-frequency resonant terahertz metamaterial sensor is designed and validated both theoretically and experimentally. The sensor exhibits magnetic dipole resonances at 0.53 THz and 2.30 THz, and the physical enhancement mechanism of the magnetic dipole resonances is analyzed through the distributions of electric field, magnetic field, and surface current. Simulation results reveal that the metamaterial sensor achieves a maximum detection sensitivity of 440 GHz/RIU, with multi-frequency resonance maintained across a polarization angle range of 0°– 90°. Experimental detection reveals that the designed multi-frequency resonant metamaterial sensor successfully detects different concentrations of forchlorfenuron, with a minimum detectable concentration of 0.01 mg/L. These theoretical and experimental results confirm the feasibility of a multi-frequency resonant terahertz metamaterial sensor for forchlorfenuron detection.