In this letter we report on a metal–semiconductor–metal photodetector based on thick relaxed Ge layers, epitaxially grown on silicon after insertion of a low-temperature-grown Ge buffer layer. The detector shows a good responsivity at normal incidence at both 1.3 and 1.55 μm, with a maximum responsivity of 0.24 A/W at 1.3 μm under a 1 V bias. A response time of about 2 ns has been measured.
Exploiting Ge K-edge x-ray absorption spectroscopy we provide direct evidence of Si–Ge intermixing in self-organized strained and unstrained Ge quantum dots on Si, and provide a quantitative measurement of the average composition. For Ge/Si(001) dots with equivalent thickness in the range 5.8–38 nm and morphology ranging from that typical of coherently strained to that associated with relaxed dots we find that the average Si composition is approximately 30%. For Ge/Si(111), we find that the wetting layer has a Si composition near 50%. We discuss these results in terms of the energetics of dot formation and argue that strain-enhanced diffusion of Si into Ge should be considered as an important factor in minimizing the strain energy of the system.
We present a new experimental method for determining band lineups at the semiconductor heterojunctions and apply it to the heterostructure. This method uses a modern version of an old spectroscopy: the photoelectric yield spectroscopy excited with photons in the near UV range. It is shown that both substrate and overlayer valence-band tops can be identified in the yield spectrum due to the high escape depth and the high dynamical range of the technique, thus allowing a direct and precise determination of the band lineup. A value of was found for the valence band discontinuity.
In this letter, we present an atomic-force-microscopy investigation of the Stranski–Krastanov growth of Ge on Si(100). Upon increasing the base width of the islands, two morphology transitions are found. The first transition occurs at a base width of ∼50–60 nm and marks the evolution from few-monolayer-thick terraces to square-base pyramidal islands. In the second transition, which takes place when the base width exceeds ∼300 nm, the island shape changes from square base pyramids to tetragonal truncated pyramids. Both transitions are brought about by the need for the system to minimize the elastic energy.