10 August 2024 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
1 September 2025 in Review of Scientific Instruments
Neutron Time-of-Flight (nTOF) detectors are key diagnostics to detect thermonuclear neutrons in laser-fusion experiments. This diagnostic, however, is often plagued by strong gamma-ray noise prior to neutron signals, especially in harsh fast-ignition (FI) environments. To address this issue, a combination of low-afterglow liquid scintillators with time-gated photomultiplier tubes as necessary nTOF components would be a natural solution. However, the calibration of such detectors is challenging due to low detection efficiency and low neutron yield in FI experiments. In this paper, we propose a novel method to cross-calibrate a gated low-afterglow nTOF spectrometer using a pre-calibrated traditional non-gated nTOF spectrometer. This approach was demonstrated using neutrons from counter-streaming deuterated-polystyrene plasmas driven by the ShenGuang-II (SG-II) laser facility, with neutron yields ranging from 4 × 105 to 1 × 107. By implementing this calibration method, we anticipate a significant improvement in the accuracy of neutron detection within a 10% uncertainty for double-cone ignition experiments.
4 March 2026 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
28 October 2025 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
1 July 2025 in Journal of Instrumentation
This study focuses on the optimization of discrete dynode electron multipliers (DEMs), which are critical for high-sensitivity signal detection in applications such as particle physics, nuclear reaction monitoring, and medical imaging. The research employs CST Studio Suite® electromagnetic simulations to analyze the impact of structural parameters — such as inter-dynode voltages, incidence angles, and surface coatings — on electron trajectory dynamics and multiplication efficiency. A 26-stage MgO dynode array is simulated, featuring dual output modes (analog and pulse counting) to accommodate varying ion input densities. The optimization process identifies key geometric parameters, including dynode spacing, curvature, and alignment, that significantly influence gain performance. The optimized design achieves a simulated gain of 1.8×105 in analog mode and 5.5×107 in pulse-counting mode, representing substantial improvements over baseline configurations. Experimental validation confirms the simulation trends, though discrepancies due to material degradation during assembly are noted. This work provides actionable insights for the design and optimization of high-performance DEMs, addressing challenges in achieving stable, high-gain operation over extended periods.
30 September 2024 in International Journal of Modern Physics A