14 February 2025 in Journal of Lightwave Technology
The performance of received signal strength (RSS)-based visible light positioning (VLP) is heavily reliant on the pre-existing channel model which describes the RSS attenuation with distance. In indoor areas, dust particles accumulating on the surfaces of LEDs may cause the pre-existing channel model deviating from actual situations and consequently decrease the localization performance. In this paper, we first experimentally verify the impact of dust on the RSS VLP system performance and find that the positioning error is significantly increased even in slight dust deposition scenarios. Then we modify the classical Lambertian-based channel model to reflect the influence of dust, and propose a two-points approach which performs the channel model calibration only based on two RSS measurements. Additionally, the variations of the channel model parameters with the accumulation of dust are observed and mathematically modeled. A single-point approach is further designed which requires only one RSS measurement for each channel model calibration. The experimental results demonstrate that the average positioning error remains below 6 cm under different dust accumulation scenarios. The negative impact of dust can be effectively mitigated by our proposed RSS VLP scheme with low system maintenance cost. To the best of our knowledge, this is the first piece of work considering dust accumulation for VLP.
2 June 2026 in IEEE Journal on Selected Areas in Communications
The integration of visible light communication (VLC) and wireless power transfer (WPT) offers a sustainable platform for powering Internet of Things (IoT) devices while enabling simultaneous data transmission. However, conventional receivers based on a single photovoltaic (PV) cell are constrained by the inherent trade-off between bandwidth and output power. To overcome this limitation, this paper proposes a PV array-based solution and designs its circuit topology, achieving both high output power and extended bandwidth. An equivalent circuit model of the PV array is established to facilitate theoretical analysis, and the transfer function is derived to evaluate system performance. Furthermore, the influences of different array configurations and peripheral circuits are investigated, leading to the adoption of an optimized bridged-T-coil structure. Numerical simulations and comparative experiments on 4-cell array configuration demonstrate that the proposed bridged-T-coil topology achieves a 3.13× bandwidth enhancement and nearly quadrupled output power com-pared to a single PV cell. Furthermore, when evaluated against the average bandwidth-power product (BW×Pmax) of the five other internally developed array architectures for a fair comparison, the bridged-T-coil array yields a value of 93.81, exceeding their mean performance by approximately 20.7% on average. To the best of our knowledge, this work presents the first systematic design and investigation into the circuit topology and performance of a PV array receiver for VLC-WPT systems, and provides a practical receiver solution for low-power IoT nodes requiring integrated energy and communication capabilities.
2 June 2026 in IEEE Sensors Journal
Fingerprint-based visible light positioning (VLP) can achieve centimeter-level accuracy, but it requires high labor and time costs for constructing a dense fingerprint database. In indoor areas, the accumulation of dust on the surface of LEDs is inevitable, which will continuously reduce the accuracy of the prebuilt fingerprints. However, frequent reconstruction of the dense fingerprint database will severely exacerbate the data collection burden, resulting in an impractical VLP system. To tackle this challenge, we propose a novel low-cost fingerprint database regeneration scheme for mitigating the impact of dust, which fully exploits both the spatial and temporal information of fingerprints to reduce the regeneration cost. In a typical positioning area illuminated by four LEDs, only 4 measurements are needed for each database regeneration. This is the lowest labor cost for fingerprint-based VLP to the best of our knowledge. Moreover, the scheme does not rely on a signal propagation model, and thus it is applicable to both Lambertian and non-Lambertian light sources. Experimental results demonstrate that, by our proposed scheme, the average positioning error always remains below 6 cm in various light sources and dust accumulation scenarios.