1 March 2016 in Bulletin of the American Meteorological Society
The Deep Propagating Gravity Wave Experiment (DEEPWAVE) was designed to quantify gravity wave (GW) dynamics and effects from orographic and other sources to regions of dissipation at high altitudes. The core DEEPWAVE field phase took place from May through July 2014 using a comprehensive suite of airborne and ground-based instruments providing measurements from Earth’s surface to ∼100 km. Austral winter was chosen to observe deep GW propagation to high altitudes. DEEPWAVE was based on South Island, New Zealand, to provide access to the New Zealand and Tasmanian “hotspots” of GW activity and additional GW sources over the Southern Ocean and Tasman Sea. To observe GWs up to ∼100 km, DEEPWAVE utilized three new instruments built specifically for the National Science Foundation (NSF)/National Center for Atmospheric Research (NCAR) Gulfstream V (GV): a Rayleigh lidar, a sodium resonance lidar, and an advanced mesosphere temperature mapper. These measurements were supplemented by in situ probes, dropsondes, and a microwave temperature profiler on the GV and by in situ probes and a Doppler lidar aboard the German DLR Falcon. Extensive ground-based instrumentation and radiosondes were deployed on South Island, Tasmania, and Southern Ocean islands. Deep orographic GWs were a primary target but multiple flights also observed deep GWs arising from deep convection, jet streams, and frontal systems. Highlights include the following: 1) strong orographic GW forcing accompanying strong cross-mountain flows, 2) strong high-altitude responses even when orographic forcing was weak, 3) large-scale GWs at high altitudes arising from jet stream sources, and 4) significant flight-level energy fluxes and often very large momentum fluxes at high altitudes.
1 July 2016 in Journal of the Atmospheric Sciences
During the Deep Propagating Gravity Wave Experiment (DEEPWAVE) project in June and July 2014, the Gulfstream V research aircraft flew 97 legs over the Southern Alps of New Zealand and 150 legs over the Tasman Sea and Southern Ocean, mostly in the low stratosphere at 12.1-km altitude. Improved instrument calibration, redundant sensors, longer flight legs, energy flux estimation, and scale analysis revealed several new gravity wave properties. Over the sea, flight-level wave fluxes mostly fell below the detection threshold. Over terrain, disturbances had characteristic mountain wave attributes of positive vertical energy flux (EFz), negative zonal momentum flux, and upwind horizontal energy flux. In some cases, the fluxes changed rapidly within an 8-h flight, even though environmental conditions were nearly unchanged. The largest observed zonal momentum and vertical energy fluxes were MFx = −550 mPa and EFz = 22 W m−2, respectively. A wide variety of disturbance scales were found at flight level over New Zealand. The vertical wind variance at flight level was dominated by short “fluxless” waves with wavelengths in the 6–15-km range. Even shorter scales, down to 500 m, were found in wave breaking regions. The wavelength of the flux-carrying mountain waves was much longer—mostly between 60 and 150 km. In the strong cases, however, with EFz > 4 W m−2, the dominant flux wavelength decreased (i.e., “downshifted”) to an intermediate wavelength between 20 and 60 km. A potential explanation for the rapid flux changes and the scale “downshifting” is that low-level flow can shift between “terrain following” and “envelope following” associated with trapped air in steep New Zealand valleys.
1 April 2022 in Journal of the Atmospheric Sciences
Four state-of-the-science numerical weather prediction (NWP) models were used to perform mountain wave (MW)-resolving hindcasts over the Drake Passage of a 10-day period in 2010 with numerous observed MW cases. The Integrated Forecast System (IFS) and the Icosahedral Nonhydrostatic (ICON) model were run at Δx ≈ 9 and 13 km globally. The Weather Research and Forecasting (WRF) Model and the Met Office Unified Model (UM) were both configured with a Δx = 3-km regional domain. All domains had tops near 1 Pa (z ≈ 80 km). These deep domains allowed quantitative validation against Atmospheric Infrared Sounder (AIRS) observations, accounting for observation time, viewing geometry, and radiative transfer. All models reproduced observed middle-atmosphere MWs with remarkable skill. Increased horizontal resolution improved validations. Still, all models underrepresented observed MW amplitudes, even after accounting for model effective resolution and instrument noise, suggesting even at Δx ≈ 3-km resolution, small-scale MWs are underresolved and/or overdiffused. MW drag parameterizations are still necessary in NWP models at current operational resolutions of Δx ≈ 10 km. Upper GW sponge layers in the operationally configured models significantly, artificially reduced MW amplitudes in the upper stratosphere and mesosphere. In the IFS, parameterized GW drags partly compensated this deficiency, but still, total drags were ≈6 times smaller than that resolved at Δx ≈ 3 km. Meridionally propagating MWs significantly enhance zonal drag over the Drake Passage. Interestingly, drag associated with meridional fluxes of zonal momentum (i.e., ) were important; not accounting for these terms results in a drag in the wrong direction at and below the polar night jet. Significance Statement: This study had three purposes: to quantitatively evaluate how well four state-of-the-science weather models could reproduce observed mountain waves (MWs) in the middle atmosphere, to compare the simulated MWs within the models, and to quantitatively evaluate two MW parameterizations in a widely used climate model. These models reproduced observed MWs with remarkable skill. Still, MW parameterizations are necessary in current Δx ≈ 10-km resolution global weather models. Even Δx ≈ 3-km resolution does not appear to be high enough to represent all momentum-fluxing MW scales. Meridionally propagating MWs can significantly influence zonal winds over the Drake Passage. Parameterizations that handle horizontal propagation may need to consider horizontal fluxes of horizontal momentum in order to get the direction of their forcing correct.
5 August 2017 in Journal of Geophysical Research: Atmospheres
1 November 2015 in Journal of the Atmospheric Sciences
As numerical models of complex atmospheric flows increase their quality and resolution, it becomes valuable to isolate and quantify the embedded resolved gravity waves. The authors propose a spatial filtering method combined with a selection of quadratic diagnostic quantities such as heat, momentum, and energy fluxes to do this. These covariant quantities were found to be insensitive to filter cutoff length scales between 300 and 700 km, suggesting the existence of a “cospectral gap.” The gravity waves identified with the proposed method display known properties from idealized studies, including vertical propagation, upwind propagation, the relationship between momentum and energy flux, and agreement with fluxes derived from an alternative method involving simulations with and without terrain. The proposed method is applied to 2- and 6-km-resolution realistic WRF simulations of orographic and nonorographic gravity waves over and around New Zealand within complex frontal cyclones. Deep mountain wave, shallow mountain wave, jet-generated gravity wave, and convection-generated gravity wave events were chosen for analysis. The four wave events shared the characteristics of positive vertical energy flux, negative zonal momentum flux, and upwind horizontal energy flux. Two of the gravity wave events were dissipated nonlinearly.
1 December 2016 in Journal of the Atmospheric Sciences
The vertical propagation and attenuation of mountain waves launched by New Zealand terrain during the Deep Propagating Gravity Wave Experiment (DEEPWAVE) field campaign are investigated. New Zealand mountain waves were frequently attenuated in a lower-stratospheric weak wind layer between z = 15 and 25 km. This layer is termed a “valve layer,” as conditions within this layer (primarily minimum wind speed) control mountain wave momentum flux through it, analogous to a valve controlling mass flux through a pipe. This valve layer is a climatological feature in the wintertime midlatitude lower stratosphere above the subtropical jet. Mountain wave dynamics within this valve layer are studied using realistic Weather Research and Forecasting (WRF) Model simulations that were extensively validated against research aircraft, radiosonde, and satellite observations. Locally, wave attenuation is horizontally and vertically inhomogeneous, evidenced by numerous regions with wave-induced low Richardson numbers and potential vorticity generation. WRF-simulated gravity wave drag (GWD) is peaked in the valve layer, and momentum flux transmitted through this layer is well approximated by a cubic function of minimum ambient wind speed within it, consistent with linear saturation theory. Valve-layer GWD within the well-validated WRF simulations was 3–6 times larger than that parameterized within MERRA. Previous research suggests increasing parameterized orographic GWD (performed in MERRA2) decreases the stratospheric polar vortex strength by altering planetary wave propagation and drag. The results reported here suggest carefully increasing orographic GWD is warranted, which may help to ameliorate the common cold-pole problem in chemistry–climate models.