Tungsten coatings were deposited on silicon substrates by radio frequency (rf) magnetron sputtering from a metallic target in Ar atmosphere. The process parameters during the sputtering process were evaluated by a Langmuir probe, particularly, the electron density and electron temperature were measured by changing the rf power and gas pressure. The morphological and structural properties of the coatings were studied as a function of the pressure. Significant correlations were found between process parameters and characteristics properties of W coatings. The influence of deposition parameters on electrical properties was investigated. The electrical resistivity of the coatings was increased from 1.3 × 10−6 to 3 × 10−5 Ω m as the pressure increased as well.
Accident tolerant fuel (ATF) concepts are being developed to improve the safety of nuclear reactors; however, current cladding materials remain limited by degradation in high-temperature water vapor. Therefore, significant efforts are devoted to the development of protective coatings and interdiffusion barriers for Zr-based and advanced cladding systems. In this work, amorphous Cr-rich Y₂O₃ (10% Cr₂O₃) is explored as a candidate intediffusion barrier material to enhance the reliability of ATF claddings under accident-relevant conditions. The material was subjected to high temperatures in vacuum and water vapor, in situ, in a scanning transmission electron microscope, where its microstructural and compositional evolution were investigated. Under vacuum, progressive crystallization occurs from 750–800 °C, followed by Cr segregation at grain boundaries above 1000 °C. In water vapor, degradation is accelerated, with Cr loss and microstructural instability emerging above 900–950 °C. Overall, the coating remains stable up to 900 °C, supporting its potential as an interdiffusion barrier for the presented application.
Hydrogen isotope permeation through structural alloys represents a critical challenge for tritium management in fusion systems. In this work, the performance of a 1 μm thick Al₂O₃ coating deposited by Pulsed Laser Deposition (PLD) on AISI 316L stainless steel is quantitatively assessed under fusion-relevant conditions.Permeation experiments were conducted using deuterium between 400°C and 500°C and at upstream partial pressures of 100–500 Pa. A matched pristine–coated dataset enables a direct evaluation of the permeation reduction factor (PRF), yielding values between 8.6 × 10² and 2.5 × 10³, corresponding to a systematic reduction of approximately three orders of magnitude.A resistance-in-series formulation shows that the coating resistance dominates transport in all investigated conditions (Rc ≫ Rs), confirming that the film acts as a functional barrier rather than a marginal surface modification. Factorial statistical analysis of ln(PRF) indicates that pressure exerts a stronger degrading effect on barrier performance than temperature within the explored domain, while a complementary multi-level model confirms the robustness of this trend.Response surface models for permeation flux and PRF provide continuous engineering maps over temperature–pressure space. In parallel, Monte Carlo inference of the pressure exponent in ln(J)–ln(p) space reveals a transition from near bulk-controlled transport in pristine AISI 316L to surface/film-controlled behaviour in coated samples, indicating that the PLD coating fundamentally alters the rate-controlling mechanism.The proposed framework provides a transferable, uncertainty-aware methodology for the quantitative assessment of permeation barriers and supports the potential of PLD-deposited Al₂O₃ as an effective tritium permeation barrier under fusion-relevant conditions.