21 June 2019 in Journal of Reinforced Plastics and Composites
It is generally accepted that matrix pores in the hollow glass microspheres (HGMs)/resin-based composites prepared using stir-casting method (SCM) seriously affect its performance. In this paper, HGMs preforms were prepared using sintering method, and co-continuous HGMs/epoxy resin syntactic foams were prepared using vacuum resin transfer molding (VARTM) method. In order to compare how preparation method affects properties of the composites, the same volume fraction of HGMs filled epoxy resin composites was prepared by SCM. The effects of preparation methods on microstructure, density, compression properties and water absorption of composites were investigated. Compression deformation mechanism of the composites prepared by two methods is discussed. Syntactic foam with the same HGMs volume fraction contained different porosity depending on the preparation method. Porosity of the matrix in the composite prepared using SCM was ∼10 vol.%, while the densities of composites prepared by VARTM were close to the theoretical density, indicating no matrix pores. Co-continuous HGMs/epoxy resin syntactic foams prepared using VARTM showed properties superior to syntactic foams prepared by SCM: compressive strength increase by 45.31%, compressive modulus increase by 37.63%, and water absorption decrease by 69.91%. All these properties improved mainly because of the elimination of the matrix pores.
23 September 2019 in Journal of Reinforced Plastics and Composites
In this article, the co-continuous hollow glass microspheres (HGMs)/epoxy resin syntactic foams were prepared by filling the HGM preforms with epoxy resin. The effects of HGM wall thickness and solid loading on the density, open porosity, and morphology of HGM preform and HGM/epoxy resin syntactic foams were studied in detail. The results show that the HGM wall thickness had no effect on the open porosity of HGM preforms. However, the density of preforms increased with the true density of HGMs. The density of HGM/epoxy resin syntactic foams decreased with the contents of HGMs, and the measured density was essentially equal to the theoretical density. The compressive strength decreased with the contents of HGM, regardless of the HGMs wall thickness. However, the variation in compressive modulus was related to the HGMs’ wall thickness. As the HGM solid loading increased, the compressive modulus of composites, prepared using thin-walled HGMs, decreased, while the composites prepared using thick-walled HGMs showed the opposite trend. The co-continuous HGM/epoxy resin syntactic foams possessed low density (0.567–1.002 g/cm3), and excellent compressive strengths (30.32–131.60 MPa). These properties were due to the elimination of matrix pores, and are a type of promising material in deep sea exploration area.
20 December 2007 in Journal of the American Ceramic Society
1 December 2020 in Journal of Alloys and Compounds