Due to the differences between the glass and crystalline phases, crystallization of metallic glass occurs with heat release, volume shrinkage, and electrical resistivity drastic changes. Electrical resistivity of the Zr52.5Cu17.9Ni14.6Al10Ti5 metallic glass during crystallization was investigated under both continuous heating and isothermal annealing. This amorphous alloy exhibits a continuous variation instead of sharp decline when reaches the onset crystallization temperature. This unique variation was found to be related to the formation of a few quasicrystalline phases. The slower phase transformation process of this metallic glass brings lots of grain boundaries, which results in increasing of resistivity at the last stage during isothermal annealing. These results imply that electrical resistivity measurement is a more intuitive approach to investigate structure evolution of metallic glasses.
Atomic probe tomography (APT) samples with Al/Ni multilayer structure were successfully prepared by using a focused ion beam (FIB), combining with a field emission scanning electron microscope, with a new single-wedge lift-out method and a reduced amorphous damage layer of Ga ions implantation. The optimum vertex angle and preparation parameters of APT sample were discussed. The double interdiffusion relationship of the multilayer films was successfully observed by the local electrode APT, which laid a foundation for further study of the interface composition and crystal structure of the two-phase composites.
Tensile tests of GW63K (Mg-6Gd-3Y-Zr) magnesium alloy under different heat treatment conditions were performed after immersion of the test specimens in 3.5 wt.% NaCl aqueous solution for periods up to 72 h. Results indicate that pitting corrosion should be responsible for the severe degradation of the tensile properties including yield strength, tensile strength (corrosion residual strength), and elongation within the testing time. The extreme depth of the corrosion pit was statistically related to corrosion residual strength. The variation of corrosion residual strength exhibited an exponential decay trend from 0 to 72 h. Furthermore, heat treatment enhanced the corrosion resistance of the GW63K alloy by inhibiting both the initiation and growth of corrosion pits, thereby improving the corrosion residual strength of the alloy. The critical working strength of GW63K alloy was significantly improved (increased to 192 MPa from 132 MPa) via heat treatment.