27 June 2017 in Atmospheric Measurement Techniques
Radiosonde soundings from the GCOS Reference Upper-Air Network (GRUAN) data record are shown to be consistent with Infrared Atmospheric Sounding Instrument (IASI)-measured radiances via LBLRTM (Line-By-Line Radiative Transfer Model) in the part of the spectrum that is mostly affected by water vapour absorption in the upper troposphere (from 700 hPa up). This result is key for climate data records, since GRUAN, IASI and LBLRTM constitute reference measurements or a reference radiative transfer model in each of their fields. This is specially the case for night-time radiosonde measurements. Although the sample size is small (16 cases), daytime GRUAN radiosonde measurements seem to have a small dry bias of 2.5 % in absolute terms of relative humidity, located mainly in the upper troposphere, with respect to LBLRTM and IASI. Full metrological closure is not yet possible and will not be until collocation uncertainties are better characterized and a full uncertainty covariance matrix is clarified for GRUAN.
30 November 2018 in Atmospheric Measurement Techniques
The hypothesis whether turbulence within the passive microwave sounders field of view can cause significant biases in radiative transfer modeling at the 183 GHz water vapor absorption band is tested. A novel method to calculate the effects of turbulence in radiative transfer modeling is presented. It is shown that the turbulent nature of water vapor in the atmosphere can be a critical component of radiative transfer modeling in this band. Radiative transfer simulations are performed comparing a uniform field with a turbulent one. These comparisons show frequency dependent biases which can be up to several kelvin in brightness temperature. These biases can match experimentally observed biases, such as the ones reported in Brogniez et al. (2016). Our simulations show that those biases could be explained as an effect of high-intensity turbulence in the upper troposphere. These high turbulence phenomena are common in clear air turbulence, storm or cumulus cloud situations.
7 January 2026 in Atmospheric Measurement Techniques
A retrieval of total column water vapour (TCWV) from the new daytime, clear-sky near-infrared (NIR) measurements of the Flexible Combined Imager (FCI) onboard the geostationary satellite Meteosat Third Generation Imager (MTG-I, Meteosat-12) is presented. The retrieval algorithm is based on the differential absorption technique, relating TCWV amounts to the radiance ratio of a non-absorbing band at 0.865 µm and a nearby water vapour (WV) absorbing band at 0.914 µm. The sensitivity of the band ratio to WV amount increases towards the surface which means that the whole atmospheric column down to the boundary-layer moisture variability can be observed well. The retrieval framework is based on an optimal estimation (OE) method, providing pixel-based uncertainty estimates. It builds on well-established algorithms for other passive imagers with similar spectral band settings. Transferring knowledge gained in their development onto FCI required new approaches. The absence of additional, adjacent window bands to estimate the surface reflectance within FCI's absorbing channel is mitigated using a principal component regression (PCR) from the bands at 0.51, 0.64, 0.865, 1.61, and 2.25 µm. We utilize synergistic observations from Sentinel-3 Ocean and Land Colour Instrument (OLCI) and Sea and Land Surface Temperature Radiometer (SLSTR) to generate “FCI-like” measurements. OLCI bands were complemented with SLSTR bands, enabling evaluation of the retrieval's robustness and global performance of the PCR. Furthermore, this enabled algorithm testing under realistic conditions using well-characterized data, at a time when a long-term, fully calibrated FCI Level 1c dataset was not available. We built a forward model for two FCI equivalent OLCI bands at 0.865 and 0.9 µm. A long-term validation of OLCI against a single atmospheric radiation measurement (ARM) reference site without the PCR resulted in a bias of 1.85 kg m−2, centred root-mean-square deviation (cRMSD) of 1.26 kg m−2, and a Pearson correlation coefficient (r) of 0.995. A first verification of the OLCI/SLSTR “FCI-like” TCWV against well-established ground-based TCWV products concludes with a wet bias between 0.33–2.84 kg m−2, a cRMSD between 1.46–2.21 kg m−2, and r between 0.98–0.99. In this set of comparisons, only land pixels were considered. Furthermore, a dataset of FCI Level 1c observations with a preliminary calibration was processed. The TCWV processed for these FCI measurements aligns well with reanalysis TCWV and collocated OLCI/SLSTR TCWV but shows a dry bias. A more rigorous validation and assessment will be done once a longer record of FCI data is available. TCWV observations derived from geostationary satellite measurements enhance monitoring of WV distributions and associated meteorological phenomena from synoptic scales down to local scales. Such observations are of special interest for the advancement of nowcasting techniques and numerical weather prediction (NWP) accuracy as well as process-studies.
3 November 2016 in EGUsphere
Radiosonde soundings from the GRUAN data record are shown to be consistent with IASI measured radiances via the LBLRTM radiative transfer model in the part of the spectrum that is mostly affected by water vapour absorption in the upper troposphere (from 700 hPa up). This result is key to have consistency between radiosonde and satellite measurements for climate data records, since GRUAN, IASI and LBLRTM constitute reference measurements in each of their fields. This is specially the case for night time radiosonde measurements. Although the sample size is small (16 cases), day time GRUAN radiosonde measurements seem to have a small dry bias of 2.5 % in absolute terms of relative humidity, located mainly in the upper troposphere, with respect to LBLRTM and IASI.
30 July 2018 in EGUsphere
The hypothesis whether turbulence within the passive microwave sounders field of view can cause significant biases in radiative transfer modelling at the 183 GHz water vapour absorption band is tested. A novel method to calculate the effects of turbulence in radiative transfer modelling is presented. It is shown that the turbulent nature of water vapour in the atmosphere can be a critical component of radiative transfer modelling in this band. Radiative transfer simulations are performed comparing a uniform field with a turbulent one. These comparisons show frequency dependent biases which can scale up to several Kelvin in brightness temperature. These biases can match experimentally observed biases, such as the ones reported in Brogniez et al. (2016). Our simulations show that those biases could be explained as an effect of high intensity turbulence in the upper troposphere. This kind of turbulence is common in clear air turbulence, storm or cumulus cloud situations.