Irene Geijselaers

Irene Geijselaers

Auto-generated profile, based on publicly available information

Irene Geijselaers

Solid State Physics/NanoLund, Lund University 1 , Box 118, S-221 00 Lund, Sweden

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 April 2018 in Nanotechnology
Verified
Journal Article
Open access
PDF file
WMWondwosen Metaferia
Wondwosen Metaferia
SSSudhakar Sivakumar
Sudhakar Sivakumar
APAxel Persson
Axel Persson
IGIrene Geijselaers
Irene Geijselaers
LWL. Reine Wallenberg
L. Reine Wallenberg
MMMartin H Magnusson
Martin H Magnusson
Controlled doping in semiconductor nanowires modifies their electrical and optical properties, which are important for high efficiency optoelectronic devices. We have grown n-type (Sn) doped GaAs nanowires in Aerotaxy, a new continuous gas phase mass production technique. The morphology of Sn doped nanowires is found to be a strong function of dopant, tetraethyltin to trimethylgallium flow ratio, Au-Ga-Sn alloying, and nanowire growth temperatures. High temperature and high flow ratios result in low morphological quality nanowires and in parasitic growth on the wire base and surface. Alloying and growth temperatures of 400 and 530 °C, respectively, resulted in good morphological quality nanowires for a flow ratio of TESn to TMGa up to 2.25×10-3. The wires are pure Zinc-blende for all investigated growth conditions, whereas nanowires grown by MOVPE with the same growth conditions are usually mainly Wurtzite. The growth rate of the doped wires is found to be dependent more on the TESn flow fraction than on alloying and nanowire growth temperatures. Our photoluminescence measurements, supported by four-point probe resistivity measurements, reveal that the carrier concentration in the doped wires varies only slightly (1-3)×1019 cm-3 with TESn flow fraction and both alloying and growth temperatures, indicating that good morphological quality wires can be grown with uncompromised carrier density. Carrier concentrations lower than 1019 cm-3 can be grown by further reducing the flow fraction of the TESn, which may give better morphology wires.

27 December 2021 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
IGIrene Geijselaers
Irene Geijselaers
NVNeimantas Vainorius
Neimantas Vainorius
SLSebastian Lehmann
Sebastian Lehmann
CPCraig E. Pryor
Craig E. Pryor
KDKimberly A. Dick
Kimberly A. Dick
MPMats-Erik Pistol
Mats-Erik Pistol
Crystal phase defined heterostructures, or polytype heterostructures, are atomically sharp with no intermixing, which makes them ideal contenders for a wide range of applications. Although polytype quantum dots have shown promising results as single photon sources, a high degree of control on the dimensions and the number of polytype quantum dots is necessary before any application can be developed. In this work, we show results from optical characterization of highly controlled wurtzite (wz)–zinc blende (zb) GaAs quantum dots with sharp photoluminescence signal and a strong indication of 0D density of states. One band effective mass calculations show good agreement with the measured data. Radially confined nanowires with a single wz–zb GaAs interface also show sharp photoluminescence signal and 0D density of states. This indicates the existence of quantum dot like states in triangular wells formed at the wz–zb GaAs interface. These results show the potential of polytype quantum dots for physics and optics applications.

8 June 2020 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
IGIrene Geijselaers
Irene Geijselaers
SLSebastian Lehmann
Sebastian Lehmann
KDKimberly A. Dick
Kimberly A. Dick
MPMats-Erik Pistol
Mats-Erik Pistol
The quality, such as long-range correlation and mobility, of a two-dimensional electron gas (2DEG) is limited by, among other factors, interface roughness, which is inherent to the use of compositional heterostructures. Polytypic heterostructures have atomically sharp interfaces and minimal strain, decreasing the interface roughness, which may increase the mobility and long-range correlation of 2DEGs. In this work, we show the formation of a 2DEG at the wurtzite–zinc blende interface in partially n-type-doped InP nanowires using power-dependent photoluminescence. We additionally determined the wurtzite–zinc blende InP valence band offset to be 35 meV < Δ E v < 70 meV. Our results may enable the study of electron gases at interfaces, which are atomically flat over large areas.

10 December 2019 in Nanoscale
Verified
Journal Article
Open access
PDF file
RJReza Jafari Jam
Reza Jafari Jam
APAxel Persson
Axel Persson
EBEnrique Barrigón
Enrique Barrigón
MHMagnus Heurlin
Magnus Heurlin
IGIrene Geijselaers
Irene Geijselaers
HPHåkan Pettersson
Håkan Pettersson
We report on the synthesis of InP nanowire arrays on (001) InP and Si substrates using template-assisted vapour–liquid–solid growth. We also demonstrate growth of InP nanowire p–n junctions and InP/InAs/InP nanowire heterostructures on (001) InP substrates.

28 June 2018 in Nano Futures
Verified
Journal Article
Closed access
IGIrene Geijselaers
Irene Geijselaers
SLSebastian Lehmann
Sebastian Lehmann
KDKimberly A Dick
Kimberly A Dick
MPMats-Erik Pistol
Mats-Erik Pistol
The band offset between wurtzite (wz) and zinc-blende (zb) GaAs is an important fundamental parameter in polytype heterostructure engineering. Since the interface has a type-II band alignment, it is reasonably straightforward to measure the band offset using photoluminescence (PL) e.g. on nanowires containing heterostructures between wz and zb GaAs. It has, however, been found that the transition energy in such heterostructures depends on the diameter of the nanowires which introduces uncertainties in the determined value of the band offset. In order to extract a more accurate value and to further elucidate the diameter-dependent behavior of the transition energy we have performed PL studies on a large set of GaAs nanowires. Those nanowires have different diameters and contain one wz–GaAs segment embedded in otherwise zb–GaAs. We have also studied the effect of a passivating capping layer of AlAs on the determined band offset. We find that our data is well explained by a diameter-dependent radial band bending in the nanowires. Combining modeling of the band bending with the experimental data we extract a band offset of about 125 meV and a p-type doping concentration of 10 16 cm −3 . Our results will improve the accuracy of future modeling of the electronic properties of wz–zb GaAs heterostructures and other engineered polytypic materials.