3 November 2022 in IEEE Antennas and Wireless Propagation Letters
This paper presents a design approach for a defected ground structure (DGS) based wideband circular microstrip patch antenna using the characteristic mode analysis (CMA). It emphasizes improving two design aspects: cross-polarization reduction and bandwidth enhancement. The CMA unveils the intrinsic characteristic modes in the patch and ground plane, and then undesired modes are suppressed using a DGS, reducing cross-polarized radiations. Another defect, strategically incorporated into the same DGS, enhances a higher-order non-radiating mode to radiate and increases bandwidth. The proposed design fabricated on an FR-4 substrate achieves a $\simeq$ 16% impedance bandwidth (5.7–6.7 GHz) with dimensions $0.8\lambda _{0}\times 0.8\lambda _{0}\times 0.03\lambda _{0}$ ( $\lambda _{0}$ being the free-space wavelength at 6 GHz) and 10–15 dB average cross-polarization reduction at $\pm$ 60° angle of boresight. The measured results from a fabricated prototype agree well with the proposed design.
9 March 2020 in Journal of Electrical Engineering & Technology
29 June 2020 in IET Microwaves, Antennas & Propagation
This study proposes an ultra‐wideband (UWB) metasurface‐based beam‐switching antenna system. A coplanar (CP) waveguide fed slot antenna (with 49% operating bandwidth) is coupled with a hexagonal metallic aperture to generate CP beam in the 10.2–10.8 GHz band. An octagonal split ring inclusion‐based meta‐element is designed to achieve 2π transmission phase variation with near‐unity magnitude. The principle of the Pancharatnam–Berry metasurface is used to design an offset metasurface superstrate for tilting the main beam of the UWB antenna for the CP band. Measured results ( S 11 , axial ratio, and radiation pattern) agree well with full‐wave simulations. The fabricated X‐band UWB aperture coupled antenna system uses the metasurface superstrate to achieve a broadside beam for the lower band and tilted beam for the upper band. This antenna system holds promise for next‐generation vehicular and satellite communication applications.
7 January 2025 in IEEE Access
This paper introduces a novel quadruple-mode excited low-profile metasurface (MTS)-based broadband circularly polarized (CP) patch antenna. For a quadruple-mode excitation, the antenna uses a unique pac-man shaped patch (PSP) as the primary CP radiator and above it a 4×4 sized rectangular MTS, which acts as the secondary radiator. Characteristic mode analysis (CMA)-based mode manipulation approach facilitates effortless separation of two orthogonal modes (OMs) of PSP, creating a 90° phase difference for circular polarization. Further, to increase the design’s axial ratio bandwidth (ARBW), two additional OMs of the MTS layer are cascaded with the PSP modes. Consequently, the four OMs exhibit quadruple-mode excitation, and the design achieves broadband CP radiation. A prototype of the proposed antenna is fabricated using an FR-4 substrate, and the overall dimension of the antenna is 0.55λ×0.7λ×0.06λ at 6.46 GHz center operating frequency. The 10 dB impedance bandwidth of the antenna is 55.22% (4.68–8.25 GHz), and the 3 dB ARBW is 35.48% (5.1–7.3 GHz). The antenna exhibits a consistent gain over the entire operating bandwidth with a peak gain of 6.2 dBi. The measurement results agree well with the simulation results.
1 January 2018 in Progress In Electromagnetics Research M
RMRabindra Kishore Mishra
15 November 2018 in International Journal of RF and Microwave Computer-Aided Engineering
RMRabindra Kishore Mishra
The article presents a microstrip patch (MSA) fed high gain circularly polarized metasurface cavity (CP‐MSC) antenna using a planar progressively‐phased‐reflector and a transmissive linear to circular polarization conversion metascreen. The bottom metasurface reflector consists of a remodeled Jerusalem cross to obtain 2π reflection phase variation. Linear to circular polarization conversion is achieved by a hexagonal ring based meta‐element with high transmission and bellow 3 dB axial ratio from 9.5 to 10.5 GHz. Simulated and measured results of assembled CP‐MSC antenna with MSA are in good agreement. The gain of the proposed cavity antenna with 10 and 10.5 GHz MSA are 14.9 and 16.3 dBi, respectively. Below 3 dB AR throughout the operating band denotes significant circular polarization performance of the proposed antenna.