Graphene nanoparticles (GnP) were selected as an alternative reinforcing nanofillers, which enhances the mechanical properties of polypropylene (PP-homo and PP-block copolymer). It may play the role of compatibilizer in polypropylene-graft-maleic anhydride (PP-g-MA) from a double-screw extruder. The effect of GnP loading and the use of the PP-g-MA compatibilizer were studied. The influence on the mechanical properties of tensile strength, elongation at break, IZOD impact strength, and melting temperature in PP-homo and PP-block copolymer were investigated and compared. Their improvement was observed at to a certain amount of 0.3% (by mass) of GnP depending on the substrate nature: homopolymer or block copolymer. The increase from 69.3 J.m-1 to 176.0 J.m-1 corresponds to a 2.5 times rising in IZOD impact resistance for block copolymer. The PP block copolymer has a significant affinity in respect of the presence of graphene and the compatibilizer due to the elastomeric co-monomer present in the block copolymer.
Plastic waste contributes negatively to the environment by increasing space occupation, creating health hazards on land, in the air, and at sea. For this reason, they need to be disposed of properly so that they can be recycled efficiently. To combat these impacts and reduce environmental pollution, this project aims to study the recycling process of polypropylene (PP) from industrial waste scraps and polypropylene from urban solid waste (MSW) using ionizing radiation from 0 to 500 kGy. Irradiation processing showed efficiency when compared to other recycling processes, promoting the molecular shearing of PP, reaching ideal lengths of shorter chains to be used as a carrier for additives for adhesives and plastics, and/or to be used as a flow modifier for injecting parts. Ionizing radiation above 100 kGy initiated the formation of cross-links, cross-linking the PP that could be used as fillers for asphalt, construction, and other applications, or as a fuel energy source, contributing to the ecosystem, without changes in the curly lettuce after ecotoxicity tests. The use of ionizing radiation in polymer processing has a great advantage when compared to other plastic recycling systems.
In this study, polyamide 6 (PA 6), polyamide 6.6 (PA 6.6), and polypropylene (PP) polymers were irradiated with an e-beam (EB) (100 and 200 kGy doses, 100 kGy.s-1 dose rate, at room temperature) to evaluate the effects on radiochemical crosslinking. Mechanical analyses (tensile, flexural, and tribological tests), thermal characterizations (TGA, DSC, and glow wire test), and FTIR spectroscopy were performed. Results demonstrated that PA 6.6 irradiated at 200 kGy exhibited a 6.8% increase in tensile strength at break, being the only material showing improvement in yield point. All samples displayed reduced elongation after irradiation. In flexural resistance tests, both irradiated PA 6 and PA 6.6 showed enhanced properties, while in tribological evaluations, only PA 6.6 (100 kGy) presented a reduced friction coefficient. Thermal analyses revealed that irradiated PA 6.6 showed increased onset degradation temperature, while all polymers exhibited decreased melting temperature. The crystallinity percentage increased in both irradiated PA 6.6 and PP, and only PA 6.6 (200 kGy) resisted all temperature levels in the glow wire test. It was concluded that PA 6.6 demonstrated superior post-irradiation performance, showing more enhanced properties compared to PA 6 and PP.