27 May 2021 in IEEE Transactions on Nuclear Science
A feedback control system has been designed for Keda Torus eXperiment (KTX) to achieve the following goals: 1) 3-D plasma stability control and 2) improvement of plasma discharge quality. The real-time electronics system which is the key unit of this feedback control system helps to resolve the lack of high-speed transmission and real-time processing capability of the previous data acquisition (DAQ) system. The electronics system is implemented in PXI Express using a modular, distributed architecture. Field-programmable gate array (FPGA) is the core component of the electronics system. This article describes in detail the reasons for the choice in the hardware components. Optical communication has been evaluated for real-time communication by using the Aurora protocol. Measurements have been executed on a prototype system. Results from several tests comparing the performance of different solutions are also provided. 2-D spatial Fourier analysis based on FPGA is first used on the reversed field pinch (RFP) fusion device. Results indicate that the system can control the whole process and calculation in low latency.
27 September 2024 in IEEE Transactions on Nuclear Science
The Keda Torus eXperiment (KTX) is a reversed field pinch (RFP) magnetic confinement device located in China. Due to the non-ideal conductivity of the copper shell and the presence of a toroidal gap, KTX is susceptible to magnetohydrodynamic (MHD) instabilities and error fields, which can significantly degrade plasma discharge quality. To actively control these MHD instabilities, we developed a real-time feedback control system based on LabVIEW-FPGA. This system is integrated into the active control feedback electronic system (ACFES). It combines hardware for data acquisition, processing, and aggregation with a corresponding software platform to analyze real-time MHD instability modes in KTX. The system subsequently transmits active control feedback signals to the KTX digital power supply array, generating a compensating magnetic field to mitigate MHD instability. Experimental results demonstrate that our system effectively extends the discharge duration of KTX.
19 May 2025 in IEEE Journal of Emerging and Selected Topics in Power Electronics
As the current step and slew rate of microprocessors increase, greater demands are placed on transient responses of voltage regulator modules (VRMs). In this article, a switched capacitor auxiliary circuit (SCAC) is proposed to enhance transient responses of VRMs. One end of the switched capacitor is connected to the VRM output voltage Vo, whereas the other end has a variable Voltage. When the load current changes, the switched capacitor’s variable end Voltage is adjusted, enabling rapid charge injection and absorption, thereby reducing Vo undershoot and overshoot. As a demonstration, a field programmable gate array (FPGA)-controlled SCAC prototype is implemented at the output of a 12V-0.9V 14-phase VRM. Transient tests are conducted with a load current step of 480 A, slew rate of 960 A/μs, and load current variable frequencies of 300 Hz to 1 MHz. The maximum overshoot and undershoot of the VRM were reduced from 190 mV to 95 mV and 142 mV to 80 mV, respectively, by implementing the SCAC, reducing the transient Vo change by 43%.