Surface lattice reconstruction is commonly observed in nickel-rich layered oxide battery cathode materials, causing unsatisfactory high-voltage cycling performance. However, the interplay of the surface chemistry and the bulk microstructure remains largely unexplored due to the intrinsic structural complexity and the lack of integrated diagnostic tools for a thorough investigation at complementary length scales. Herein, by combining nano-resolution X-ray probes in both soft and hard X-ray regimes, we demonstrate correlative surface chemical mapping and bulk microstructure imaging over a single charged LiNi0.8Mn0.1Co0.1O2 (NMC811) secondary particle. We reveal that the sub-particle regions with more micro cracks are associated with more severe surface degradation. A mechanism of mutual modulation between the surface chemistry and the bulk microstructure is formulated based on our experimental observations and finite element modeling. Such a surface-to-bulk reaction coupling effect is fundamentally important for the design of the next generation battery cathode materials.
The magnetic moment and the magnetic order induced by localized defects, like vacancies, interstitials, and/or nonmagnetic (NM) ions, in a NM oxide atomic lattice are discussed. When the defect concentration is of the order of or larger than ≈3 at%, magnetic order at room temperature can appear. Herein, the theoretical basic principles needed to understand and compute this new magnetic phenomenon in solids are developed in detail. In particular, the main results of density functional theory (DFT) calculations are used to estimate the magnetization and X‐ray magnetic circular dichroism (XMCD) values. The main experimental evidences on this phenomenon are reviewed, especially magnetization, the element‐specific XMCD, and transport properties in two selected oxides, ZnO and TiO2. Emphasis is given on the simplicity and efficiency ion irradiation methods have to trigger magnetic order in these oxides as well as a very sensitive method to characterize magnetic impurities. Two possible applications of this phenomenon are discussed, namely spin filtering at magnetic/NM interfaces in ZnO and perpendicular magnetic anisotropy triggered in TiO2 anatase microstructures. The existing literature on defect‐induced magnetism in oxides is shortly reviewed, which provides further evidence on the robustness of this phenomenon in solids.
A non-standing characteristic of directly imaged spin-waves in confined micrometer-sized ultrathin Permalloy ( ) structures is reported along with evidence of the possibility to alter the observed state by modifications to the sample geometry. Using micromagnetic simulations, the presence of the spin-wave modes excited in the Permalloy stripes along with the quasi-uniform modes was observed. The predicted spin-waves were imaged in direct space using time resolved scanning transmission x-ray microscopy, combined with a ferromagnetic resonance excitation scheme (STXM-FMR). STXM-FMR measurements revealed a non-standing characteristic of the spin-waves. Also, it was shown by micromagnetic simulations and confirmed using STXM-FMR results that the observed characteristic of the spin-waves can be influenced by the local magnetic fields in different sample geometries.
Spin pumping in a ferromagnet-nonferromagnet heterostructure is directly imaged with spatial resolution as well as element selectivity. The time-resolved detection in scanning transmission x-ray microscopy allows us to directly probe the spatial extent of the ac spin polarization in Co-doped ZnO, which is generated by spin pumping from an adjacent permalloy microstrip. Comparing the relative phases of the dynamic magnetization component of the two constituents is possible and found to be close to antiphase. The correlation between the distribution of the magnetic excitation in the permalloy and the Co-doped ZnO reveals that laterally there is no one-to-one correlation. The observed distribution is rather complex, but integrating over larger areas demonstrates that the spin polarization in the nonferromagnet extends laterally beyond the region of the ferromagnetic microstrip. Therefore, the observations are better explained by a local spin pumping efficiency and a lateral propagation of the ac spin polarization in the nonferromagnet over the range of a few micrometers.
Magnetic nanoparticles have proven invaluable for biomechanical investigations due to their ability to exert localized forces. However, cellular delivery of exogenous magnetic agents often results in endosomal entrapment, thereby limiting their utility for manipulating subcellular structures. This study characterizes and exploits fully genetically controlled biomineralization of iron‐oxide cores inside encapsulin nanocompartments to enable magnetic‐activated cell sorting (MACS) and magnetic cell manipulation. The fraction of MACS‐retained cells showed substantial overexpression of encapsulins and exhibited both para‐ and ferrimagnetic responses with magnetic moments of 10−15 A m2 per cell, comparable to standard exogenous labels for MACS. Electron microscopy revealed that MACS‐retained cells contained densely packed agglomerates of ≈30 nm iron oxide cores consisting of ultrafine quasicrystalline ordered nuclei within an amorphous matrix of iron, oxygen, and phosphorus. Scanning transmission X‐ray microscopy, X‐ray absorption spectroscopy, and Raman microspectroscopy confirmed that the iron‐oxide species are consistent with ferric oxide (Fe2O3). In addition, the encapsulin‐overexpressing MACS‐retained cells can be manipulated by a magnetic needle and regrown in patterns determined by magnetic gradients. This study demonstrates that the formation of quasicrystalline iron oxide with mixed para/ferrimagnetic behavior in the cytosol of mammalian cells enables magnetic manipulation without the delivery of exogenous agents.