Olga Shanina

Olga Shanina

Auto-generated profile, based on publicly available information

Olga Shanina

Kharkiv Petro Vasylenko National Technical University of Agriculture, Department of Technologies of Processing and Food Industries, Alchevsky Str. 44, 61002, Kharkiv, Ukraine, Tel.: +380509103205

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 January 2019 in Potravinarstvo Slovak Journal of Food Sciences
Verified
Journal Article
Open access
PDF file
OSOlga Shanina
Olga Shanina
IGIvan Galyasnyj
Ivan Galyasnyj
TGTetyana Gavrysh
Tetyana Gavrysh
KDKateryna Dugina
Kateryna Dugina
YSYuriy Sukhenko
Yuriy Sukhenko
NSNatalia Slobodyanyuk
Natalia Slobodyanyuk
The article is devoted to the study of the influence of hydrocolloids and animal protein concentrates on the formation of the foam-like structure of gluten-free non-yeast dough as the main factor for bread quality formation. The use of CMC in a concentration of 0.5% is found to be appropriate. The bread volume increases to 236 cm3.100g-1 in comparison with the control sample in water – 202 cm3.100g-1. It is proved that the suggested additives in the amounts of 0.5 ‒ 1.0% Helios-11 and 0.5% CMC solution cause 100% resistance of egg white foam. In this case, the foaming ability increases with the addition of Helios-11 only in amounts up to 1.0%, then decreases for higher amounts of Helios-11 or in the presence of CMC. This can be explained by the increase in density of the whipping mass and the ability of both additives to thicken solutions. In the presence of the additives, the foamy texture of the dough changes. The number of large pores (0.7 – 1.5 mm) decreases almost fourfold, and the number of small and very small pores (0.1 ‒ 0.5 mm) increases significantly. The index of form resistance of the control sample is 32, and in the presence of 0.5% CMC with 0.5 ‒ 1.0% APC is 20 ‒ 21, which indicates a decrease in the surface tension of the aqueous solutions with additives, to a large extent, in the case of joint use.

28 April 2020 in Potravinarstvo Slovak Journal of Food Sciences
Verified
Journal Article
Open access
PDF file
OSOlga Shanina
Olga Shanina
SMSergii Minchenko
Sergii Minchenko
TGTetyana Gavrysh
Tetyana Gavrysh
YSYuriy Sukhenko
Yuriy Sukhenko
VSVladyslav Sukhenko
Vladyslav Sukhenko
TRTatyana Rozbytska
Tatyana Rozbytska
Development and introduction of high quality gluten-free products is one of the priorities of food industry. Feasibility of producing gluten-free steamed bread based on rice and corn flour using flaxseed, sunflower, sorghum and quinoa flour additives is proved in the article. Recommended ratios of flours are established: Frc:Ffs 95:5, Frc:Fsn 95:5, Fcn:Fqn 85:15, Fcn:Fsg 90:10. The parameters of dough kneading are studied and the influence of additives on relative elasticity, plasticity and resilience is established. Use of additives leads to a decrease in irreversible relative deformation of dough for 36 – 68% and relative plasticity for 16 – 18%, to increase of its elasticity relative resilience up to 2.3 times. Dough fermentation process is investigated. It is established that amount of carbon dioxide accumulated in gluten-free dough increases by 10 – 30%. Process of acid accumulation during fermentation is studied. A flow chart for the production of gluten-free steamed bread is proposed. The parameters for the production of gluten-free steamed bread were established and justified. Product is prepared in a single-phase method, adopted in practice of baking bread. The duration of dough mixing is 10 – 15 min, fermentation 20 – 35 min. Steam treatment is carried out under atmospheric pressure. Recommended steam processing time is 35 min for bread based on rice flour, 30 min for based on corn flour. In comparison with the traditional technological scheme, it is recommended to use a double boiler instead of an oven.

28 July 2020 in Potravinarstvo Slovak Journal of Food Sciences
Verified
Journal Article
Open access
PDF file
Leonora AdamchukLeonora Adamchuk
Leonora Adamchuk
VSVladyslav Sukhenko
Vladyslav Sukhenko
OAOleksandra Akulonok
Oleksandra Akulonok
TBTetiana Bilotserkivets
Tetiana Bilotserkivets
VVVolodymyr Vyshniak
Volodymyr Vyshniak
IGIvan Galyasnyj
Ivan Galyasnyj
The demand for monofloral, original, and special (functional) kinds of honey, or those with geographical indication, is forecast. At the same time, there is a need to improve the methods for determining the botanical and geographical origin of honey. The purpose of the research was to select and apply a variety of techniques for identifying the botanical origin of honey for its correspondence to acacia species. Samples of honey from the Kyiv, Odesa, and Dnipro regions extracted in the spring and summer period were used in the research. Organoleptic, physicochemical, NMR spectrometry, and advanced melissopalynology methods were applied. The tests were carried out at the laboratories of the Department of Certification and Standardization of Agricultural Products, NULES, Ukraine; the Ukrainian Laboratory of Quality and Safety of Agricultural Products; and the Bruker BioSpin GmbH company (Germany). According to the research results, the requirements for acacia honey were met by the organoleptic method for samples B1 and B2; by the physicochemical method for A0 and A2; by NMR spectroscopy for not a single sample, all being assessed as polyfloral; and by pollen analysis for B1 and B2. The conducted studies confirm the need for a comprehensive approach to the identification of the botanical origin of honey for its conformity to acacia species. There is a need to review the physicochemical indicators for the compliance of honey with the acacia species obtained in Ukraine. After all, even the modern NMR spectrometry technique indicated that the specially fabricated sample that did not contain acacia pollen grains was acacia honey. Identification of the botanical origin of monofloral honey, in particular acacia, should be carried out in the following sequence: pollen analysis (by dominant pollen grains), safety (presence of antibiotics, pesticides), physicochemical parameters according to international requirements, organoleptic parameters.

28 August 2020 in Potravinarstvo Slovak Journal of Food Sciences
Verified
Journal Article
Open access
PDF file
KSKyrylo Samoichuk
Kyrylo Samoichuk
DZDmytro Zhuravel
Dmytro Zhuravel
NPNadiya Palyanichka
Nadiya Palyanichka
VOVadim Oleksiienko
Vadim Oleksiienko
SPSerhii Petrychenko
Serhii Petrychenko
VSVladyslav Sukhenko
Vladyslav Sukhenko
Homogenization is a necessary process in the production of drinking milk and most dairy products. The specific energy consumption of the most common valve homogenizers reaches 8 kW h.t-1. A promising way to reduce it is the introduction of more effective counter-jet homogenizers. The purpose of these studies is to increase the efficiency of machines of this type through fuller use of their kinetic energy. To achieve this, the design of a ring reflector was developed and experimental studies were carried out to determine its influence on the efficiency of milk fat dispersion in a counter-jet homogenizer. Calculations were made to determine the reflector’s design parameters. An installation for experimental research has been developed, in which the required milk pressure is created with the help of compressed carbon dioxide. The dispersive indices of the milk emulsion were determined by computer analysis of milk sample micrographs obtained with an optical microscope and a digital camera using Microsoft Office Excel and Microsoft Visual Studio C# software using the OpenCV Sharp library. As a result of research, the formula for defining the angle of the reflector top has been determined analytically. Experimental studies proved its validity and allowed determination of the optimal diameter. A comparison of the dependence of the degree of homogenization on the excess pressure in a counter-jet homogenizer proves a 15 – 20% increase in the degree of dispersion when using a reflector. At the same time, specific energy consumption does not increase. Comparison of the distribution curves of milk fat globules by size after counter-jet homogenization and homogenization with a reflector suggests that the average diameter of fat globules for the experimental method decreases from 0.99 to 0.83 μm. This indicates the high quality of the dispersal characteristics of the milk emulsion after processing in a counter-jet homogenizer with a reflector.

31 October 2022 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
FMFarrukh Makhmudov
Farrukh Makhmudov
САСана Азимова
Сана Азимова
MKMaigul Kizatova
Maigul Kizatova
AIAuyelbek Iztayev
Auyelbek Iztayev
OSOlga Shanina
Olga Shanina
The objects of this study were wheat grain (Shortandinskaya variety, harvest 2021) and wheat grain grinding products – whole grain (whole-ground) wheat flour of coarse, medium, and fine grinds. Studies have been carried out to establish the terms of safe storage of whole-grain (whole-ground) wheat flour of various sizes. Samples of whole-grain flour of coarse, medium, and fine grinding were obtained by grinding wheat grain in a finger-type single-rotor eight-row disintegrator. The resistance to storage of samples of whole-grain wheat flour of various sizes, as well as treated with gases (nitrogen, carbon dioxide) with a concentration of 2.0 mg/l, at a pressure of P=2.0 atm for 10 minutes, was investigated. Based on the indicators of QMAFAnM, the acid number of fat, and the acidity of gas-processed and unprocessed whole-grain wheat flour of various sizes, the terms of its safe storage were established. All safety indicators were examined within three months with a frequency of every 10 days. The relationship between the size of the flour product and its stability during storage has been established. It is recommended to store unprocessed whole grain wheat flour of coarse grinding up to 50 days, medium grinding – up to 40 days, fine grinding – up to 30 days. The treatment of whole-grain flour before storage with carbon dioxide has made it possible to prolong the period of safe storage of coarse flour to 70 days, medium grinding – up to 50 days, fine grinding – up to 40 days. The best results in the preservation of whole-grain flour, depending on the size of the grind, were shown by its treatment before storage with nitrogen in comparison with similar treatment with carbon dioxide. Nitrogen treatment has made it possible to recommend the duration of safe storage of coarse flour up to 90 days, medium – up to 60 days, small – up to 50 days

17 February 2023 in Grail of Science
Verified
Journal Article
Open access
PDF file
КCКарина Cвідло
Карина Cвідло
ОШОльга Шаніна
Ольга Шаніна
ЛМЛюдмила Мамченко
Людмила Мамченко
ЛПЛідія Піддубна
Лідія Піддубна
Сучасні дослідження функціональних можливостей організму військовослужбовців Збройних Сил та інших військових формувань України в зоні бойових дій, а також лікування та реабілітації поранених підтверджують необхідність удосконалення раціонального харчування.  Найбільш ефективним лікувально-профілактичним засобом є харчові продукти, біокомпоненти яких здатні мобілізувати природні захисні сили організму і захистити організм військового, оптимізуючи його функціональний стан. Прикладом такої продукції є розроблений авторами новий вид молочних напоїв на основі концентрату сироваткового білку, отриманий шляхом ультрафільтрації (КСБ-УФ) і природних сировинних комплексів.