19 December 2019 in International Journal of Energy Research
11 May 2021 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Addition of Al2O3 nanoparticles into paraffin wax is beneficial to improve the thermal conductivity of paraffin wax. Moreover, it has effect on the other thermophysical properties of paraffin wax such as the thermal diffusivity and volumetric heat capacity. In the present paper, the two-step method was used to prepare the nanofluids of Al2O3 nanoparticles and paraffin wax and then the influence of temperature and volume fraction of Al2O3 nanoparticles on the thermal conductivity, thermal diffusivity, and volumetric heat capacity of the nanofluids was investigated. The experimental results show that the changing trend of the above-mentioned properties of Al2O3/paraffin shows a slight regularity with increasing temperature. The thermal conductivity of nanofluids is enhanced at 20°C, and the largest thermal conductivity attained is 0.38 W/m·K at the volume fraction of 0.01%, which led to 40% augmentation, compared with paraffin. The thermal diffusivity of nanofluids with the volume fraction 0.01%, 0.1%, and 1% varies by −31%, 13.5%, and −21% in solid state, respectively. Moreover, the volumetric heat capacity fluctuates with the increase in temperature, and the volumetric heat capacity of nanofluids with the volume fraction 0.01% and 0.1% is higher than that of 1% in liquid state.
24 May 2021 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
In this study, a multi-physics coupled mathematical model was established on thermal stress distribution of double-glazed units with phase-change material (PCM-glazed) for the transient temperature fields and non-uniform intermittent solar irradiation, and the mathematical calculations are in good agreement with the experimental results, which shows that the developed model in present work can solve the coupled thermal stress distribution problem between phase change and intermittent solar irradiation in the PCM-glazed. A case that is the thermal stress distribution on the surface of glazed unit filled with paraffin under the outdoor variable temperature and non-uniform intermittent solar irradiation was studied in autumn in cold region of China. The results show that the stress produced on the surface of glazed unit filled with paraffin varies obvious, PCM layer between the glass panes significantly affects the stress values at different time, which can, respectively, reach up to about 4.59MPa and down to −3.9MPa for tensile and compressive strains once the paraffin in liquid state, due to improved thermal conductivity of PCM throughout phase transition to liquid. Additionally, the frame is the key factor causing temperature gradient of PCM-glazed unit, and the biggest tensile stress appears at the edge. The influence range of the frame on the surface temperature and stress of the PCM-glazed unit is limited and different, and the largest influence distance of the surface temperature and stress from the edge is 0.1 m and 0.03 m, respectively.