3 January 2019 in Advances in Civil Engineering
Timber buildings might incur damages after a long service, because column foot damage affects the structural performance under the continued use. In this paper, six straight‐tenon joint wood frame specimens were prepared with varying degrees of two different damage conditions at a scale of 1 : 3.52. To obtain failure mode and hysteresis performance of the specimens, the low‐cycle reciprocating loading test was conducted. The stiffness degradation curves and equivalent viscous damping curves of the damaged wood frames were also analysed. The mechanical characteristics of the wood frames with column foot damage under the low‐cycle reciprocating load were then simulated using the finite element method, and the results were compared to the test results. It is determined that as the degree of column foot damage increases, the fullness and peak of the hysteresis curves for wood frames, the equivalent viscous damping coefficients, and the overall seismic behaviour of the wood frame all gradually decrease. The skeleton curves obtained by finite element analysis and tests showed good agreement, verifying the influence of column foot damage on the seismic behaviour of ancient wood frame structures.
20 February 2015 in Earthquake Engineering and Engineering Vibration
8 October 2018 in Mathematical Problems in Engineering
Vibration responses of building structure closely related to the structural health status. In this paper, wavelet singular spectrum entropy (WSSE) is proposed to evaluate the damage condition of building structure. A 1/3 scaled model of a Chinese ancient timber structure has been constructed, and three damage conditions and one restored condition of the structure are simulated. The acceleration responses for undamaged and the four simulated damaged and restored conditions are measured and analyzed by employing WSSE to identify the location at which the structure has incurred damage. Results show that (1) the relative variation rate of WSSE for the damaged position changes significantly; (2) the relative variation rate of WSSE of the point that is damaged more severely would become higher; and (3) signals of North-South and East-West directions are required for further identification. Moreover, a finite element modeling analysis of the timber structure under different damage conditions is performed, and the results verify the applicability of the method proposed.
29 October 2022 in Journal of Seismology
19 September 2025 in Journal of Seismology
1 January 2019 in Advances in Civil Engineering
The time‐averaged shear wave velocity (SWV) to 30 m (VS30) is a site condition parameter that has been widely used to specify the site class in building codes. However, the penetration depth of some building sites is less than 30 m, and thus, VS30 cannot be determined based on the velocity profiles. To estimate the site parameter VS30 accurately, we examined the effect of the velocity structural characteristic parameter of site profiles, βH, on VS30 by performing a residual analysis. Further, a method to estimate VS30 was established considering the effect of βH, and the validity of the proposed model was assessed based on site data pertaining to Japan and California (USA). The results show that the time‐averaged shear wave velocity to the depth H (H < 30 m), VSH, is weakly correlated with the parameter βH. However, βH has a significant effect on VS30; for the same site VSH, VS30 tended to increase with βH. Compared with the extrapolation method, the proposed model can significantly reduce the standard deviation for the estimation of VS30, while increasing the correlation between the estimated and measured values of VS30. Thus, the estimation accuracy can be significantly improved by considering the effect of βH.