The presence of tetracycline (TC) antibiotics was determined in animal feed that had been previously screened with a microbiological plate test. Feed samples were screened by a microbiological plate test on a pH 6.0 culture medium seeded with Bacillus cereus ATCC 11778 able to pre-reveal the presence of tetracyclines. Subsequently, confirmation and quantification were performed using a validated HPLC method with mass spectrometric detection. In 2013–2018, 353 feed samples were analysed to detect antibacterial substances, of which 186 (52.7%) were suspected to contain tetracyclines. Forty-two out of 186 (22.6%) samples analysed by the chromatographic method contained undeclared tetracyclines, which were determined at concentrations from 0.3 to 49 mg kg−1. The most frequently identified contaminating tetracyclines were doxycycline and chlortetracycline.
Animal by-products result mainly from the slaughter of animals for human consumption, the production of products of animal origin (such as dairy products), the disposal of dead animals, and disease-control measures. Regardless of their source, they pose a potential risk to public and animal health and the environment. This risk needs to be adequately controlled, either by safe disposal of such products, or by their utilization, provided that strict conditions are maintained to minimize the health risks involved. Animal by-products are classified into categories that reflect the level of risk to public and animal health arising from those by-products (Cat. 1, 2 and 3). According to Commission Regulation (EU) No 142/2011, in processing plants for the processing of Category 1 or 2 material, derived products shall be permanently marked with glycerol triheptanoate (GTH). The minimum content of marker in target materials is 250 mg/kg of fat. For the determination of glycerol triheptanoate in dry meat, bone meals, rendered fat and soil adjuvants, gas chromatography technique and mass spectrometry detection are used
Introduction: Whole dead animals, parts of dead animals, products of animal origin or other products derived from animals that are not intended for human consumption are animal by-products, and legislation imposes restrictions on the use of those which may pose a risk to the food and feed chain. High-risk products should only be used outside the feed chain. Unsafe by-products are distinguished from safe ones, parcel by parcel, and those with the highest harm potential are permanently marked during processing with glycerol triheptanoate (GTH) to prevent their entry into the feed chain. The legislated minimum content of this marker must be 250 mg/kg of fat. This research is on the development and validation of methods using gas chromatography with flame ionisation or with mass spectrometry for GTH detection, and also comprises a report of compliance with the GTH content threshold among samples of animal by-products. Material and Methods: Between 2010 and 2024, 2,303 samples of meat and bone meal, rendering fat, processed animal protein, soil improvers, antioxidants, feed materials and mixtures, dog chews, feathers, bird balls and unknown material of animal origin were tested. Gas chromatography was used with either flame ionisation detection or mass spectrometry. Results: Samples that did not meet the requirements under applicable law accounted for approximately 10.5% (240 samples). The highest percentage of non-compliant samples was recorded in the processed animal proteins group (20.7%). Incorrectly marked meat and bone meal and rendered fat accounted for 8% and 12% of their groups, respectively. Conclusion: Nearly 90% of the samples tested were correctly marked with GTH as required or free of it, which may indicate progress in developing effective marking technology at processing plants.
Introduction: To monitor the occurrence of antibiotics in feed, a two-step control strategy is often adopted of screening by microbiological inhibition followed by confirmation by chromatographic techniques. This study is devoted to the development of a reliable method for simultaneous determination of lincomycin, spiramycin, tylosin and tiamulin in animal feed using liquid chromatography coupled to mass spectrometry after a microbial assay. Material and Methods: The analytes were extracted from feed using a methanol:water mixture, and solid-phase extraction was employed for the isolation of the antibiotics. The determination of the presence of lincomycin, spiramycin, tylosin and tiamulin was carried out using high-performance liquid chromatography with mass spectrometry. Results: The method was validated according to EU requirements. The decision limit and detection capability were 0.213–0.318 and 0.259–0.535 mg kg −1 , respectively, and the limits of detection and quantification were 0.029–0.151 and 0.069–0.223 mg kg −1 , respectively, depending on the analyte. Recoveries were satisfactory (86.6–105.1%), repeatability ranged from 2.6 to 18.3% and reproducibility from 6.2 to 11.7%. Conclusion: The proposed method is reliable and applicable to identify four antibiotics for feed-safety control.