With continuous improvements in the superconducting performance and technical maturity, High Temperature Superconductors (HTS) are believed to meet the challenges of future fusion magnets. The Institute of Plasma Physics Chinese Academy of Sciences (ASIPP) has been designing several types of high current REBCO Conductor On Round Core (CORC) Cable-In-Conduit Conductors (CICCs) for use in Central Solenoid (CS) magnet of a next-generation tokamak device. One preferred structure of CICC consists of six CORC sub-cables embedded in the spiral grooves of a copper structural part. This CICC, rated for 45 kA at 4.2 K and 20 T, is subjected to great electromagnetic forces. Compared with stainless steel, copper has better thermal conductivity but poorer mechanical performance. Therefore, the mechanical robustness of conductor in low temperature and electromagnetic environment needs to be evaluated. In this paper, the mechanical analyses of this conductor is performed by Finite Element Method (FEM), and the effect of pitch on conductor stress is analyzed. These results will provide mechanical information for selecting the relatively suitable conductor scheme.
29 March 2022 in IEEE Transactions on Applied Superconductivity
The jacket of cable in conduit conductor (CICC) is the primary component to bear the high electromagnetic load during operation. This function creates requirements for high mechanical properties such as strength and toughness at cryogenic temperature, especially for the high field magnets application. Due to its high yield strength of beyond 1300 MPa at cryogenic temperature, the austenitic stainless steel N50 is considered as one of the promising material for fabricating the conduit for high field magnets application. But during magnets manufacturing, the jacket shall experience critical processes, such as cold working and heat treatment at 650 °C, which may cause its plastic properties degradation. In this manuscript, the performance of the developed N50 conduit is introduced, and the effects from cold working and heat treatment on its mechanical performance at cryogenic temperature are discussed. These results can promote the development of N50 conduit with higher strength and toughness.
The China Fusion Engineering Test Reactor (CFETR) proposes the use of high-temperature superconductors as next-generation central solenoid coil magnets to excite a stronger magnetic field. Currently, REBCO and Bi-2212 are two candidate materials for high-temperature superconductors. For some time to come, the fusion reactor superconducting magnet system will keep using a Cable-In-Conduit Conductors (CICC) structure. The strength of current jacket materials can not meet the current requirements of CFETR central solenoid (CS) magnets at 4.2 K. The jacket of CICC has been prepared by N50H material in China, and some research and development work has been carried out. However, in the Bi-2212 magnet manufacturing process, the N50H jacket should undergo a series of procedures, especially the 890 °C heat treatment process may cause its mechanical properties to decline. This article introduces the mechanical properties of N50H jackets before and after aging heat treatment at different temperatures and discusses its influence on mechanical properties at low temperatures. The results show that the elongation is only about 15% at 4.2 K, which temporarily does not meet the requirements, N50H can not be used as jacket of Bi2212 wires at present.