24 April 2017 in Nanotechnology
III-V semiconductor nanowires are a platform for next-generation photovoltaics. An interesting research direction is to embed a nanowire array in a transparent polymer, either to act as a stand-alone flexible solar cell, or to be stacked on top of a conventional Si bottom cell to create a tandem structure. To optimize the tandem cell performance, high energy photons should be absorbed in the nanowires whereas low energy photons should be transmitted to and absorbed in the Si cell. Here, through optical measurements on 1.95 eV bandgap GaInP nanowire arrays embedded in a polymer membrane, we identify two mechanisms that could be detrimental for the performance of the tandem cell. First, the Au particles used in the nanowire synthesis can absorb >50% of the low-energy photons, leading to a 80%. Second, after the removal of the Au particles, a 40% reflectance peak shows up due to resonant back-scattering of light from in-plane waveguide modes. To avoid the excitation of these optical modes in the nanowire array, we propose to limit the pitch of the nanowire array.
5 September 2018 in Nano Letters
The properties of semiconductors can be controlled using doping, making it essential for electronic and optoelectronic devices. However, with shrinking device sizes it becomes increasingly difficult to quantify doping with sufficient sensitivity and spatial resolution. Here, we demonstrate how X-ray fluorescence mapping with a nanofocused beam, nano-XRF, can quantify Zn doping within in situ doped III–V nanowires, by using large area detectors and high-efficiency focusing optics. The spatial resolution is defined by the focus size to 50 nm. The detection limit of 7 ppm (2.8 × 1017 cm–3), corresponding to about 150 Zn atoms in the probed volume, is bound by a background signal. In solar cell InP nanowires with a p-i-n doping profile, we use nano-XRF to observe an unintentional Zn doping of 5 × 1017 cm–3 in the middle segment. We investigated the dynamics of in situ Zn doping in a dedicated multisegment nanowire, revealing significantly sharper gradients after turning the Zn source off than after turning the source on. Nano-XRF could be used for quantitative mapping of a wide range of dopants in many types of nanostructures.
9 November 2018 in Nanotechnology
Nanowire array solar cells have reached efficiencies where it becomes feasible to talk about creating tandem solar cells in order to achieve even higher efficiencies. An example of such a tandem solar cell could be a nanowire array embedded in a membrane and integrated on top of a Si bottom cell. Such a system, however, requires understanding and control of its interaction with light, especially to make sure that the low energy photons are transmitted to the bottom cell. The dependence of the optical response of a nanowire array on the nanowire length, diameter, array pitch, materials surrounding the nanowires, and absorption coefficient of the nanowire material is very strong and possibly resonant, indicating the complexity of the optical response. In this work, we use an eigenmode-based analysis to reveal underlying physics that gives rise to observed resonant and non-resonant behavior. First, we show that an effective refractive index can be defined at long wavelengths, where only a single mode propagates. Second, we analyze the origin of the resonant reflection when the next optical mode becomes propagating and can be 'trapped' in the array and interact with the fundamental mode. Additionally, we define two simple boundaries for the wavelength range of the resonant response: the resonances can only occur if there is more than 1 propagating mode in the array, and they disappear if the 1st diffracted order is propagating in the top or bottom material. Such resonance effects could be detrimental for tandem solar cells. We thus provide recommendations for tuning the geometry of the array and the nanowire materials in order to push the resonant regime to the absorbing regime of the nanowire, where absorption in the nanowires dampens the resonances. Finally, this work demonstrates the strength of an eigenmode-based analysis of the optical response of periodic nanostructures in terms of simplifying the analysis of a complex system.
14 January 2016 in Nanotechnology
In order to push the development of nanowire-based solar cells further using optimized nanowire diameter and pitch, a doping evaluation of the nanowire geometry is necessary. We report on a doping evaluation of n-type InP nanowires with diameters optimized for light absorption, grown by the use of metal–organic vapor phase epitaxy in particle-assisted growth mode using tetraethyltin (TESn) as the dopant precursor. The charge carrier concentration was evaluated using four-probe resistivity measurements and spatially resolved Hall measurements. In order to reach the highest possible nanowire doping level, we set the TESn molar fraction at a high constant value throughout growth and varied the trimethylindium (TMIn) molar fraction for different runs. Analysis shows that the charge carrier concentration in nanowires grown with the highest TMIn molar fraction (not leading to kinking nanowires) results in a low carrier concentration of approximately 1016 cm−3. By decreasing the molar fraction of TMIn, effectively increasing the IV/III ratio, the carrier concentration increases up to a level of about 1019 cm−3, where it seems to saturate. Axial carrier concentration gradients along the nanowires are found, which can be correlated to a combination of changes in the nanowire growth rate, measured in situ by optical reflectometry, and polytypism of the nanowires observed in transmission electron microscopy.
10 September 2018 in Nanotechnology
We demonstrate x-ray absorption fine structure spectroscopy (XAFS) detected by x-ray beam induced current (XBIC) in single n + -i-n + doped nanowire devices. Spatial scans with the 65 nm diameter beam show a peak of the XBIC signal in the middle segment of the nanowire. The XBIC and the x-ray fluorescence signals were detected simultaneously as a function of the excitation energy near the Ga K absorption edge at 10.37 keV. The spectra show similar oscillations around the edge, which shows that the XBIC is limited by the primary absorption. Our results reveal the feasibility of the XBIC detection mode for the XAFS investigation in nanostructured devices.
6 July 2018 in Nanotechnology
GaxIn(1-x)P nanowire arrays are promising for various optoelectronic applications with band-gap tunable over a wide range. In particular, it is well suited as a top cell in tandem junction solar cell devices. So far, most GaxIn(1-x)P nanowires have been synthesized by use of trimethylgallium. However, particle assisted nanowire growth in metal organic vapor phase epitaxy is typically carried out at relatively low temperatures, where trimethylgallium is not fully pyrolysed. In this work, we developed growth of GaxIn(1-x)P nanowires using triethylgallium as Ga precursor, which reduced Ga precursor consumption by about 5 times as compared to trimethylgallium due to lower homogeneous pyrolysis temperature of triethylgallium. The versatility of triethylgallium is shown by synthesis of high yield GaxIn(1-x)P nanowire arrays, with a materials composition tunable by the group III input flows, as verified by x-ray diffraction measurements and photoluminescence characterization. The growth dynamics of GaxIn(1-x)P nanowires was assessed by varying the input growth precursor molar fractions and growth temperature, using hydrogen-chloride as in-situ etchant. We observed a complex interplay between the precursors. First, trimethylindium inhibits Ga incorporation into the nanowires, resulting in higher In composition in the grown nanowires than in the vapor. Second, the growth rate increases with temperature, indicating a kinetically limited growth, which from nanowire effective binary volume growth rates of InP and GaP can be attributed to synthesis of GaP in GaxIn(1-x)P. We observed that phosphine has a strong effect on the nanowire growth rate with behavior expected for a unimolecular Langmuir-Hinshelwood mechanism of pyrolysis on a catalytic surface. However, growth rates increase strongly with both triethylgallium and trimethylindium precursors as well, indicating the complexity of vapor liquid solid growth for ternary materials. One precursor can affect the decomposition of another, and each precursor can affect the wetting properties and catalytic activity of the metal particle.