1 April 2013 in Optical Engineering
We have developed an interferometer for gauge block calibration based on phase shifting algorithms. The measurement process can provide flatness, parallelism, and length. Wavelength values need to be corrected according to the refractive index of air. This correction is obtained indirectly using Edlén’s equation. High-resolution sensors provide the temperature, pressure, and relative humidity readings. To preserve stability, the interferometer is encapsulated in a chamber with active temperature control. Its design, measurement principle, calibration, stability, and reproducibility are analyzed. Since one goal is to employ robust and cheap diode lasers as light sources, we describe the system developed to stabilize a red laser diode using a mode locking technique with a reference gas cell. The instruments and assembly are used to avoid the Doppler effect in the gas cell, which would limit wavelength resolution. Several experiments are carried out to restrict the influence of environmental changes, which affect laser diode frequency.
12 October 2015 in IEEE Transactions on Instrumentation and Measurement
JVJose Luis Valencia-Alvarez
Jose Luis Valencia-Alvarez
This paper presents a new electronic Vernier fringe counter for the wavelength measurement of a diode laser in a scanning interferometer. The system is intended to be a low cost alternative to commercial systems used for gauge block calibration. The counter stage and phase coincidence detector are made with a microcontroller and high-speed CMOS logic to achieve the required resolution. The microcontroller also can synchronize with other elements to make a fully automated measurement system. This electronic design improves the resolution of the electronic counters in the previous designs.
1 September 2023 in Review of Scientific Instruments
This article describes a new measurement system for the comparison of two electronic signals of different frequencies with application to high resolution comparison of laser wavelengths using a Michelson interferometer. It was built within the framework of research projects made by the University of Vigo and the Laboratorio Oficial de Metroloxía de Galicia (LOMG) in cooperation with Escolas Proval High School. The new hardware is based on a cheap high-speed module for the acquisition of data and a microcontroller module for processing, which can also be used for practical lessons in vocational training. The system has been tested with electronic signal generators. The novel measurement method reduces the uncertainty using multiple consecutive measurements and the fractional part of the fringes and could achieve precisions in the range 10−12 of the wavelength ratios.