1 May 2007 in Technical Physics
The electrical explosion of aluminum wires is numerically simulated in the magnetohydrodynamic approximation for the current density ranging from 107 to 1010 A/cm2 and times to explosion varying from 10−10 to 10−6 s. It is shown that, at current densities of 108−109 A/cm2, low-temperature explosion conditions change to high-temperature ones, when inertial forces preventing the wire dispersion play a decisive role. This transition is accompanied by a sharp change in the thermodynamic parameters (the temperature and the energy deposited into the wire by the instant of explosion increase by several times), and the action integral for this transition increases smoothly approximately threefold as the explosion characteristics (current density and time to explosion) change by two orders of magnitude. The instant of transition from the low-temperature explosion to the high-temperature one depends on the radial dimensions of an exploding wire and does not depend on the properties of the environment.
1 January 2009 in Technical Physics Letters
The development of thermal (overheat) instabilities during the electric explosion of a conducting wire was studied based on the theory of small perturbations. It is established that (i) the overheat instabilities are always developed in the course of electric explosions, irrespective of the regime of explosion and (ii) a threshold value of the current density exists for each metal, below which the magnetohydrodynamic screw instabilities grow faster than the overheat instabilities; above this threshold, the latter instabilities predominate.
1 April 2021 in Journal of Applied Physics
The dynamics of phase changes in the material of a copper cathode during the explosion of a microprotrusion on its surface under the action of the explosive electron emission current has been numerically simulated. Numerical data have been obtained that characterize the interaction of the liquid metal and the dense cathode plasma that are formed due to the microprotrusion explosion. It has been shown that, under the action of the pressure exerted by the plasma, the liquid metal is almost completely displaced from the zone of operation of the cathode spot of the vacuum discharge. This leads to the formation of a crater on the cathode surface with microirregularities at its edge. Thus conditions are created for the formation of new microprotrusions, which, when exploding, provide self-sustained and cyclic operation of the vacuum discharge.
1 February 2007 in Russian Physics Journal
26 February 2012 in Technical Physics
Experiments are performed on a high-current MIG generator (current amplitude 2.5 MA, current rise time 100 ns) to synthesize diamond-like carbon forms. Magnetohydrodynamic calculations carried out...
11 June 2019 in IEEE Transactions on Plasma Science
This paper presents results of a numerical simulation of the explosion of a surface microprotrusion exposed to a radio frequency electromagnetic field. The integral of specific current action has been estimated for an RF and a dc electric field causing a microprotrusion explosion. It has been shown that in both cases, the microexplosion and the subsequent crater formation occur in much the same way. The results obtained support the hypothesis that a dc vacuum breakdown and a breakdown initiated by an RF wave incident on a metal surface proceed by the same mechanism.