1 March 2023 in IEEE Transactions on Electron Devices
A 500 kV, 80 Hz repetition rate compact Marx generator has been designed and developed for producing high intense relativistic electron beams for high-power microwave (HPM) sources. This Marx generator comprises eight bipolar stages (16 stages of unipolar) using energy storage capacitors for achieving improved performance in repetition mode operation. The maximum charging voltage per stage is 50 kV, producing an erected voltage of 800 kV. However, the load voltage will vary according to the impedance of the load connected across the generator. Custom-designed energy storage capacitors were developed to allow voltage reversal of up to 30%–50%, enabling the system to deliver a higher current. A small pulse transformer-based triggering unit with an output voltage of 30 kV was used for triggering the generator. The system’s performance was tested in pulse repetition frequency (PRF) mode with resistive and diode loads and achieved a repetition rate of 80 Hz. An energy density of ~460 J/m3 was achieved in the developed system. A vircator device was connected and tested to benchmark the Marx generator for its repetitive and burst mode operations. The test results show the measured RF output power of 100 MW.
9 June 2023 in IEEE Transactions on Plasma Science
A compact peaking capacitor-based 500 kV, 10 kA, 100 Hz repetition rate pulsed power source has been designed and developed for high-power microwave applications. This system utilizes a 500 kV, 1.9 nF peaking capacitor to deliver the nanosecond pulse with a peak current of 10 kA. An eight-stage bipolar Marx generator (MG) with 35 kV charging voltage is used for driving this peaking capacitor. The design was carried out by an analytical approach and confirmed by simulation for the MG with and without peaking capacitors using PSpice software. The simulated results were compared to study the enhancement of voltage pulse using a peaking capacitor. The system was developed and tested experimentally with and without a peaking capacitor with different load impedances. The experimental results show the merits of peaking capacitor implementation. The system is suitable for driving HPM load at a high repetition rate with less input energy than similar systems.
12 February 2024 in IEEE Transactions on Plasma Science
A high-voltage repetitive pulsed power supply (PPS) with variable pulsewidth has been designed and developed for generating high-intense electron beams suitable for high RF applications. In this present work, a new passive method is proposed using a suitably designed Marx generator and peaking capacitor. System parameters along with the operating pressure of the peaking switch are designed to achieve the variable pulsewidth at an operating voltage higher than 300 kV and a repetition rate of 100 Hz. Based on this concept, a system is designed, developed, and tested at a voltage of 300 kV with a load current of 5 kA. The variable pulsewidth of 115–204 ns has been achieved from the same PPS and with the same load.