9 January 2019 in Journal of Infrared, Millimeter, and Terahertz Waves
Continuous wave THz (cw THz) systems define the state-of-the-art in terms of spectral resolution in THz spectroscopy. Hitherto, acquisition of broadband spectra in a cw THz system was always connected with slow operation. Therefore, high update rate applications like inline process monitoring and non-destructive testing are served by time domain spectroscopy (TDS) systems. However, no fundamental restriction prevents cw THz technology from achieving faster update rates and be competitive in this field. In this paper, we present a fully fiber-coupled cw THz spectrometer. Its sweep speed is two orders of magnitude higher compared to commercial state-of-the-art systems and reaches a record performance of 24 spectra per second with a bandwidth of more than 2 THz. In the single-shot mode, the same system reaches a peak dynamic range of 67 dB and exceeds a value of 100 dB with averaging of 7 min, which is among the highest values ever reported. The frequency steps can be as low as 40 MHz. Due to the fully homodyne detection, each spectrum contains full amplitude and phase information. This demonstration of THz-spectroscopy at video-rate is an essential step towards applying cw THz systems in non-destructive, in line testing.
24 September 2024 in IEEE Transactions on Terahertz Science and Technology
Terahertz (THz) time-domain spectroscopy (TDS) offers considerable potential for a wide range of industrial applications, including thickness determination and defect identification through imaging. Fiber-coupled THz TDS systems are particularly promising due to their flexible and robust operation in a variety of environments. However, increasing the THz power of these systems remains a critical challenge for applications that require high dynamic range in very short acquisition times. Here, we present a significant improvement of a commercially available THz TDS system by combining a novel ultrafast Er-doped fiber laser and improved iron-doped InGaAs (InGaAs:Fe) photoconductive THz emitters. The Er-doped fiber laser offers the combination of high average power up to 70 mW and ultrashort pulse duration down to 45 fs with a fiber delivery of 6.3 m to the THz antennas. The THz emitters are optimized in terms of the photoconductive material and gap size for excitation at optical power > 50 mW, and provide up to (958 ± 67) μW of emitted THz power. These improvements enable a record peak dynamic range of 117 dB for 60 s acquisition time and the highest peak dynamic range ever measured in a THz TDS setup of 137 dB.
2 August 2024 in Optics Express
For the first time, we present photoconductive, continuous wave (cw) terahertz (THz) detectors for 1550 nm excitation based on rhodium- (Rh) doped indium gallium arsenide (InGaAs) grown by molecular beam epitaxy. Compared to iron- (Fe) doped material, the Rh-doped InGaAs shows higher carrier mobilities with similar carrier lifetimes. Therefore, these photoconductive antennas outperform InGaAs:Fe-based detectors by a factor of 10 in terms of responsivity and noise-equivalent-power (NEP) while maintaining the same bandwidth. In a homodyne spectrometer configuration, we achieve a record peak dynamic range (DNR) of 132 dB, which constitutes an improvement of 20 dB.
8 December 2021 in Journal of Infrared, Millimeter, and Terahertz Waves
We compare a state-of-the-art terahertz (THz) time domain spectroscopy (TDS) system and a novel optoelectronic frequency domain spectroscopy (FDS) system with respect to their performance in layer thickness measurements. We use equal sample sets, THz optics, and data evaluation methods for both spectrometers. On single-layer and multi-layer dielectric samples, we found a standard deviation of thickness measurements below 0.2 µm for TDS and below 0.5 µm for FDS. This factor of approx. two between the accuracy of both systems reproduces well for all samples. Although the TDS system achieves higher accuracy, FDS systems can be a competitive alternative for two reasons. First, the architecture of an FDS system is essentially simpler, and thus the price can be much lower compared to TDS. Second, an accuracy below 1 µm is sufficient for many real-world applications. Thus, this work may be a starting point for a comprehensive cross comparison of different terahertz systems developed for specific industrial applications.
1 March 2025 in APL Photonics
Continuous wave (cw) terahertz (THz) radiation has a wide array of applications, ranging from sensing to next-generation wireless communication links. Industrial applications frequently require THz systems that are broadband, highly efficient, and compact. Photomixer-based solutions hold promise in meeting these demands, offering extremely broadband operation and the potential for miniaturization through photonic integration. However, current photoconductive antenna (PCA) receivers used in these systems are top-illuminated, which strongly limits their efficiency and renders them incompatible with photonic integration. To overcome these limitations, we developed optical waveguide-integrated photoconductive antennas (win-PCAs) for cw-THz detection. These antennas not only facilitate integration into photonic integrated chips (PICs) but also allow us to explore new device geometries to optimize the PCA’s responsivity. By optimizing the absorber geometry of the win-PCAs, we achieve a 22-fold increase in photoresponse, a 500-fold improvement in THz responsivity, and a 4.7-fold reduction in noise-equivalent power compared to state-of-the-art top-illuminated PCAs. In a coherent cw-THz spectrometer, these improvements enable measurements with a peak dynamic range of 123 dB for 300 ms averaging, which is 11 dB higher than what is achievable with comparable top-illuminated receivers. The presented win-PCAs represent a significant step toward fully integrated, high-performing photonic cw-THz systems for both spectroscopy and high-capacity wireless links.