Xi Chen

Xi Chen

Auto-generated profile, based on publicly available information

Xi Chen

State Key Laboratory of Aerodynamics, Mianyang, China

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 May 2017 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
XCXi Chen
Xi Chen
YZYiding Zhu
Yiding Zhu
CLCunbiao Lee
Cunbiao Lee
The stability of a hypersonic boundary layer on a flared cone was analysed for the same flow conditions as in earlier experiments (Zhang et al., Acta Mech. Sinica, vol. 29, 2013, pp. 48–53; Zhu et al., AIAA J., vol. 54, 2016, pp. 3039–3049). Three instabilities in the flared region, i.e. the first mode, the second mode and the Görtler mode, were identified using linear stability theory (LST). The nonlinear-parabolized stability equations (NPSE) were used in an extensive parametric study of the interactions between the second mode and the single low-frequency mode (the Görtler mode or the first mode). The analysis shows that waves with frequencies below 30 kHz are heavily amplified. These low-frequency disturbances evolve linearly at first and then abruptly transition to parametric resonance. The parametric resonance, which is well described by Floquet theory, can be either a combination resonance (for non-zero frequencies) or a fundamental resonance (for steady waves) of the secondary instability. Moreover, the resonance depends only on the saturated state of the second mode and is insensitive to the initial low-frequency mode profiles and the streamwise curvature, so this resonance is probably observable in boundary layers over straight cones. Analysis of the kinetic energy transfer further shows that the rapid growth of the low-frequency mode is due to the action of the Reynolds stresses. The same mechanism also describes the interactions between a second-mode wave and a pair of low-frequency waves. The only difference is that the fundamental and combination resonances can coexist. Qualitative agreement with the experimental results is achieved.

14 September 2018 in Journal of Fluid Mechanics
Verified
Journal Article
Open access
PDF file
YZYiding Zhu
Yiding Zhu
CLCunbiao Lee
Cunbiao Lee
XCXi Chen
Xi Chen
JWJiezhi Wu
Jiezhi Wu
SCShiyi Chen
Shiyi Chen
MGMohamed Gad-El-Hak
Mohamed Gad-El-Hak
Instability evolution in a transitional hypersonic boundary layer and its effects on aerodynamic heating are investigated over a 260 mm long flared cone. Experiments are conducted in a Mach 6 wind tunnel using Rayleigh-scattering flow visualization, fast-response pressure sensors, fluorescent temperature-sensitive paint (TSP) and particle image velocimetry (PIV). Calculations are also performed based on both the parabolized stability equations (PSE) and direct numerical simulations (DNS). Four unit Reynolds numbers are studied, 5.4, 7.6, 9.7 and $11.7\times 10^{6}~\text{m}^{-1}$ . It is found that there exist two peaks of surface-temperature rise along the streamwise direction of the model. The first one (denoted as HS) is at the region where the second-mode instability reaches its maximum value. The second one (denoted as HT) is at the region where the transition is completed. Increasing the unit Reynolds number promotes the second-mode dissipation but increases the strength of local aerodynamic heating at HS. Furthermore, the heat generation rates induced by the dilatation and shear processes (respectively denoted as $w_{\unicode[STIX]{x1D703}}$ and $w_{\unicode[STIX]{x1D714}}$ ) were investigated. The former item includes both the pressure work $w_{\unicode[STIX]{x1D703}1}$ and dilatational viscous dissipation $w_{\unicode[STIX]{x1D703}2}$ . The aerodynamic heating in HS mainly arose from the high-frequency compression and expansion of fluid accompanying the second mode. The dilatation heating, especially $w_{\unicode[STIX]{x1D703}1}$ , was more than five times its shear counterpart. In a limited region, the underestimated $w_{\unicode[STIX]{x1D703}2}$ was also larger than $w_{\unicode[STIX]{x1D714}}$ . As the second-mode waves decay downstream, the low-frequency waves continue to grow, with the consequent shear-induced heating increasing. The latter brings about a second, weaker growth of surface-temperature HT. A theoretical analysis is provided to interpret the temperature distribution resulting from the aerodynamic heating.

19 February 2019 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
XCX. Chen
X. Chen
GHG. L. Huang
G. L. Huang
CLCunbiao Lee
Cunbiao Lee
This study investigates the stability and transition of Görtler vortices in a hypersonic boundary layer using linear stability theory and direct numerical simulations. In the simulations, Görtler vortices are separately excited by wall blowing and suction with spanwise wavelengths of 3, 6 and 9 mm. In addition to primary streaks with the same wavelength as the blowing and suction, secondary streaks with half the wavelength also emerge in the 6 and 9 mm cases. The streaks develop into mushroom structures before breaking down. The breakdown processes of the three cases are dominated by a sinuous-mode instability, a varicose-mode instability and a combination of the two, respectively. Both fundamental and subharmonic instabilities are relevant in all cases. Multiple modes are identified in the secondary-instability stage, some of which originate from the primary instabilities (first and second Mack modes). We demonstrate that the first Mack mode can be destabilized to either a varicose-mode or sinuous-mode streak instability depending on its frequency and wavelength, whereas the second Mack mode undergoes a stabilizing stage before turning into a varicose mode in the 6 and 9 mm cases. An energy analysis reveals the stabilizing and destabilizing mechanisms of the primary instabilities under the influence of Görtler vortices, highlighting the role played by the spanwise production based on the spanwise gradient of the streamwise velocity in both varicose and sinuous modes. The effects introduced by the secondary streaks are examined by filtering the secondary streaks in two new simulations with nominally identical conditions to those of the 6 and 9 mm cases. Remarkably, the secondary streaks can destabilize the Görtler vortices, therefore advancing the transition. The stability theory results are in good agreement with those from direct numerical simulations.

11 March 2020 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
XJX. Y. Jiang
X. Y. Jiang
CLCunbiao Lee
Cunbiao Lee
XCX. Chen
X. Chen
CSC. R. Smith
C. R. Smith
PLP. F. Linden
P. F. Linden
The beginning of laminar–turbulent transition is usually associated with a wave-like disturbance, but its evolution and role in precipitating the development of other flow structures are not well understood from a structure-based view. Nonlinear parabolized stability equations (NPSE) were solved numerically to simulate the transition of K-regime, N-regime and O-regime. However, only the K-regime transition was examined experimentally using both hydrogen bubble visualization and time-resolved tomographic particle image velocimetry (tomo-PIV). Based on the ‘NPSE visualization’ and ‘tomographic visualization’, at least four common characteristics of the generic transition process were identified: (i) inflectional regions representing high-shear layers (HSL) that develop in vertical velocity profiles, accompanied by ejection–sweep behaviours; (ii) low-speed streak (LSS) patterns, manifested in horizontal timelines, that seem to consist of several three-dimensional (3-D) waves; (iii) a warped wave front (WWF) pattern, displaying multiple folding processes, which develops adjacent to the LSS in the near-wall region, prior to the appearance of 𝛬-vortices; (iv) a coherent 3-D wave front, similar to a soliton, in the upper boundary layer, accompanied by regions of depression along the flanks of the wave. It was determined that the amplification and lift-up of a 3-D wave causes the development of the HSL, WWF and multiple folding behaviour of material surfaces, that all contribute to the development of a 𝛬-vortex. The amplified 3-D wave is hypothesized as a soliton-like coherent structure. Based on our results, a path to transition is proposed, which hypothesizes the function of the WWF in boundary-layer transition.

10 March 2022 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
XCXi Chen
Xi Chen
SDSiwei Dong
Siwei Dong
GTGuohua Tu
Guohua Tu
XYXianxu Yuan
Xianxu Yuan
JCJianqiang Chen
Jianqiang Chen
Boundary layer transition over a lifting body of 1.6 m length at $2^\circ$ angle of attack has been simulated at Mach 6 and a unit Reynolds number $1.0 \times 10^7$ m $^{-1}$ . The model geometry is the same as the Hypersonic Transition Research Vehicle designed by the China Aerodynamics Research and Development Center. Four distinct transitional regions are identified, i.e. windward vortex region, shoulder vortex region, windward cross-flow region and shoulder cross-flow region. Multi-dimensional linear stability analyses by solving the two-dimensional eigenvalue problem (spatial BiGlobal approach) and the plane-marching parabolized stability equations (PSE3D approach) are further carried out to uncover the dominant instabilities in the last three regions as well as the shoulder attachment-line region. The shoulder vortex is conducive to both inner and outer modes of shear-layer instability, of which the latter most likely trigger the vortex breakdown. A novel method is presented to substantially reduce the computational cost of BiGlobal and PSE3D in resolving the cross-flow instabilities in cross-flow regions. The peak frequencies of cross-flow modes lie between 15 and 45 kHz. Whereas oblique second Mack modes are marginally unstable in the windward cross-flow region, they could be strong enough to compete with the cross-flow modes in the shoulder cross-flow region. In the shoulder attachment-line region, there exists only one unstable mode of Mack instability, differing from previous studies that show a hierarchy of modes in the context of symmetrical attachment-line flows. Results of the numerical simulation and multi-dimensional stability analyses are compared when possible, showing a fair agreement between the two approaches and highlighting the necessity of considering non-parallel effects.

1 February 2016 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
XCXi Chen
Xi Chen
CZChen Zhijiang
Chen Zhijiang
XLXiaotian Li
Xiaotian Li
LSLiang Shan
Liang Shan
WSWanchen Sun
Wanchen Sun
Shuxiang DongShuxiang Dong
Shuxiang Dong
We report a hollow type piezoelectric micromotor made of a PZT ceramic/metal composite cylinder with sizes of only 3.6 mm in diameter and 3.0 mm in length aiming at medical endoscope application. The hollow piezoelectric stator of the micromotor, acting as a nut, can excite E02-mode traveling wave along its circumferential direction, and a hollow rotor with a fine lens inside, acting as a screw, is driven to produce a spiral motion along its axis direction inside the hollow stator via the traveling wave. The features of the developed micromotors are its hollow, fine structure and submicrometer step resolution, ensuring that the optical path passes in a narrow and limited space and that the optical focal length is tuned precisely inside the endoscope, which is meaningful in medical diagnosis.