Cunbiao Lee

Dr. Cunbiao Lee


Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2019 in Physics of Fluids
Verified
Journal Article
Open access
PDF file
CLCunbiao Lee
Cunbiao Lee
XJXianyang Jiang
Xianyang Jiang
The basic problems of transition in both incompressible and compressible boundary layers are reviewed. Flow structures in low-speed transitional and developed turbulent boundary layers are presented, together with almost all of the physical mechanisms that have been proposed for their formation. Comparisons of different descriptions of the same flow structures are discussed as objectively as possible. The importance of basic structure such as solitonlike coherent structure is addressed. For compressible flows, the receptivity and instability of boundary layer are reviewed, including the effect of different parameters on the transition. Finally, the principle of aerodynamic heating of hypersonic boundary layer is presented.

12 May 2017 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
XCXi Chen
Xi Chen
YZYiding Zhu
Yiding Zhu
CLCunbiao Lee
Cunbiao Lee
The stability of a hypersonic boundary layer on a flared cone was analysed for the same flow conditions as in earlier experiments (Zhang et al., Acta Mech. Sinica, vol. 29, 2013, pp. 48–53; Zhu et al., AIAA J., vol. 54, 2016, pp. 3039–3049). Three instabilities in the flared region, i.e. the first mode, the second mode and the Görtler mode, were identified using linear stability theory (LST). The nonlinear-parabolized stability equations (NPSE) were used in an extensive parametric study of the interactions between the second mode and the single low-frequency mode (the Görtler mode or the first mode). The analysis shows that waves with frequencies below 30 kHz are heavily amplified. These low-frequency disturbances evolve linearly at first and then abruptly transition to parametric resonance. The parametric resonance, which is well described by Floquet theory, can be either a combination resonance (for non-zero frequencies) or a fundamental resonance (for steady waves) of the secondary instability. Moreover, the resonance depends only on the saturated state of the second mode and is insensitive to the initial low-frequency mode profiles and the streamwise curvature, so this resonance is probably observable in boundary layers over straight cones. Analysis of the kinetic energy transfer further shows that the rapid growth of the low-frequency mode is due to the action of the Reynolds stresses. The same mechanism also describes the interactions between a second-mode wave and a pair of low-frequency waves. The only difference is that the fundamental and combination resonances can coexist. Qualitative agreement with the experimental results is achieved.

7 May 2018 in National Science Review
Verified
Journal Article
Open access
PDF file
CLCunbiao Lee
Cunbiao Lee
SCShiyi Chen
Shiyi Chen
Turbulence is a universal form of fluid motion. It is the key issue in fluid mechanics. Very recently, it has become a bottleneck in some key engineering research of national importance, such as aeronautics, astronautics and navigation. Developed turbulence and the onset of turbulence, i.e. transition, are two interrelated parts of turbulence. The hypersonic boundary-layer transition is a strategic focus in the fluid mechanics community. This article reviews recent developments in the study of the hypersonic boundary-layer transition, research facilities and experimental techniques. The hypersonic quiet wind tunnel is introduced as a necessary device to obtain real flight data in near space. Near-wall measurement techniques, such as temperature-sensitive paint, near-wall particle image velocimetry and Rayleigh-scattering visualization, are shown. The most important issues in the recent development of the transition in the hypersonic boundary layer are addressed. The instability and nonlinear interaction of different instability modes are discussed. The recent contributions from China, especially at Peking University, are also introduced.

1 January 2018 in Physics of Fluids
Verified
Journal Article
Closed access
YZYiding Zhu
Yiding Zhu
XCXi Chen
Xi Chen
JWJiezhi Wu
Jiezhi Wu
SCShiyi Chen
Shiyi Chen
CLCunbiao Lee
Cunbiao Lee
MGMohamed Gad-El-Hak
Mohamed Gad-El-Hak
The evolution of second-mode instabilities in hypersonic boundary layers and its effects on aerodynamic heating are investigated. Experiments are conducted in a Mach 6 wind tunnel using fast-response pressure sensors, fluorescent temperature-sensitive paint, and particle image velocimetry. Calculations based on parabolic stability equations and direct numerical simulations are also performed. It is found that second-mode waves, accompanied by high-frequency alternating fluid compression and expansion, produce intense aerodynamic heating in a small region that rapidly heats the fluid passing through it. As the second-mode waves decay downstream, the dilatation-induced aerodynamic heating decreases while its shear-induced counterpart keeps growing. The latter brings about a second growth of the surface temperature when transition is completed.

14 September 2018 in Journal of Fluid Mechanics
Verified
Journal Article
Open access
PDF file
YZYiding Zhu
Yiding Zhu
CLCunbiao Lee
Cunbiao Lee
XCXi Chen
Xi Chen
JWJiezhi Wu
Jiezhi Wu
SCShiyi Chen
Shiyi Chen
MGMohamed Gad-El-Hak
Mohamed Gad-El-Hak
Instability evolution in a transitional hypersonic boundary layer and its effects on aerodynamic heating are investigated over a 260 mm long flared cone. Experiments are conducted in a Mach 6 wind tunnel using Rayleigh-scattering flow visualization, fast-response pressure sensors, fluorescent temperature-sensitive paint (TSP) and particle image velocimetry (PIV). Calculations are also performed based on both the parabolized stability equations (PSE) and direct numerical simulations (DNS). Four unit Reynolds numbers are studied, 5.4, 7.6, 9.7 and $11.7\times 10^{6}~\text{m}^{-1}$ . It is found that there exist two peaks of surface-temperature rise along the streamwise direction of the model. The first one (denoted as HS) is at the region where the second-mode instability reaches its maximum value. The second one (denoted as HT) is at the region where the transition is completed. Increasing the unit Reynolds number promotes the second-mode dissipation but increases the strength of local aerodynamic heating at HS. Furthermore, the heat generation rates induced by the dilatation and shear processes (respectively denoted as $w_{\unicode[STIX]{x1D703}}$ and $w_{\unicode[STIX]{x1D714}}$ ) were investigated. The former item includes both the pressure work $w_{\unicode[STIX]{x1D703}1}$ and dilatational viscous dissipation $w_{\unicode[STIX]{x1D703}2}$ . The aerodynamic heating in HS mainly arose from the high-frequency compression and expansion of fluid accompanying the second mode. The dilatation heating, especially $w_{\unicode[STIX]{x1D703}1}$ , was more than five times its shear counterpart. In a limited region, the underestimated $w_{\unicode[STIX]{x1D703}2}$ was also larger than $w_{\unicode[STIX]{x1D714}}$ . As the second-mode waves decay downstream, the low-frequency waves continue to grow, with the consequent shear-induced heating increasing. The latter brings about a second, weaker growth of surface-temperature HT. A theoretical analysis is provided to interpret the temperature distribution resulting from the aerodynamic heating.

1 February 2013 in Acta Mechanica Sinica
Verified
Journal Article
Closed access
PDF file
CZChuan-Hong Zhang
Chuan-Hong Zhang
QTQing Tang
Qing Tang
CLCunbiao Lee
Cunbiao Lee