16 July 2021 in IET Power Electronics
Multilevel converters have seen rising demands in the past decades, due to their increased power ratings, enhanced power quality, low switching losses and reduced electromagnetic interference. Prominent among them are the three‐level (3L) neutral point clamped and the flying capacitor inverter topologies along with their derivatives. Nevertheless, the main drawback of these topologies is the requirement of a front‐end boost DC–DC converter to compensate the high dc‐link voltage demand, which is usually twice the grid peak voltage. This multi‐stage power conversion further pulls down the overall system efficiency. A single‐stage dc–ac power converter with boost capability offer an interesting alternative compared to the two stage approach. Considering this aspect, a novel three‐level three‐phase boost type inverter is introduced in this paper for general‐purpose applications (prominently grid‐connected renewable energy). The proposed inverter would reduce the DC‐link voltage requirement to half using the same or even less number of active and passive components, compared to the conventional three‐level neutral point clamped and flying capacitor family. The principle of operation and theoretical analysis are discussed in detail. The design methodology along with simulation and experimental waveforms for a 5 kVA inverter are presented to prove the concept of the proposed inverter topology for practical applications.
1 July 2026 in IEEE Transactions on Power Electronics
This article proposes a novel Symmetric Unipolar Modulation (SUM) strategy for Dual Active Bridge (DAB) converters, which significantly enhances power density by improving transformer utilization factor and reducing the size of passive components. The proposed SUM technique effectively doubles the transformer frequency ($f_{\text{TX}}$) to $2f_{sw}$ while maintaining the switching frequency ($f_{sw}$) of both the primary and secondary side bridge switches at $f_{sw}$, unlike conventional methods where the semiconductor and transformer frequencies are equal. By pushing the transformer frequency to a higher level, the proposed technique minimizes passive component dimensions without introducing additional stress on the active or passive components. Moreover, the SUM approach reshapes the transformer core flux density from triangular to trapezoidal while reducing its peak and enabling further reduction in magnetic core size. It also reduces the voltage stress across the transformer by half compared to conventional modulation strategies, thereby improving the overall performance of the converter. Experimental validation using a 1-kW prototype confirms the effectiveness of the proposed modulation technique in achieving these benefits.