16 September 2007 in Nature Photonics
8 February 2022 in Journal of Lightwave Technology
Historically optical links up to 100–300m distances are served by light emitting devices in the 850 nm spectral range in combination with multimode glass fibers (MMF). As the silicon scaling continues, a single channel data rate is to double each 24 months. Light-emitting diodes had to be replaced by vertical cavity surface emitting lasers (VCSELs) and the data rate increased from 100 Mb/s to 10 Gb/s. At higher data rates problems with further scaling evolved. To avoid the collapse an anti-waveguiding VCSEL cavity design was invented, applied, and presently serves data links operating up to 50–100 Gb/s per channel. Another requirement in data communication is the bandwidth density scaling, with the number of channels per link increasing approximately 5-fold each 10 years, while keeping a similar space for connectors. A coarse short-wavelength division multiplexing allowing 850 nm, 880 nm, 910 nm, and 940 nm wavelengths in a single MMF is introduced. The bandwidth density increase is also possible by using multicore fiber (MCF) coupled to on-chip VCSEL arrays. The data rates up to 224 Gb/s are already reached by 850nm VCSELs. At such data rates significant transmission distance over MMF is only possible by applying ultra-narrow spectrum VCSELs minimizing the chromatic dispersion effects. On-chip mini-arrays of oxide-confined VCSELs allow a high coupling efficiency to MMFs, a narrow spectrum, a high power, a significant transmission distance at high data rates. Coherent lasing in such arrays allow photon-photon resonance engineering aimed at modulation bandwidths ∼50–100 GHz.
1 April 2016 in Electronics Letters
Successful 54 Gbit/s on–off keying (OOK) transmission over 2.2 km of multimode OM4 fibre is demonstrated. The decisive advantages of the single mode over multimode vertical cavity surface emitting laser (VCSEL) in transmission experiments are shown.
4 January 2018 in Optics Express
Oxide–confined vertical cavity surface emitting lasers (VCSELs) with anti–waveguiding AlAs–rich core presently attract a lot of attention. Anti–waveguiding cavity enables the maximum possible optical confinement of the VCSEL mode (“λ/2 design”), increases its oscillator strength and reduces dramatically the optical power accumulated in the VCSEL mesa regions outside the aperture. VCSEL designs are suggested that favor single transverse mode operation. Modeling including current–induced and absorption–induced overheating shows that the preference for the transverse fundamental mode persists up to 10 mA current at 5 µm aperture diameter. Error–free data transmission is realized up to 160 Gb/s in digital–multitone (DMT) format using single–mode anti–waveguiding VCSELs. The approach to single–mode anti–waveguiding VCSELs is extended over a broad spectral range realizing error–free high–speed data transmission at both 850 nm and 910 nm.
10 November 2016 in Journal of Lightwave Technology
To cope with the ever increasing data traffic demands in modern data centers, new approaches and technologies must be explored. Short range optical data links play a key role in this scenario, enabling very high speed data rate links. Recently, great research efforts are being made to improve the performance of vertical-cavity surface-emitting lasers (VCSELs) based transmission links, which constitute a cost-effective solution desirable for massive deployments. In this paper, we experimentally demonstrate intensity-modulation direct-detection transmissions with a data rate of 107.5 Gb/s over 10 m of OM4 multimode fiber (MMF) using a multimode VCSEL at 850 nm, and up to 100 m of OM4 MMF using a single-mode VCSEL at 850 nm. Measured bit error rates were below 7% overhead forward error correction limit of 3.8e-03, thus, achieving an effective bit rate of 100.5 Gb/s. These successful transmissions were achieved by means of the multiband approach of carrierless amplitude phase modulation.
15 September 2017 in IEEE Journal of Quantum Electronics
This paper presents data on wafer-fused 1550-nm vertical-cavity surface-emitting lasers (VCSELs) based on the active region and distributed Bragg reflectors (DBRs) grown by molecular beam epitaxy. VCSELs with a tunnel junction aperture diameter of 8 μm show lasing at a threshold current density jth <; 3 kA/cm2, an output optical power of ~4 mW, and a -3 dB bandwidth of approximately 7 GHz at a 10-mA bias current. The devices demonstrate single-mode continuous wave operation with the transverse side-mode suppression ratio (SMSR) varying in the range of 40-45 dB up to roll-over currents. The increase in mirror losses due to the etching of the top DBR makes the output optical power increase to 6 mW and causes the wallplug efficiency value to reach 20%, but SMSR remains in the range of 40-45 dB. This also makes it possible to reduce both the photon lifetime and, as a result, the effect of damping and increase the modulation bandwidth to 9 GHz. The observed open and clear eye diagrams indicate that non-return-to-zero operation is possible at bit rates of up to 30 Gbps without equalization or forward error correction. The high-output optical power and modulation performance pave the way for the dense wavelength division multiplexing application of wafer-fused 1550-nm VCSELs.