Half-metallic ferromagnetic Heusler alloys having high spin polarization are promising candidates to realize large magnetoresistance (MR) ratio and high spin-transfer torque (STT) efficiency in next-generation spintronic devices. Since the Heusler alloy properties are sensitive to composition, optimizing the composition is crucial for enhancing device performance. Here, we report the fabrication of high-performance current-perpendicular-to-plane giant magnetoresistance (CPP-GMR) devices using Co2MnxFe1−xGe (0 ≤ x ≤ 1) Heusler alloy, employing a high-throughput and detailed composition optimization method. The method combined composition-gradient films and local measurements to enable the composition variation from Co2FeGe to Co2MnGe to be efficiently studied on a single library sample with a small composition interval. The CPP-GMR devices fabricated from stacks annealed at 250 °C showed a clear composition dependence of MR with the maximum of MR ratio ∼38% in the Mn-rich region of x = 0.85. By increasing the annealing temperature to 350 °C, the MR ratio increased to ∼45% along with high STT efficiency ∼0.6 in the broad composition range of 0.2 ≤ x ≤ 0.7. The optimal composition for the highest MR changed with annealing temperature because of the stability of the GMR stack being higher in the lower x range. The record high MR for the all-metal CPP-GMR devices, at low annealing temperature of 250 °C was achieved by the detailed composition optimization. These results present the high potential of Co2MnxFe1−xGe and provide a comprehensive guidance on the composition optimization for achieving large MR ratio and high STT efficiency in the CPP-GMR devices.
16 July 2024 in Journal of Physics D: Applied Physics
We demonstrate a high-throughput experimental characterization of anomalous Nernst conductivity ( ) of L10-ordered CoPt using Co1–xPtx composition-spread thin films on MgO(100) substrates. The compositional dependence of the anomalous Nernst effect, anomalous Hall effect (AHE) and Seebeck effect is systematically measured. As increasing the Pt concentration, the crystal structure in the composition-spread film grown at 500 °C changes from face-centered cubic (fcc) Co, A1-disordered CoPt, L10-ordered CoPt, A1-CoPt to fcc Pt. The largest of 2.52 A m–1 K–1 is obtained in L10-CoPt for Pt-rich composition of x = 70%, which is larger than that for an additionally fabricated nearly stoichiometric L10-Co48Pt52 reference uniform film. The contribution from direct conversion of a temperature gradient to a transverse charge current through is dominant to the total anomalous Nernst coefficient compared to the AHE-related contribution. From a scaling analysis of the AHE, the intrinsic contribution is found to be dominant for x = 70%. A theoretical calculation for of L10-Co50Pt50 agrees with the experimental value for the nearly stoichiometric reference film by considering on-site Coulomb interaction for Co atoms. We also point out the possible electron doping effect by the addition of Pt in L10-CoPt, which could explain the larger for the off-stoichiometric Pt-rich composition than that for the nearly stoichiometric one. Our experimental and theoretical results suggest the potential of L10-CoPt with a large originating from the intrinsic mechanism for future thermoelectric applications.
Oxygen vacancy defects (VO) in Ti-based oxides play important roles in catalytic processes despite limited knowledge regarding their formation and characterization. Here, we demonstrate the use of X-ray absorption spectroscopy (XAS) measurements to compare the relative proportion of VO defects in as-grown alkali hexatitanate A2Ti6O13 (A = Li, Na, K). Both X-ray absorption near edge structure (XANES) and extended X-ray absorption fine structure (EXAFS) regions were studied. The similarity of measured XANES spectra of Ti K-edge in all samples indicates the presence of (Ti4+)O6 units in good agreement with reported X-ray diffraction results. The small influence of cations A at the tunnel was observed and can be well reproduced in the simulated spectra. In addition, we present a semi-quantitative approach to intuitively determine the content of VO defects in oxygen-deficient K2Ti6O13-x by in situ time-resolved XAS measurements under reducing conditions (10%H2/Ar, 50-650 °C). The in situ XANES measurements indicate that the oxidation state of bulk Ti remains the same as the as-grown sample, i.e., 4+, at elevated temperatures. By in situ EXAFS measurements, the relative number of VO defects is highest at a reduction temperature of ∼550 °C and slightly decreases after that. To confirm the formation of VO defects, first-principles calculations were independently carried out using a 126-atom K2Ti6O13 supercell with VO at various positions. Based on calculated EXAFS, the removal of the oxygen atom nearest to the tunnel, which is the lowest energy structure, provides a good match to the experimental spectra.
Magnetic materials with high negative spin polarization have been sought as a building block to increase the design freedom and performance of spintronics devices. In this paper, we investigate negative spin polarization of Mn2VGa Heusler alloy in current-perpendicular-to-plane giant magnetoresistance (CPP-GMR) devices. We fabricated an epitaxial CPP-GMR stack consisting of Mn2VGa/Ag/CoFe with L21 ordering in the Mn2VGa layer and observed negative magnetoresistance (MR), which provided evidence of negative spin polarization. The MR ratio depended on thermal treatments (deposition at an elevated temperature and post-annealing), because these processes affected the ordering, roughness, and magnetic properties of Mn2VGa. The maximum MR ratio reached −1.8% at room temperature and −3.0% at low temperatures, representing the highest among the negative MR values in pseudo-spin-valve CPP-GMR devices despite the underestimation due to an incomplete antiparallel magnetization configuration. These findings demonstrate the potential of Mn2VGa for a material with high negative spin polarization.
We explored (MVA) Heusler alloy thin films to investigate their potential as a material with negative spin polarization. Density-of-states calculations showed that MVA has a gap in the majority-spin state at the Fermi energy, leading to negative spin polarization. Negative spin polarization was found to be higher in the -ordered state than that in the -ordered state. antisites (V atoms occupying Mn sites) introduced an in-gap state that significantly reduced negative spin polarization, while and antisites preserved the energy gap and thus weakly affected negative spin polarization. High-quality MVA films were fabricated via magnetron sputtering at elevated temperatures, achieving the and order parameters of 0.88 and 0.5 at in the stoichiometric composition, respectively. The comparison of stoichiometric and various off-stoichiometric samples revealed that the Mn-rich and Al-rich compositions showed an improved ordering and a smaller number of antisites. The benefit of using off-stoichiometric compositions was further highlighted by the obtained negative magnetoresistance, which was measured via epitaxial MVA/Ag spacer/CoFe current-perpendicular-to-plane giant magnetoresistance devices. Devices with the MVA composition of showed a very large negative magnetoresistance of −4.4%, indicating high negative spin polarization in MVA. Furthermore, highly efficient spin-transfer torque generation, with a torque direction opposite to that seen in positive spin polarization materials, was demonstrated via spin injection from MVA.