29 April 2021 in Nuclear Fusion
The exhaust of excessively high heat and particle fluxes on the divertor target is crucial for EAST long-pulse operation. In the recent EAST experiments, stable partial energy detachment around the upper outer strike point with H 98,y2 ∼ 1 was achieved with either Ne or Ar seeding from the upper outer divetor target in the upper single null configuration with ITER-like tungsten divertor. With either Ar or Ne seeding, the electron temperature around the upper outer strike point (T et,UOSP) was maintained at around 5 eV, the peak temperature of divertor target surface around the upper outer strike point (T div,UO) decreased significantly, and material sputtering was well suppressed. It was observed that there was less Ar seeding needed for partial energy detachment onset than Ne seeding, which shows that Ar is more efficient in the cooling of T et on the upper outer divertor than Ne. However, there was no detachment on the upper inner divertor with T et around strike point (T et,UISP) remaining >10 eV with either Ar or Ne seeding from the upper outer divertor. Accompanied with the disappearance of double peak phenomenon of ion flux density on the upper inner divertor target (j s,UI), the peak T div,UI around the strike point increased to around 300 °C. Although the heat flux on the upper inner divertor target (q t,UI) is still in the acceptable level, either Ar or Ne seeding only from the upper outer divertor target is not enough to protect the upper inner divertor target from sputtering under current EAST conditions. On the other hand, Ar seeding always causes confinement degradation in the partial energy detachment state. It was observed that there is a slight confinement improvement (∼10%) with Ne seeding, which may be due to density peaking, dilution effects and stabilization of the ion temperature gradient mode.
13 January 2023 in Nuclear Fusion
It is necessary to achieve simultaneous exhaust of excessive transient and steady-state heat fluxes on the divertor target for the divertor protection in the future fusion reactors. The sustained large ELM control and stable partial detachment have been achieved concurrently with argon (Ar) or neon (Ne) seeding in EAST. With Ne seeding, the large ELMs with frequency f ELM ∼ 100 Hz disappear and a stable ELM-free state with H 98,y2 > 1 is maintained. Meanwhile, the electron temperature T et around the lower outer strike point decreases from more than 70 eV during the large ELM burst to less than 5 eV in the stable ELM-free phase. In addition, a slight improvement of plasma confinement is observed in the partially detached state, mainly attributed to the increased electron density n e and ion temperature T i in the core region. In the pedestal region, the density gradient and the electron temperature show subtle variation. The effective charge number Z eff increases significantly after Ne seeding, leading to a decrease in the edge bootstrap current and the pedestal pressure gradient, and thus the stabilization of ELMs. With Ar seeding, the large ELMs are also suppressed at first, but soon transit to type-III ELMs with a high f ELM ∼ 1 kHz, highly correlated with the energy confinement degradation. The steady-state and transient heat fluxes on the divertor can be both well reduced with Ar/Ne seeding in EAST.
15 October 2024 in Nuclear Fusion
Divertor detachment operation compatible with the core plasma is an effective method to alleviate the steady-state heat flux approaching the divertor target; this scheme will be adopted by high-performance tokamaks in the future, such as International Thermonuclear Experimental Reactor (ITER). Currently, two ITER-like tungsten divertors with different geometries have been installed at the top and bottom of Experimental Advanced Superconducting Tokamak (EAST), providing conditions for the present study to investigate the effect of divertor geometry on the compatibility between detachment and core plasma. Recent H-mode experiments show that the electron temperature and heat flux of the outer target of the lower divertor decrease lower than those of the upper divertor after similar amounts of impurity are truly injected into the plasma. SOLPS simulations further prove that the closed lower divertor with a ‘corner slot’ structure is beneficial for trapping impurity and deuterium particles, thereby increasing momentum and energy losses. For the upper single-null discharges, the divertor electron temperature can be relatively reduced by increasing impurity seeding, but it is also easy to decrease the plasma stored energy and even lead to an H-L back transition. In addition, statistical data on discharges with impurity seeding show that the proportion of detachment discharges achieved by using the closed divertor is higher than that achieved by using the open divertor. The discharges with the closed divertor after detachment have less damage to the core plasma performance than those with the open divertor, irrespective of whether neon or argon seeding is employed. This research will support long-pulse detachment operation in EAST and provide a reference for other tokamaks in divertor design.
8 June 2021 in Plasma Physics and Controlled Fusion
To investigate the optimal scenario of impurity seeding to obtain divertor plasma detachment for target protection, experiments with Ar&D 2 seeding from two different poloidal locations, the upper outer (UO) divertor target and lower outer (LO) target, were carried out on EAST. Partial energy detachment (the electron temperature near the strike point T e,spt ⩽ 10 eV) were obtained with Ar&D 2 mixture puffing from the UO target and, for the first time, from the LO target into H-mode plasmas in the upper single null (USN) configuration. The peak heat flux q t on the UO target was significantly reduced (by ∼80%). The rollover of ion flux density j s did not appear probably due to insufficient momentum loss, which is independent of the puff locations. The poloidal asymmetries of particle and heat fluxes on the targets have also been investigated. The UO-dominant asymmetry of particle flux was reversed, while the UO-dominant asymmetry of heat flux was mitigated but not reversed. The plasma confinement dropped by only 14% and 8.2% in the LO-puff case and UO-puff case, respectively, during detachment. The high level of C may contributed greatly to the higher radiation in the bulk plasma region and the greater decline in W MHD in the LO-puff case.
26 July 2021 in Plasma Physics and Controlled Fusion
Steady-state heat flux deposition on the first wall of the Chinese Fusion Engineering Testing Reactor (CFETR) is investigated for 1 GW fusion power and under the updated design scheme. The computation is accomplished by the modelling of two simulation systems: SOLPS-ITER and PFCFlux. Seeding neon (Ne) gas is considered to be one of the possible methods of protecting the CFETR divertor from high heat flux damage. Simulations with different Ne seeding rates were carried out on a standard divertor with a lower single-null configuration to determine the effect of Ne seeding on heat flux deposition on the first wall. A blob-based transport model was used to investigate the effect of enhanced cross-field transport on the CFETR first wall, as with ITER and EU DEMO simulations. This work establishes a potential method for simulating the complete heat flux deposition on the first wall for the CFETR steady state by SOLPS-ITER and PFCFlux. After modelling and energy analysis, the peak value of complete heat flux on each module of the CFETR first wall is obtained, which may provide the basic reference for the CFETR physics and engineering design team. The CFETR first wall module which receives the highest heat flux has also been identified, and Ne seeding has a positive effect on reducing the heat flux on the CFETR first wall from around 2.5 MW m −2 to 1 MW m −2 , which is within the engineering requirement.
1 April 2024 in Physics of Plasmas
Radiative divertor is an effective method for the divertor heat flux control, but excessive core impurity radiation can deteriorate the confinement in tokamaks. In recent EAST experiments, the compatibility of divertor detachment and impurity control with good core confinement (H98,y2 ∼1) has been achieved simultaneously by combining an upstream deuterium (D2) puff and divertor argon (Ar) seeding. Both experimental and SOLPS-ITER modeling reveal that additional D2 puff can further mitigate the target heat load and facilitate the detachment. The SOLPS-ITER results also show that the D2 puff makes a limited contribution to the Ar line radiation but a significant contribution to the neutral radiation in the SOL and divertor regions. The physical mechanism behind the effect of the D2 puff on the Ar retention is also revealed by the modeling. The increase in the Ar velocity is the major reason for the improved Ar retention in the partial detachment state. The increase in vAr is mainly caused by the strengthening of frictional drag of D+, which is because the additional D2 puff increases the pressure gradient force (FPG) and the electric field force (FE) on D+. Further analysis reveals that in the deep detachment state, some other negative effects play a dominant role in determining the Ar retention, such as the shift of the region of the Ar+ ionization source, the decrease in the strength of the Ar+ ionization source, and the net force on the Ar ions near the target.