1 September 2020 in Physics of Plasmas
A conventional single null divertor geometry has been proposed for Chinese fusion engineering testing reactor (CFETR) with fusion power up to gigawatt level. Modeling using the SOLPS5.0 code package shows promising results for divertor power exhaust by seeding with neon (Ne) and deuterium (D2). Partial detachment for both inner and outer divertor targets can be achieved with a peak heat load lower than 3 MW/m2. The effective ion charge number, Zeff, at the core boundary is below three, which can be further reduced by increasing the upstream D2 puffing rate. A higher D2 puffing rate helps to increase electron density (ne) in scrape-off layer (SOL) and the impurity screening ability. Based on the SOLPS modeling results, the lifetime of tungsten (W) divertor targets has been estimated by using the DIVIMP code, which indicates that W sputtering is mainly contributed by Ne ions at a far SOL region due to high electron and ion temperature (Te and Ti) there. Upstream D2 puffing can reduce the W erosion rate and W impurity concentration inside the separatrix due to decreasing Te and Ti at the far SOL region. The modeling results show a viable operation regime for the CFETR divertor.
1 August 2017 in Chinese Physics B
To investigate the radiative divertor behavior and physics for the scenario of impurity seeded plasma in ITER, the radiative divertor experiments with argon (Ar) seeding under ITER-like tungsten divertor condition were carried out during recent EAST campaigns. The experimental results reveal the high efficiency of reducing heat load and particle flux onto the divertor targets owing to increased radiation by Ar seeding. We achieve detached plasmas in these experiments. The inner–outer divertor asymmetry reduces after Ar seeding. Impurities, such as Ar, C, Li, and W, exist in the entire space of the vacuum chamber during EAST operations, and play important roles in power exhausting and accelerating the plasma detachment process. It is remarkable that the contamination of the core plasma is observed using Ar seeding owing to the sputtering of plasma facing components (PFCs), particularly when Ar impurity is injected from the upper tungsten divertor.
1 May 2019 in Physics of Plasmas
Both experimental modeling and numerical modeling were carried out on Experimental Advanced Superconductive Tokamak (EAST) to study the radiative divertor plasma behavior with neon (Ne) seeding. Steady H-mode radiation feedback control regimes (frad ∼ 18%–36%) were achieved by synergistic working of a divertor puff and supersonic molecular beam injection with Ne in the 2017 EAST campaign. Ne seeding effectively promoted divertor detachment while only causing a slight loss to the plasma stored energy in the experiment. To better understand the experimental result, analysis of the detachment process is introduced in this work. Two time slices namely before and after Ne seeding during the radiative divertor experiment in Shot #71021 were simulated by Scrape Off Layer Plasma Simulator (SOLPS)-ITER code. The simulation results for upstream plasma agreed well with the experiment, and the divertor profile agreed well on the outer targets when ignoring drifts. Radiation distribution was also calculated by SOLPS-ITER, showing that there was a high radiation region near the X-point, which is consistent with the experimental measurements.
1 June 2020 in Physics of Plasmas
In order to fulfill the requirements for future high-power and long-pulse discharges in the Experimental Advanced Superconducting Tokamak, the present lower graphite divertor will be upgraded with tungsten (W) materials. For one of the new divertor options obtained during the physics design phase, simulations of argon (Ar) seeding are performed by using the SOLPS-ITER code suite. Besides the deuterium and Ar species, all the ionization states of W species generated through physical sputtering have been included in the simulations. As the seeding rate increases, the total power dissipation dominated by Ar radiation increases gradually. Obvious Ar radiation loss in the divertor region is observed. Meanwhile, a high pressure area in the scrape-off layer side of the outer strike point is formed near the corner due to the closed structure. As a result, the outer divertor detaches before the inner divertor, and the maximum Te at the outer target reduces to 5 eV at a puffing rate of 4.0 × 1019 atoms/s. The total heat flux onto the inner and outer target plates, dominated by the charged particles, can be reduced simultaneously. The sputtering rate of W atoms along the divertor plates and the distribution of W impurities in the poloidal cross section are given. The W concentration inside the last closed magnetic flux surface can be controlled to the order of 10−5.
1 November 2022 in Physics of Plasmas
In the EAST radiative divertor experiments, stable detachment and divertor protection have been achieved with mixed impurity gas seeding. Experiments indicate that neon (Ne) is an appropriate external impurity for plasma detachment in EAST. In this work, the physical mechanism of plasma detachment with Ne seeding in EAST is studied by using the SOLPS-ITER code package. The electron temperature Tet on the upper outer divertor target decreases to below 10 eV with Ne seeding, which is mainly due to the power loss and upstream power drop caused by the impurity radiation. For Tet < 10 eV, the significant drop of the poloidal saturation ion current js,p occurs around the upper outer strike point. The simulation results show that the js,p drop is mainly driven by the rise of the momentum loss and the upstream pressure loss. The increase in the momentum loss is mainly caused by the plasma–neutral interactions in the region from the X-point to the upper outer divertor target. The upstream pressure loss around the X-point is related to the decrease in the upstream electron temperature Teu, which originates from the increased radiation loss with Ne seeding.
30 January 2024 in Nuclear Fusion
It is necessary for future fusion reactor to reduce the heat fluxes on the entire divertor target, especially if view of long pulse high performance operation. In recent EAST experiments, partial energy detachment without confinement degradation, and deep energy detachment with protection of the entire divertor target have both been confirmed on EAST corner slot divertor by argon (Ar) seeding, which can provide reference for the divertor protection on future fusion reactors. In the deep energy detachment state, the electron temperature T et along entire lower outer divertor target decreases to less than 10 eV and heat fluxes are also strongly mitigated with peak heat flux reduction of more than 90%. Compared to the attached state, there is a moderate confinement degradation with H 98,y2 from ∼1 to ∼0.9 because of Ar radiation in the core region. This confinement degradation can be avoided in the partial energy detachment state, where the radiative power losses in the core are reduced. The experiment and SOLPS-ITER simulation results show that there is no decrease of particle flux js
on the divertor target in the partial energy detachment state because the momentum loss in the SOL region is not strong enough. With increasing Ar seeding, there is a js
decrease in the deep energy detachment state. The increases of momentum and power losses in the SOL region, and the decrease of upstream pressure all contribute to the js
reduction.